2019 HYUNDAI I10 light

5-21
05
Tilt steering / Telescope
steering
WARNING
Never adjust the steering wheel
whilst driving. You may lose steer-
ing control and cause severe per-
sonal injury, death or accidents.
i Information
After adjustment, sometimes the lock-
release lever may not lock the steering
wheel.
It is not a malfunction. 7his occurs
when two gears are not engaged cor-
rectly. In this case, adjust the steering
wheel again and then lock the steering
wheel.
OAC3059009R
To change the steering wheel angle
and height:
1. Pull down the lock-release lever
(1).
$GMXVW WKH VWHHULQJ ZKHHO WR WKH
desired angle (2) and height (3, if
equipped). Move the steering
wheel, so it points toward your
chest, not toward your face. Make
sure you can see the instrument
panel warning lights and gauges.
3. Pull up the lock-release lever to
lock the steering wheel in place.
Push the steering wheel both up and
down to be certain it is locked in posi-
tion.
CAUTION
Whilst adjusting the steering wheel
height, please do not push or pull
it hard since the fixture can be
damaged.

5-23
05
Inside rearview mirror
%HIRUH \RX VWDUW GULYLQJ DGMXVW WKH
rearview mirror to the centre on the
view through the rear window.
WARNING
Make sure your line of sight is not
obstructed. Do not place objects in
the rear seat, cargo area, or behind
the rear head restraints which
could interfere with your vision
through the rear window.
WARNING
To prevent serious injury during
an accident or deployment of the
air bag, do not modify the rearview
mirror and do not install a wide
mirror.
WARNING
NEVER adjust the mirror whilst
driving. This may cause loss of
vehicle control resulting in an acci-
dent.
NOTICE
When cleaning the mirror, use a
paper towel or similar material
dampened with glass cleaner. Do
not spray glass cleaner directly on
the mirror as that may cause the
liquid cleaner to enter the mirror
housing.
Day/night rearview mirror
(if equipped)
OAH2048020
[A] : Day, [B] : Night
0DNHWKLVDGMXVWPHQWEHIRUH\RXVWDUW
GULYLQJ DQG ZKLOVW WKH GD\QLJKW OHYHU
is in the day position.
3XOO WKH GD\QLJKW OHYHU WRZDUGV \RX
to reduce glare from the headlights
of the vehicles behind you during
night driving.
Remember that you lose some rear-
view clarity in the night position.
MIRRORS

5-30
Convenient features
Bonnet
Opening the bonnet
OAC3059017R
1. Make sure the shift lever is in N
(Neutral, for Automated manual
transmission) or first gear or R
(Reverse, for Manual transmis-
sion) and set the parking brake.
2. Pull the release lever to unlatch the
bonnet. The bonnet should pop up
slightly.
OAC3059018TU
3. Go to the front of the vehicle, raise
the bonnet slightly, push the sec-
ondary latch up (1) inside of the
bonnet centre and lift the bonnet
(2).
OAC3059019TU
4. Pull out the stay-rod from the bon-
net.
5. Hold the bonnet opened with the
stay rod.
Closing the bonnet
1. Before closing the bonnet, check
the following:


5-33
05
WARNING
OAC3059062TU
Do not hold the part (gas lifter) that
supports the tailgate. Be aware
that the deformation of the part
may cause vehicle damage and a
risk of safety accident.
)XHOILOOHUGRRU
Opening the fuel filler door
OAC3059021R
The fuel filler door must be opened
from inside the vehicle by pulling up
the fuel filler door opener.
1. Stop the engine.
2. Pull the fuel filler door opener up.
OAC3059053TU
3. Pull the fuel filler door out (1) to
fully open.
4. To remove the fuel tank cap (2),
turn it counterclockwise. You may
hear a hissing noise as the pres-
sure inside the tank equalizes.
5. Place the cap on the fuel filler door
(3).
i Information
If the fuel filler door does not open
because ice has formed around it, tap
lightly or push on the door to break the
ice and release the door. 'o not pry on
the door. If necessary, spray around
the door with an approved de-icer fluid
(do not use radiator anti-free]e) or
move the vehicle to a warm place and
allow the ice to melt.

5-36
Convenient features
Exterior lights
Lighting control
OAC3059022TU
To operate the lights, turn the knob at
the end of the control lever to one of
the following positions:
(1) OFF (O) position
(2) AUTO light position (if equipped)
(3) Position light position
(4) Headlight position
OAC3059024TU
A872 light position (if equipped)
When the light switch is in the AUTO
position, the position light and head-
light will be turned ON or OFF auto-
matically depending on the amount of
light outside the vehicle.
Even with the AUTO light feature in
operation, it is recommended to man-
ually turn ON the lights when driving
at night or in a fog, or when you enter
dark areas, such as tunnels and park-
ing facilities.
NOTICE

5-37
05
OHCR046344
Position light position ()
The position light, license plate light
and instrument panel light are turned
ON.
OHCR046345
+eadlight position ()
The headlight, position light, license
plate light and instrument panel light
are turned ON.
i Information
7he ignition switch must be in the 21
position to turn on the headlight.
High beam operation
OHCR046346
To turn on the high beam headlight,
push the lever away from you.
The high beam indicator will light
when the headlight high beams are
switched on.
To turn off the high beam headlight,
pull the lever towards you. The low
beams will turn on.
WARNING
Do not use high beam when there
are other vehicles approaching
you. Using high beam could
obstruct the other driver’s vision.
OHCR046349
To flash the high beam headlight, pull
the lever towards you, then release
the lever. The high beams will remain
ON as long as you hold the lever
towards you.

5-38
Convenient features
High Beam Assist system
(if equipped)
OAC3059025TU
High Beam Assist is a system that
DXWRPDWLFDOO\ DGMXVWV WKH KHDGOLJKW
range (switches between high beam
and low beam) according to the
brightness of other vehicles and road
conditions.
System setting
The driver can activate the HBA by
placing the ignition switch to the ON
position and by selecting: ‘User
Settings  Lights  HBA (High Beam
$VVLVW

5-39
05
OAC3069028TU
Warning light and message
When the High Beam Assist (HBA) is
not working properly, the warning
message will come on for a few sec-
ond. After the message disappears,
the master warning light (
) will illu-
minate.
We recommend that you take your
vehicle to a HYUNDAI authorised
repairer and have the system
checked.
CAUTION
The system may not operate nor-
mally if any of the following condi-
tions should occur:
1) When the illumination from an
on-coming vehicle or a vehicle
in front is dim. Such examples
may include: