Page 143 of 631

Continued141
uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
Controls
To temporarily deactivate the function:
1. Set the power mode to OFF.
2. Open the driv er’s door.
3. Using the master door lock switch, operate 
the lock as follows:
Lock Unlock Lock Unlock.
u The beeper sounds and the function is 
deactivated.
To restore the function:
• Set the power mode to ON.
• Lock the vehicle withou t using the auto lock 
function
• With the smart entry remote on you, move 
out of the auto lock function operation 
range.
• Open any door.1Locking the doors and tailg ate (Walk away auto lock®)
The auto lock function does  not operate when any of 
the following conditions are met.
•The smart entry remote is inside the vehicle.
•A door, tailgate or the  bonnet is not closed.•The power mode is set to any mode other than OFF.
•The smart entry remote is not located within a 
radius of about 5 feet (1 .5 m) from the vehicle 
when you get out of the vehicle and close the 
doors and tailgate.
Auto lock function operation stop beeper
After the auto lock function has been activated, the 
auto lock operation stop beeper sounds for 
approximately two seconds  in the following cases.
•The smart entry remote is put inside the vehicle 
through a window.
•You are located too close to the vehicle.
•The smart entry remote is put inside the tailgate.
If the warning beeper sounds, check that you are 
carrying the smart entry remote. Then, open/close a 
door and confirm the auto  lock activation beeper 
sounds once.
19 HR-V HDMC HDMG-31T7A6300.book  141 ページ  2018年6月1日 金曜日 午後1時14分 
         
        
        
     
        
        Page 151 of 631
149
uuLocking and Unlocking the Doors uChildproof Door Locks
Controls
Childproof Door Locks
The childproof door locks prevent the rear  doors from being opened from the inside 
regardless of the position of the lock tab.
Slide the lever in the rear door to the lock 
position, and close the door.
■When opening the door
Open the door using the outside door handle.
■Setting the Childproof Door Locks1 Childproof Door Locks
To open the door from the inside when the 
childproof door lock is on, put the lock tab in the 
unlock position, lower the  rear window, put your 
hand out of the window, and pull the outside door 
handle.
Lock
Unlock
19 HR-V HDMC HDMG-31T7A6300.book  149 ページ  2018年6月1日 金曜日 午後1時14分 
         
        
        
     
        
        Page 160 of 631

uuSecurity System uSecurity System Alarm
158
Controls
■To deactivate the security system alarm
Unlock the vehicle using the remote  transmitter or smart entry remote*, or turn the 
ignition switch to ON 
(w*1. The system, along with the  horn and flashing lights, is 
deactivated.
■Setting the security system alarm
The security system alarm  automatically sets when the following conditions have 
been met:
• The ignition switch is in LOCK 
(0*1, and the key has been removed from the 
ignition switch.
• The hood is closed.
• All doors and the tailgate are locked  from outside with the key, remote 
transmitter, or smart entry system
*.
■When the security system alarm sets
The security system alarm indicator in  the instrument panel blinks. When the 
blinking interval changes after about 15  seconds, the security system alarm is set.
■To cancel the security system alarm
The security system alarm is canceled when  the vehicle is unlocked using the remote 
transmitter or smart entry system
*, or the ignition swit ch is turned to ON (w*1. The 
security system alarm indicator goes off at the same time.
*1: Models with the smart entry system have an  ENGINE START/STOP button instead of an 
ignition switch.
1 Security System Alarm
Do not set the security system alarm when someone 
is in the vehicle or a window  is open. The system can 
accidentally activate when:
•Unlocking the door with the lock tab.•Opening the hood with the hood release handle.
•Moving the shift lever out of ( P.
If the battery goes dead after you have set the 
security system alarm, the security alarm may activate 
once the battery is re charged or replaced.
If this occurs, deactivate the security system alarm by 
unlocking a door using the ke y, remote transmitter, 
or smart entry system
*.
Do not alter the system or  add other devices to it.
Doing so may damage the system and make your 
vehicle inoperable.
* Not available on all models
19 HR-V HDMC HDMG-31T7A6300.book  158 ページ  2018年6月1日 金曜日 午後1時14分 
         
        
        
     
        
        Page 162 of 631

160
Controls
Opening and Closing the Windows
Opening/Closing the Power Windows
The power windows can be opened and closed when the ignition switch is in ON 
(w*1, using the switches on the doors. The driver’s side switches can be used to 
open and close all of the windows.
The power window lock button on the driver’s side must be switched off (not 
pushed in, indicator off) to open and close the windows from anywhere other than 
the driver’s seat.
When the power window lock button is pu shed in, the indicator comes on and you 
can only operate the driver’s window. Turn the power window lock button on if a 
child is in the vehicle.
■Automatic operation
To open:  Push the switch down firmly.
To close:  Pull the switch up firmly.
The window opens or cl oses completely. To 
stop the window at any time, push or pull the 
switch briefly.
■Manual operation
To open:  Push the switch  down lightly, and 
hold it until the desired position is reached.
To close:  Pull the switch up lightly, and hold it 
until the desired position is reached.
*1: 
Models with the smart entry system have an  ENGINE START/STOP button instead of an 
ignition switch.
■Opening/Closing Windows with Auto-Open/Close Function
1 Opening/Closing the Power Windows
The power windows can be  operated for up to 10 
minutes after you turn the ignition switch to LOCK 
( 0*1. Opening either front door  cancels this function.
Auto Reverse
If a power window senses  resistance when closing 
automatically, it will  stop closing and reverse 
direction.
The driver’s window auto re verse function is disabled 
when you continuously pull up the switch.
The auto reverse function  stops sensing when the 
window is almost closed to en sure that it fully closes.
3WARNING
Closing a power window on someone’s 
hands or fingers can cause serious injury.
Make sure your passengers are away from 
the windows before closing them.
Power Window Lock Button
Driver’s 
Window 
Switch
OffOn
Indicator
19 HR-V HDMC HDMG-31T7A6300.book  160 ページ  2018年6月1日 金曜日 午後1時14分 
         
