2019 HONDA CIVIC SEDAN lock

uuIf a Tire Goes Flat uChanging a Flat Tire*
610
Handling the Unexpected
1. Open the trunk floor lid.
2. Take the tool case out of the trunk. Take
the jack and wheel nut wrench out of the
tool case.
3. Unscrew the wing bolt, and remove the
spacer cone. Then, remove the spare tire.
4. Place a wheel block or ro ck in front and rear
of the wheel diagonal to the flat tire.
■Getting Ready to Replace the Flat Tire1 Getting Ready to Replace the Flat Tire
NOTICE
Do not mount the compact spare on the front. If
mounted on the front, the compact spare, smaller in
size than the full-size tire, may damage the
differential.
If either front tire goes flat, remove the rear tire on
the same side, and mount the compact spare on the
rear and the rear tire on the front.
The shape of the tool case varies by model.
Models with SPORT mode
Tool Case
Spare Tire
Wheel
Blocks
The tire to be replaced.
19 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6301.book 610 ページ ２０１８年１０月２６日　金曜日　午前７時４２分

616
uuIf a Tire Goes Flat uTemporarily Repairing a Flat Tire*
Handling the Unexpected
Temporarily Repairing a Flat Tire*
If the tire has a large cut or is otherwise se verely damaged, you will need to have the
vehicle towed. If the tire only has a smal l puncture, from a nail for instance, you can
use the temporary tire repair kit so that you can drive to the nearest service station
for a more permanent repair.
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually
to reduce speed. Then stop in a safe place.
1. Park the vehicle on a firm, level, and non-slippery surface and apply the parking
brake.
2. Move the shift lever to
(R.
3. Turn on the hazard warning lights an d set the power mode to VEHICLE OFF
(LOCK).
1 Temporarily Repairing a Flat Tire*
The kit should not be used in the following situations.
Instead, contact a dealer or a roadside assistant to
have the vehicle towed.
•The tire sealant has expired.•More than one tire is punctured.•The puncture or cut is larger than 3/16 inch (4.8
mm).
•The tire side wall is da maged or the puncture is
outside the contact area.
•Damage has been caused by driving with the tire
extremely under inflated.
•The tire bead is no longer seated.•The rim is damaged.
Do not remove a nail or screw that punctured the
tire. If you remove it from the tire, you may not be
able to repair the puncture using the kit.
When the puncture is:Kit Use
Smaller than 3/16 inch
(4.8 mm)Yes
Larger than 3/16 inch
(4.8 mm)No
Contact
Area
* Not available on all models
19 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6301.book 616 ページ ２０１８年１０月２６日　金曜日　午前７時４２分

630
uuEngine Does Not Start uEmergency Engine Stop
Handling the Unexpected
Emergency Engine Stop
The ENGINE START/STOP button may be used to st op the engine due to an
emergency situation even while driving. If you must stop the engine, do either of the
following operations:
• Press and hold the ENGINE START/STOP button for about two seconds.
• Firmly press the ENGINE START/STOP button three times.
The steering wheel will not lock. However, because turning off the engine disables
the power assist the engine provides to the steering and braking systems, it will
require significantly more physical effort an d time to steer and slow the vehicle. Use
both feet on the brake pedal to slow down the vehicle and stop immediately in a
safe place. With manual transmission models you can also downshift the
transmission to utilize engine braking.
The power mode is in ACCESSORY when the engine is stopped.
To change the mode to VEHICLE OFF, move the shift lever to
(P after the vehicle
comes to a complete stop.
Then press the ENGINE START/STOP button twice without depressing the brake
pedal.
The power mode changes to VEHICLE OFF.
Models with smart entry system
1 Emergency Engine Stop
Do not press the ENGINE START/STOP button while
driving unless it is absolute ly necessary for the engine
to be turned off.
If you press the ENGINE START/STOP button while
driving, the beeper sounds.
Continuously variable transmission models
Canadian continuously variable transmission models
Manual transmission models
19 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6301.book 630 ページ ２０１８年１０月２６日　金曜日　午前７時４２分

634
Handling the Unexpected
Shift Lever Does Not Move
Follow the procedure below if you cannot move the shift lever out of the (P
position.
1.Set the parking brake.
2. Remove the key from the ignition switch.
2. Remove the built-in key from the smart
entry remote.
3. Move the removable beverage holder tray
rearward.
2 Front seat beverage holders P. 192
4.Wrap a cloth around the tip of a small flat-
tip screwdriver to remove the cover of the
shift lock release slot. Put the tip of the flat-
tip screwdriver into th e slot and remove it
as shown in the image.
5. Insert the key into the sh ift lock release slot.
6. While pushing the key in, press the shift
lever release button and place the shift lever
into
(N.
u The lock is now released. Have the shift
lever checked by a dealer as soon as
possible.
■Releasing the Lock
Continuously variable transmission models
Slot
Cover
Models without smart entry system
Models with smart entry system
All models
Release
Button
Shift Lock
Release Slot
19 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6301.book 634 ページ ２０１８年１０月２６日　金曜日　午前７時４２分

