2019 INFINITI Towing Guide
7
BREAKAWAY SWITCH
On a trailer with electric brakes, a breakaway switch can automatically activate the trailer
brake system if the trailer becomes separated from the tow vehicle. Should the trailer
become detached, a breakaway switch may help prevent the trailer from wandering into
another lane.
WARNING- A breakaway switch relies on the power of a trailer battery, so make
sure it is not discharged. Never use the breakaway switch to “park” the trailer on a grade.
The battery would eventually discharge and release the brake, allowing the trailer to roll.
Be sure to leave enough slack in the tether on the breakaway switch to turn corners
without binding. If you do not, the electric trailer brakes will lock-up and not release. See
your trailer manufacturer for proper installation of a breakaway switch that is compatible
with your trailer braking system.
TRAILER LIGHTS
Trailer lights should comply with all applicable federal, state, and local regulations, and
should be in proper working order at all times. If your vehicle is equipped with a towing
package, a 7-pin trailer harness connector is located at the trailer hitch, under a cover on
the rear bumper on some models for connecting trailer lights. For trailers that use a
different style plug, contact your INFINITI retailer or a professional supplier of towing
equipment for adaptors to the 7-pin trailer harness.
A trailer’s taillights, stoplights, and turn signal lights must be wired into the towing vehicle’s
electrical system.* Most trailers operate on a four-wire system in which the stoplights and
turn signal lights utilize the same wire. Most all INFINITI vehicles have separate wires for
the stoplights and turn signal lights, therefore a device called a “converter” is needed.**
Specifically, a “powered converter” must be used, as a converter of this type creates only
minimal additional electrical demand (draw) on the vehicle lighting circuits, which helps to
ensure protection for the vehicle’s sensitive electronics.* Always check for correct operation
of the taillights, stoplights, and turn signal lights every time you connect a trailer for
towing. Never replace vehicle fuses with fuses of a higher amperage rating than the
original.
*Vehicles equipped with LED taillights require that wiring be connected at a specific location. For
assistance in
hooking up trailer lights, contact your INFINITI retailer or a professional supplier of
towing equipment.
**QX80 and QX60 vehicles are pre-wired for trailer lighting and do not require a converter.
CAUTION – Improperly installed or poor quality trailer harness wiring may adversely
affect your vehicle’s electrical system. Use only an INFINITI approved wiring harness,
or consult your retailer or a professional supplier of towing equipment for compatible
equipment.
