2019 DODGE CHALLENGER SRT service

[x] Cancel search: service

Page 160 of 500

DODGE CHALLENGER SRT 2019  Owners Manual 2. If you install the compact or non-matching full sizespare tire in place of a road tire that has a pressure below
the low-pressure warning limit, upon the next ignition
key cycle, the TPMS Warning L

Page 161 of 500

DODGE CHALLENGER SRT 2019  Owners Manual To reactivate the TPMS, replace all four wheel and tire
assemblies (road tires) with tires equipped with TPM
sensors. Then, drive the vehicle for up to 20 minutes above
15 mph (24 km/h). The TPMS will

Page 162 of 500

DODGE CHALLENGER SRT 2019  Owners Manual If your vehicle is not equipped with a rear seat, FCA
recommends that you do not allow children 12 years old
and under to ride in your vehicle.
2. A child who is not big enough to wear the vehicle sea

Page 172 of 500

DODGE CHALLENGER SRT 2019  Owners Manual In Automatic Locking Mode, the shoulder belt is automati-
cally pre-locked. The seat belt will still retract to remove
any slack in the shoulder belt. Use the Automatic Locking
Mode anytime a child re

Page 174 of 500

DODGE CHALLENGER SRT 2019  Owners Manual Air Bag Warning Light
The ORC monitors the readiness of the electronic parts ofthe air bag system whenever the ignition switch
is in the START or ON/RUN position. If the
ignition switch is in the OFF

Page 175 of 500

DODGE CHALLENGER SRT 2019  Owners Manual WARNING!
Ignoring the Air Bag Warning Light in your instrument
panel could mean you won’t have the air bag system to
protect you in a collision. If the light does not come on
as a bulb check when th

Page 183 of 500

DODGE CHALLENGER SRT 2019  Owners Manual If you do have a collision which deploys the air bags, any
or all of the following may occur:
•The air bag material may sometimes cause abrasions
and/or skin reddening to the occupants as the air ba

Page 185 of 500

DODGE CHALLENGER SRT 2019  Owners Manual Enhanced Accident Response System Reset
Procedure
In order to reset the Enhanced Accident Response System
functions after an event, the ignition switch must be
changed from ignition START or ON/RUN to