4-11
4
To install the seat
Insert the projections on the front of the seat into
the seat holders and push down on the seat at the
rear. Make sure that the seat is securely fitted.
EBU30052Front shock absorbersThese shock absorber assemblies are equipped
with a spring preload adjusting nut, a rebound
damping force adjusting screw, with a compres-
sion damping force adjusting bolt (for fast com- pression damping), and a compression damping
force adjusting screw (for slow compression
damping).
WARNING
EWB02492
Suspension components become hot during
operation. Never touch the compression
damping force adjusting bolt and screw, the
rebound damping force adjusting screw or
the oil reservoir with your bare hand or skin
until suspension components have cooled.
Always adjust the shock absorber assem-
blies on the left and right side to the same
setting. Uneven adjustment can cause poor
handling and loss of stability, which could
lead to an accident. NOTICEECB00091Never turn an adjusting mechanism beyond
the minimum and maximum settings. TIPAlthough the total number of clicks or turns of a
damping force adjusting mechanism may not ex-
actly match the following specifications due to
1. Projection
2. Seat holder
1
2
UBW261E0.book Page 11 Friday, May 26, 2017 9:38 AM
4-22
4Compression damping force
Remove the seat to make this adjustment. (See
page 4-10.) If the adjustment is difficult, it may be
necessary to remove panels A and C. (See page
8-10.)
Fast compression damping force
To increase the fast compression damping force
and thereby harden the compression damping,
turn the fast compression damping force adjust-
ing bolt in direction (a). To decrease the fast com-
pression damping force and thereby soften the
compression damping, turn the adjusting bolt in
direction (b).
Slow compression damping force
To increase the slow compression damping force
and thereby harden the compression damping,
turn the slow compression damping force adjust-
ing screw in direction (a). To decrease the slow
compression damping force and thereby soften
the compression damping, turn the adjusting
screw in direction (b).
1. Fast compression damping force adjusting bolt
(a)
(b)
1
Fast compression damping setting:
Minimum (soft):2 turn(s) out from the fully turned in posi-
tion
Standard: 1 turn(s) out from the fully turned in posi-
tion
Maximum (hard): Adjusting bolt fully turned in
UBW261E0.book Page 22 Friday, May 26, 2017 9:38 AM
