4-11
4
EBU31391Light switch “ / / ”Set the switch to “ ” to turn on the low
beam and the taillights.
Set the switch to “ ” to turn on the high
beam and the taillights.
Set the switch to “ ” to turn off the head-
lights and taillights.NOTICEECB02061Do not use the headlights with the engine
turned off for an extended period of time.
The battery may discharge to the pointthat the electric starter will not have
enough power to crank the engine. If this
should happen, remove the battery and re-
charge it.
EBU31402On–Command drive knob
“2WD/4WD/DIFF LOCK”Stop the vehicle and move the On–Command
drive knob to change the drive mode to two–
wheel drive, four–wheel drive, or four–wheel
1. Light switch “ / / ”
L
H
1
L
HLH
1. On-Command drive knob “2WD/4WD/DIFF LOCK”
1
UB3D7AE0.book Page 11 Tuesday, November 7, 2017 9:38 AM
4-33
4
This vehicle is equipped with a trailer hitch
bracket and a 2" (5 cm) receiver for a stan-
dard trailer hitch. Trailer towing equipment
can be obtained at a Yamaha dealer. See
page 6-7 for loading information.EBU32952Auxiliary DC jack
This model has an auxiliary DC jack in the
dashboard. A 12-V accessory with the proper
plug, such as a radio or smartphone charger,
can be used when the engine is running and
the headlights are off.
1. Start the engine. (See page 6-2.)
2. Turn the headlights off. (See page 4-11.)
3. Open the auxiliary DC jack cap.
4. Turn the accessory off.
5. Insert the accessory power plug.
6. Turn the accessory on.TIP When inserting or removing the accessory
power plug, turn the accessory off.
When the auxiliary DC jack is not being
used, cover it with the cap.
1. Auxiliary DC jack cap
2. Auxiliary DC jack
21
Auxiliary DC jack maximum capacity:
10 A (120 W)
UB3D7AE0.book Page 33 Tuesday, November 7, 2017 9:38 AM
