2019 HONDA ACCORD HYBRID steering wheel adjustment

5
Quick Reference Guide
❙ Headlights/Turn Signals (P 193)
❙ Fog Lights *
(P 195)
❙ LaneWatch TM *
(P 505)Canadian models
❙ Paddle Shifter (Shift down) *
(P 481)
❙ Left Selector Wheel (P 139)
❙ (home) Button (P 139)
❙ MAIN Button (P 536)
❙ Adaptive Cruise Control (ACC) with Low
Speed Follow (LSF) Buttons *
(P 528)
❙ Adaptive Cruise Control (ACC) Buttons *
(P 537)
❙ Wipers/Washers (P 200)
❙ Paddle Shifter (Shift up) *
(P 481)
❙ Lane Keeping Assist System (LKAS) Button (P 552)
❙ Interval Button (P 529, 544)
❙ Steering Wheel Adjustments (P 207)
❙ Bluetooth ® HandsFreeLink ® System Voice Control Buttons (P 403, 427)
❙ Audio Remote Controls (P 248)❙ Horn (Press an area around .)
❙ (HUD) Button *
(P159 )
❙ Heated Steering Wheel *
(P 235)Canadian models
* Not available on all models

13
Quick Reference Guide
Turn Signals (P 193)
Lights (P 193)Turn Signal Control Lever
Right
Left
Light Control Switches
Low Beam High Beam
Flashing Wipers and Washers (P 200)
*1:Models with automatic intermittent
wipers
*2:Models without automatic intermittent
wipers Wiper/Washer Control Lever
Adjustment Ring ( -
: Low Sensitivity *1
( -
: Lower speed, fewer sweeps *2
( +
: High Sensitivity *1
( +
: Higher speed, more sweeps *2
MIST
OFF
AUTO *1
: Wiper speed varies automatically
INT *2
: Low speed with intermittent
LO : Low speed wipe
HI : High speed wipe Pull toward
you to spray
washer fluid. AUTO should always be turned OFF before
the following situations in order to prevent
severe damage to the wiper system:
● Cleaning the windshield
● Driving through a car wash
● No rain
Steering Wheel (P 207)
● To adjust, push the adjustment lever
down, adjust to the de sired position, then
lock the lever back in place. Models with automatic intermittent wipers
To lock
To adjust

200 uu Operating the Switches Around the Steering Wheel u Wipers and Washers
Controls Wipers and Washers The windshield wipers and washers can be
used when the power mode is in ON.
■ MIST
The wipers run at high speed until you release
the lever.
■ Wiper switch (OFF, INT *1
/AUTO *2
, LO, HI)
Move the lever up or down to change the
wiper settings.
■ Adjusting wiper operation *
Turn the adjustment ring to adjust the wiper
operation.
■ Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one second, the spray stops, the wipers sweep two
or three more times to clear the windshield, then stop.
*1: Models with manual intermittent operation
*2: Models with automati c intermittent operation■ Windshield Wiper/Washer 1 Wipers and Washers NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get sc ratched, or the rubber
blades will get damaged. NOTICE
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation’s
shortest delay se tting ( ) and the LO setting become
the same.
NOTICE
In cold weather, the blades may freeze to the
windshield.
Operating the wipers in th is condition may damage
the wipers. Use the defogge r or heated windshield *

to warm the windshield, then turn the wipers on. Models with intermittent time adjustment ring
MIST
INT *1
/ AUTO *2
OFF
LO : Low speed wipe
HI : High speed wipe Pull to
use
washer.
Intermittent Time
Adjustment Ring *
Lower speed, fewer sweeps
Higher speed, more sweeps
* Not available on all models

