2019 CHEVROLET CRUZE stop start

2
Low Fuel
Traction Control Off
Brake System
Cruise Control
StabiliTrak Active
StabiliTrak Off
Forward Collision Alert
Security
Lights On Reminder
Airbag Readiness
Engine Oil Pressure
Check Engine
SYMBOLS
INSTRUMENT PANEL
Exterior Lamp Control/Instrument Panel Illumination Control
Windshield Wipers Lever
Trunk Release (Sedan Only)
Steering Wheel Adjustment Lever
Power Mirror ControlF
Turn Signal Lever
Audio Next/Previous Favorite Station ControlsF (behind steering wheel)
Hood Release (pull 2x to open)
Heated Steering WheelF/Cruise ControlF/Forward Collision AlertF/Lane Keep AssistF Buttons
Audio Volume ControlsF (behind steering wheel)
Engine Start/Stop ButtonF
Voice Recognition ButtonsF/Driver Information Center ControlsF
Driver Information CenterF

5F Optional equipment
The Keyless Access System enables operation of the doors and trunk/liftg\
ate without removing the Remote Keyless Entry transmitter from a pocket or purse. Th\
e transmitter must be within 3 feet of a door or the trunk/liftgate.
KEYLESS UNLOCKING
With the transmitter within range:
Press the lock button on the driver’s door handle to unlock the driver’s door; press it again within 5 seconds to unlock all doors.
Press the lock button on the front passenger’s door handle to unlock all doors.
Press the touchpad either above the license plate or at the base of the liftgate to open the trunk/liftgate.
KEYLESS LOCKING
With the ignition off, the transmitter out of the vehicle, and all doors\
closed:
Press the lock button on any door handle to lock all doors immediately.
If Passive Locking is turned on, all doors will lock automatically after\
a short delay once all doors are closed.
Note: To change the door lock and unlock settings, go to Settings > Vehicle > Remote Lock, Unlock, Start.
See Keys, Doors and Windows in your Owner’s Manual.
KEYLESS ACCESS SYSTEMF
KEYLESS (PUSHBUTTON) STARTF
The Remote Keyless Entry (RKE) transmitter must be in the vehicle to turn on the ignition.
STARTING THE ENGINE
With the vehicle in Park, press the brake pedal and then press the ENGINE START/STOP button. The button indicator will be green.
Note: If the RKE transmitter battery is weak, place the transmitter in the front cupholder in the center console to enable the engine to start. Replace the transmitter battery as soon as possible.
STOPPING THE ENGINE/OFF
Shift to Park and press the ENGINE START/STOP button.
ACCESSORY MODE
With the engine off and the brake pedal not depressed, press the ENGINE START/STOP button. The button indicator will be amber.
See Driving and Operating in your Owner’s Manual.

6F Optional equipment
FRONT SEATS
MANUAL DRIVER’S SEAT
A. Seat Adjustment
Lift the handle under the front of the seat near the console to slide the seat.
B. Seat Height Adjustment
Ratchet the lever to raise or lower the seat.
C. Seatback Recline Adjustment
Lift the lever to recline or raise the seatback.
POWER DRIVER’S SEATF
A. Seat Adjustment
Move the horizontal control to move the seat forward or rearward and to tilt, raise or lower the seat.
B. Seatback Recline Adjustment
Move the vertical control to recline or raise the seatback.See Seats and Restraints in your Owner’s Manual.
AUTO ENGINE STOP/START OPERATION (IF EQUIPPED)
An automatic stop/start system has been integrated with the engine to he\
lp conserve fuel. While driving, when the brake is applied and the vehicle is at a c\
omplete stop, the automatic engine stop/start system may turn off the engine, depending on\
operating conditions. When the engine is off, the tachometer gauge will read AUTO \
STOP. Upon releasing the brake pedal or applying the accelerator pedal, the engine \
will restart. After parking and turning off the vehicle, the tachometer gauge will read OFF.\

The engine may remain running or restart when the vehicle is stopped if:\
• A minimum vehicle speed is not reached.
• The engine or transmission is not at the required operating temperature.\
• The outside temperature is not in the required operating range.
• The shift lever is in any gear other than Drive (D).
• The battery state of charge is low.
• The climate control setting requires the engine to run. Select the Eco a\
ir conditioning setting (green A/C indicator) to maximize the frequency and duration o\
f Auto Stops.
• The Auto Stop time is greater than 2 minutes.
DISABLING AUTO ENGINE STOP/START
Press the $ button on the center console, when the engine is running, to disable the system. The system is enabled each time the vehicle is started.
See Driving and Operating in your Owner’s Manual.
CBA
BA

14
CLIMATE CONTROLS
F Optional equipment
ECO MODE (MODELS WITH AUTO ENGINE STOP/START)
Press the A/C control until the indicator is green to select the Eco air conditioning setting. This setting will maximize the frequency and duration of Auto S\
tops.
Press the A/C control until the indicator is amber to select the Comfort air conditio\
n-ing setting. Auto Stops will be reduced in both frequency and duration.
See Climate Controls in your Owner’s Manual.
A/C Temperature Control/Air Conditioning Control Defog Mode
Vent Mode
Recirculation Mode
Floor Mode Bi-level Mode Rear Window Defogger
Driver’s Heated Seat ButtonF
Defrost Mode
Fan Speed Control/Off
AUTO Automatic OperationF
Passenger’s Heated Seat ButtonF