        
        
     
        
        Page 163 of 631
161
uuOpening and Closing the Windows uOpening/Closing the Power Windows
Controls
To open:  Push the switch down.
To close:  Pull the switch up.
Release the switch when the window reaches 
the desired position.
■Opening/Closing Windows without Auto-Open/Close 
Function
Close
Open
19 HR-V HDMC HDMG-31T7A6300.book  161 ページ  2018年6月1日 金曜日 午後1時14分 
         
        
        
     
        
        Page 166 of 631

164
uuOperating the Switches Around the Steering Wheel uENGINE START/STOP Button
Controls
ENGINE START/STOP Button
*1: Canadian models
*2: U.S. models
■Changing the Power Mode
Models with smart entry system
1ENGINE START/STOP Button
ENGINE START/STOP Button Operating Range
You can start the engine when the smart entry 
remote is inside the vehicle.
If the battery of the smar t entry remote is getting 
low, the engine may not start when you press the 
ENGINE START/STOP  button. If the engine does not 
start, refer to the following link. 2 If the Smart Entry Remote Battery is Weak  
P. 586
The engine may also run if the smart entry remote is 
close to the door or window, ev en if it is outside the 
vehicle.
ON mode:
The  ENGINE START/STOP  button is on (in red), if the 
engine is running.
Do not leave the power mode in ACCESSORY or ON 
when you get out.
Operating Range
Continuously Variable Transmission
VEHICLE OFF (LOCK)
The button is off.
The steering wheel is locked
*1. 
The power to all electrical 
components is turned off.
Press the button without the 
transmission in 
( P.
Press the button with the 
transmission in 
( P. Press the button.
Without pressing 
the brake pedal ACCESSORY
The button blinks (in red).
Operate the audio system and 
other accessories in this position.
ON
The button blinks (in red).
All electrical components can be 
used.
Put the transmission into (P*2.
*2
19 HR-V HDMC HDMG-31T7A6300.book  164 ページ  2018年6月1日 金曜日 午後1時14分 
         
        
        
     
        
        Page 168 of 631

uuOperating the Switches Around the Steering Wheel uENGINE START/STOP Button
166
Controls
If you open the driver’s door when th e power mode is in ACCESSORY, a warning 
buzzer sounds.
Warning buzzers may sound from inside and/
or outside the vehicle to remind you that the 
smart entry remote is out of the vehicle. If the 
buzzer continues even after the remote is put 
back inside, place it to be within its 
operational range.
■When the power mode is in ON
If the smart entry remote is taken out of the 
vehicle, and the driver’s door is closed, a 
warning buzzer sounds from both inside and 
outside the vehicle. A warning message on 
the multi-information display notifies the 
driver inside that the remote outside of the 
vehicle.
■When the power mode is in 
ACCESSORY
If the smart entry remote is taken out of the 
vehicle, and all the doors are closed, a 
warning buzzer sounds from outside the 
vehicle.
■Power Mode Reminder
■Smart Entry Remote Reminder
1 Smart Entry Remote Reminder
When the smart entry remote is within the system’s 
operational range, and the driv er’s door is closed, the 
warning function cancels.
If the smart entry remote is taken out of the vehicle 
after the engine has been started, you can no longer 
change the  ENGINE START/STOP  button mode or 
restart the engine. Always make sure if the remote is 
in your vehicle when you operate the  ENGINE 
START/STOP  button.
Removing the smart entry remote from the vehicle 
through a window does not  activate the warning 
buzzer.
Do not put the smart entr y remote on the dashboard 
or in the glove box. It may cause the warning buzzer 
to activate. Under some  other conditions that can 
prevent the vehicle from locating the remote, the 
warning buzzer may also activate even if the remote 
is within the system’s operational range.
19 HR-V HDMC HDMG-31T7A6300.book  166 ページ  2018年6月1日 金曜日 午後1時14分 
         
        
        
     
        
        Page 184 of 631

182
uuOperating the Switches Around the Steering Wheel uDefogger/Heated Door Mirror*/Heated Windshield*
Controls
Defogger/Heated Door Mirror*/Heated Windshield*
Press the rear defogger button or touch the 
icon to defog the rear window and mirrors 
when the ignition switch is in ON 
(w*1.
The rear defogger and heated door mirrors 
automatically switch off after 10-30 minutes 
depending on the outside temperature.
However, if the outside temperature is 32°F 
(0°C) or below, they do not automatically 
switch off.
*1: Models with the smart entry system have an  ENGINE START/STOP button instead of an 
ignition switch.
■Rear Defogger/Heated Door Mirror* Button1 Rear Defogger/Heated Door Mirror* Button
This system consumes a lot of power, so turn it off 
when the window has been defogged.
Also, do not use the system  for a long time while the 
engine is idling. This may  weaken the battery, making 
it difficult to  start the engine.
Models with heating and cooling system
Models with climate control system
Models with climate control system
* Not available on all models
19 HR-V HDMC HDMG-31T7A6300.book  182 ページ  2018年6月1日 金曜日 午後1時14分