201uu Operating the Switches Around the Steering Wheel u Wipers and Washers
Controls
When you push the lever down to AUTO , the
windshield wipers sweep once, and go into
the automatic mode.
The wipers operate intermittently, at low
speed, or at high speed and stops in
accordance with the amount of rainfall the
rainfall sensor detects.
■ AUTO sensitivity adjustment
When the wiper function is set to AUTO , you
can adjust the sensitivity of the rain fall sensor
(using the adjustment ring) so that wipers will
operate in accordance with your preference.
Sensor sensitivity■ Automatic Intermittent Wipers * 1 Wipers and Washers
If the wipers st op operating due to an obstacle such
as the build-up of snow, pa rk the vehicle in a safe
place.
Rotate the wiper switch to OFF , and set the power
mode to ACCESSORY or VEHICLE OFF, then remove
the obstacle.
1 Automatic Intermittent Wipers *
The rainfall sensor is in the location shown below.
AUTO should always be turned OFF before the
following situations in order to prevent severe
damage to the wiper system:
• Cleaning the windshield
• Driving through a car wash
• No rain presentRainfall SensorAdjustment Ring
Low Sensitivity
High Sensitivity
* Not available on all models

205uu Operating the Switches Around the Steering Wheel u Driving Position Memory System *
Continued
Controls
Driving Position Memory System *You can store two driver’s seat positions (except for power lumbar) with the driving
position memory system.
When you unlock and open the driver's door with a remote transmitter, or smart
entry system to one of the two preset po sitions and the seat adjusts to retracted
positions of one of the two preset positions automatically.
The seat will move to the stored position when you set the power mode to
ACCESSORY.
When you enter the vehicle, the driver in formation interface briefly shows you which
remote transmitter you used to unlock the vehicle.
• DRIVER 1 transmitter is linked to memory button 1.
• DRIVER 2 transmitter is linked to memory button 2.
The driver’s seat moves rearward depending
on the set seating position once you
• Stop the vehicle.
• Put the transmission into ( P
.
• Turn the engine off.
• Then open the driver’s door.
Once the power mode is in the ACCESSORY
position, the driver’s seat moves forward to
the DRIVER 1 or 2 preset position. 1 Driving Position Memory System *
Using the audio/informati on screen you can disable
the automatic seat adjustment function.
2 Customized Features P. 381
The driver’s seat easy exit feature can be turned ON/
OFF.
2 Customized Features P. 381
System Operation
The system will not operate if:
• The vehicle speed is above 2 mph (3 km/h).
• Either memory position but ton is pressed while the
seat is in motion.
• The seat position is adju sted while in operation.
• The memory 1 or 2 position is set fully to the rear.DRIVER 1
DRIVER 2
* Not available on all models

207uu Operating the Switches Around the Steering Wheel u Adjusting the Steering Wheel
Controls
Adjusting the Steering Wheel The steering wheel height and distance from your body can be adjusted so that you
can comfortably grip the steering wheel in an appropriate driving posture.
1. Push the steering wheel adjustment lever
down.
u The steering wheel adjustment lever is
under the steering column.
2. Move the steering wheel up or down, and
in or out.
u Make sure you can see the instrument
panel gauges and indicators.
3. Pull the steering wheel adjustment lever up
to lock the steering wheel in position.
u After adjusting the position, make sure
you have securely locked the steering
wheel in place by trying to move it up,
down, in, and out. 1 Adjusting the Steering Wheel
3
WARNING Adjusting the steering wheel position while
driving may cause you to lose control of the
vehicle and be seriously injured in a crash.
Adjust the steering wheel only when the
vehicle is stopped.To adjust To lock
Lever

210
Controls Adjusting the SeatsFront Seats Adjust the driver’s seat as far back as possible
while allowing you to maintain full control of
the vehicle. You should be able to sit upright,
well back in the seat and be able to
adequately press the pedals without leaning
forward, and grip the steering wheel
comfortably. The passenger’s seat should be
adjusted in a similar manner, so that it is as far
back from the front airbag in the dashboard
as possible.
■ Adjusting the front power seat(s) * 1 Adjusting the Seats
The National Highway Traffic Safety Administration
and Transport Cana da recommend that drivers allow
at least 10 inches (25 cm) between the center of the
steering wheel and the chest.
Always make seat adjustments before driving.3
WARNING Sitting too close to a front airbag can result
in serious injury or death if the front
airbags inflate.
Always sit as far back from the front
airbags as possible while maintaining
control of the vehicle.Move back.Allow sufficient
space.
■ Adjusting the Seat Positions Horizontal Position
Adjustment
Height Adjustment
(Driver’s seat only)
Seat-back Angle
Adjustment
Driver’s seat is shown
* Not available on all models