Page 422 of 591

uu When Driving u Lane Keeping Assist System (LKAS)
420
Driving The system can be used when the following conditions are met.
• The lane in which you are driving has dete ctable lane markers on both sides, and
your vehicle is in the center of the lane.
• The vehicle speed is between 45 and 90 mph (72 and 145 km/h).
• You are driving on a straight or slightly curved road.
• The turn signals are off.
• The brake pedal is not depressed.
• The wipers are not in continuous operation.
■ How to activate the system
1. Press the MAIN button.
u The LKAS (green) is on in the driver
information interface.
The system is ready to use.
2. Press the LKAS button.
u Lane outlines appear on the driver
information interface.
The system is activated.■ When the System can be Used 1 When the System can be Used
If the vehicle drifts toward ei th e r l ef t o r r i ght lane line
due to the system applying torque, turn off the LKAS
and have your vehicle checked by an authorized
Honda Clarity Plug-In Hybrid dealer.
MAIN Button
LKAS Button19 CLARITY PHEV-31TRW6100.book 420 ページ 2018年10月25日 木曜日 午後2時29分
Page 424 of 591

422 uu When Driving u Lane Keeping Assist System (LKAS)
Driving ■ The system operation is suspended if
you:
• Set the wipers to HI .
u Set the wiper switch to other than HI
resumes the LKAS.
• Decrease the vehicle speed to about 40
mph (64 km/h) or less.
u Increasing the vehicle speed to about 45
mph (72 km/h) or more resumes the
LKAS.
• Depress the brake pedal.
u The LKAS resumes and starts detecting
the lane lines again once you release the
brake pedal.
■ The LKAS may automatically be suspended when:
• The system fails to detect lane lines.
• The steering wheel is quickly turned.
• You fail to steer the vehicle.
• Driving through a sharp curve.
• Driving at a speed in excess of approximately 90 mph (145 km/h).
Once these conditions no longer exis t, the LKAS automatically resumes.When the LKAS is suspended,
the lane lines on the driver
information interface change to
contour lines, and the beeper
sounds (if activated).19 CLARITY PHEV-31TRW6100.book 422 ページ 2018年10月25日 木曜日 午後2時29分
Page 485 of 591

483uu Maintenance Under the Hood u Opening the Hood
Maintenance
Opening the Hood 1. Park the vehicle on a level surface, and set
the parking brake.
2. Pull the hood release handle under the
driver’s side lower corner of the dashboard.
u The hood will pop up slightly.
3. Push the hood latch lever (located under
the front edge of the hood to the center) to
the side and raise the hood. Once you have
raised the hood slightly , you can release the
lever.
4. Remove the support rod from the clamp
using the grip. Mount the support rod in
the hood.
When closing, remove the support rod, and
stow it in the clamp, then gently lower the
hood. Remove your hand at a height of
approximately 12 inches (30 cm) and let the
hood close. 1 Opening the Hood NOTICE
Do not open the hood when the wiper arms are
raised: The hood will strike the wipers, resulting in
possible damage to the hood and/or the wipers. NOTICE
Do not press the engine cover forcibly. This may
damage the engine cover and component parts.
When closing the hood, check that the hood is
securely latched.
If the hood latch lever moves stiffly, or if you can
open the hood without lifti ng the lever, the latch
mechanism should be cl eaned and lubricated.PullHood Release Handle
Lever
Support Rod
Grip
Clamp19 CLARITY PHEV-31TRW6100.book 483 ページ 2018年10月25日 木曜日 午後2時29分
Page 500 of 591
498
Maintenance Checking and Mainta ining Wiper BladesChecking Wiper Blades If the wiper blade rubber has deteriorated, it will leave streaks and the hard surfaces
of the blade may scratch the window glass.
Changing the Wiper Blade Rubber 1. Set the power mode to VEHICLE OFF
(LOCK).
2. While holding the wiper switch in the
MIST position, set the power mode to ON,
then to VEHICLE OFF (LOCK).
u Both wiper arms are set to the
maintenance position as shown in the
image.
3. Lift both wiper arms. 1 Changing the Wiper Blade Rubber NOTICE
Avoid dropping the wiper arm onto the windshield, it
may damage the wiper arm and/or the windshield.
When you raise a wiper arm, you may inadvertently
alter the position of the arm by applying undue force.
If you notice that an arm is not in its proper return
position, active the wipers once and they will
automatically reset.
2 Wipers and Washers P. 16619 CLARITY PHEV-31TRW6100.book 498 ページ 2018年10月25日 木曜日 午後2時29分
Page 520 of 591

uu Cleaning u Exterior Care
518
Maintenance • Keep sufficient distance between the cleaning nozzl e and the vehicle body.
• Take particular care around the windows. Standing too close may cause water to
enter the vehicle interior.
• Do not spray water into the engine compartment.
A good coat of automotive body wax helps protect your vehicle’s paint from the
elements. Wax will wear off over time and expose your vehicle’s paint to the
elements, so reapply as necessary.
If you get gasoline, oil, coolant, or batter y fluid on resin coated parts, they may be
stained or the coating may peel. Promptly wipe it away using a soft cloth and clean
water.
Wipe using a glass cleaner.■ Using High Pressure Cleaners
■ Applying Wax
■ Maintaining the Bumpers and Other Resin Coated Parts
■ Cleaning the Window 1 Applying Wax NOTICE
Chemical solvents and st rong cleaners can damage
the paint, metal, and plasti c on your vehicle. Wipe
away spills immediately.
1 Maintaining the Bumpers an d Other Resin Coated Parts
Ask an authorized Honda Clarity Plug- In Hybrid
dealer about the correct coating material when you
want to repair the painted surface of the parts made
of resin.
1 Cleaning the Window
When you raise a wiper arm, you may inadvertently
alter the position of the arm by applying undue force.
If you notice that an arm is not in its proper return
position, active the wipers once and they will
automatically reset.
2 Wipers and Washers P. 16619 CLARITY PHEV-31TRW6100.book 518 ページ 2018年10月25日 木曜日 午後2時29分
Page 590 of 591

588
Index W Wallpaper .................................................. 223
Warning and Information Messages ....... 103
Warning Indicator On/Blinking ................ 547
Warning Labels ........................................... 83
Warranties (Warranty Manual provided
separately) ............................................... 574
Watts ......................................................... 568
Wear Indicators (Tire) ............................... 506
Wi-Fi Connection ...................................... 274
Window Washers ...................................... 166
Adding/Refilling Fluid ............................... 495
Switch ..................................................... 166
Windows (Opening and Closing) ............. 156
Windshield
Cleaning .......................................... 516, 518
Defrosting/Defogging .............................. 197
Washer Fluid............................................ 495
Wiper Blades ........................................... 498
Wipers and Washers ................................ 166
Winter Tires
Snow Tires ............................................... 509
Tire Chains .............................................. 509
Wipers and Washers ................................. 166
Checking and Replacing Wiper Blades ..... 498
WMA ......................................................... 264
Worn Tires ................................................. 50119 CLARITY PHEV-31TRW6100.book 588 ページ 2018年10月25日 木曜日 午後2時29分