643Continued
Handling the Unexpected
Fuses
Fuse Locations
If any electrical devices are not working,
turn the ignition switch to LOCK
(0*1 and
check to see if any appl icable fuse is blown.
Located near the battery. Push the tabs to
open the box.
Fuse locations are shown on the fuse box
cover. Locate the fuse in question by the
fuse number and box cover number.
■Engine Compartment Fuse Box
■Circuit protected and fuse rating
Circuit ProtectedAmps
1
Passenger’s Power Seat*/
Rear Seat Heaters*, *2, *8(60 A)
Adaptive Damper System/ Rear Seat Heaters*, *3, *860 A
Option Block 1*9(60 A)
Cooling Fan*4, *8(30 A)DCDC 1*, *9
Cooling Fan*5(50 A)*8
50 A*9
−*8−
Premium Amp*, *9(30 A)
IG Main*6, *8
IG Main 2*6, *930 A
(30 A)
−*7−
Headlight High Beam Main30 A
Battery125 A
2
EPS70 A
IG Main*8
IG Main 1*930 A*6
50 A*7
Fuse Box Option*(40 A)
Fuse Box*8
Fuse Box 1*960 A
Front Wiper Motor30 A
Headlight Low Beam Main 30 A
*1:Models with the smart entry system have an ENGINE START/STOP button
instead of an ignition switch.
*2:Models without SPORT mode
*3:Models with SPORT mode
*4:2.0L engine models
*5:1.5L engine models
*6:Models with smart entry system
*7:Models without smart entry system
*8:Models without detachable towing hook
*9:Models with detachable towing hook
3
Rear Defroster40 A
Starter Motor*630 A*8
(30 A)*9
−*7−
Fuse Box*8
Fuse Box 2*940 A
ABS/VSA Motor40 A
ABS/VSA FSR40 A
Blower Motor40 A
4 −*8−
PTC 4*, *9(40 A)
−*8−
PTC 3*, *9(40 A)
−*8−
PTC 2*, *9(40 A)
−*8−
PTC 1*, *9(40 A)
Circuit ProtectedAmps
* Not available on all models
19 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6301.book 643 ページ ２０１８年１０月２６日　金曜日　午前７時４２分

645
uuFuses uFuse Locations
Continued
Handling the Unexpected
Located under the dashboard.
Fuse locations are shown on the label on
the side panel.
Locate the fuse in question by the fuse
number and label number.
■Interior Fuse Box
Fuse Label
■Circuit protected and fuse rating
Circuit ProtectedAmps
1Accessory10 A
2−*1
Key Lock*2, *3−
(5 A)
3−*4−
Rear Wiper*, *5(10 A)
4 Front Sensor Camera*1
Transmission*2, *3(5 A)
(10 A)
5Option10 A*4
(10 A)*5
6 SRS Indicator 10 A*4
(10 A)*5
7Meter10 A
8 Fuel Pump 15 A
9AIRCON10 A
10 −*4−
Rear Accessory Socket*5(20 A)
11Engine Control5A
12 Passenger Side Door Lock 10 A
13Driver Side Rear Door Unlock*4(10 A)
Driver’s Side Door Unlock*510 A
14 Rear Driver’s Side Power
Window (20 A)
15Front Passenger’s Power
Window20 A
16 Door Lock 20 A
*1:Models with smart entry system
*2:Models without smart entry system
*3:
Continuously variable transmission models
*4:Models without detachable towing hook
*5:Models with detachable towing hook
17Transmission*1, *3
Front Sensor Camera*2(10 A)
(5 A)
18 −
*4−
Driver’s Power Seat Lumbar Support
*5(10 A)
19Moonroof*(20 A)
20 −*4−
Starter*5(10 A)
21ACG10 A
22 Daytime Running Lights 10 A*4
(10 A)*5
23−*4−
Rear Fog Light*, *5(10 A)
24 Front Sensor Camera*(5 A)
25Driver’s Door Lock10 A*4
(10 A)*5
26Passenger Side Door Unlock10 A
27Rear Passenger’s Side Power Window(20 A)
28 Driver’s Power Window 20 A
29Front Accessory Power Socket20 A
Circuit ProtectedAmps
* Not available on all models
19 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6301.book 645 ページ ２０１８年１０月２６日　金曜日　午前７時４２分

646
uuFuses uFuse Locations
Handling the Unexpected
*1:Models with smart entry system
*2:Models without smart entry system
*4:Models without detachable towing hook
*5:Models with detachable towing hook
Circuit ProtectedAmps
30 Smart Entry
*110 A*4
(10 A)*5
−*2−
31Driver’s Power Seat Reclining*(20 A)
32 Front Seat Heater*(20 A)
33Driver’s Power Seat Sliding*(20 A)
34 VSA/ABS 10 A
35SRS10 A
36 − −
37−*4−
Option*5(10 A)
38 Driver Side Rear Door Lock*4(10 A)
Driver’s Side Door Lock*510 A
39Driver’s Door Unlock10 A*4
(10 A)*5
* Not available on all models
19 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6301.book 646 ページ ２０１８年１０月２６日　金曜日　午前７時４２分

647
uuFuses uInspecting and Changing Fuses
Handling the Unexpected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK (0*1. Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fu ses in the engine
compartment and the vehicle interior.
u If there is a blown fuse, remove it with
the fuse puller and replace it with a new
one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Inspecting and Changing Fuses
NOTICE
Replacing a fuse with on e that has a higher rating
greatly increases the chances of damaging the
electrical system.
There is a fuse puller on the back of the engine
compartment fuse box cover.
Combined
Fuse Blown Fuse
Fuse Puller
19 CIVIC 4D HCM_HMIN_J (KA KL KC)-31TBA6301.book 647 ページ ２０１８年１０月２６日　金曜日　午前７時４２分