8-28
8
11. Connect the coolant reservoir hose.
12. Pour the specified amount of fresh cool-ant into the radiator, then install the radi-
ator cap.
13. Pour the specified amount of fresh cool- ant into the reservoir, then install the res-
ervoir cap.
14. Remove the right panel and right rear panel. (See page 8-11.)
15. Loosen the water pump air bleed bolt to
allow air to escape from the system. 16. When coolant begins to flow out, tighten
the bleed bolt.
17. Loosen the cylinder head air bleed bolt to allow air to escape from the system.Tightening torque:Coolant drain bolt:8 N·m (0.8 kgf·m, 5.9 lb·ft)
1. Water pump air bleed boltTightening torque: Water pump air bleed bolt:8 N·m (0.8 kgf·m, 5.9 lb·ft)
1
UB3D7AE0.book Page 28 Tuesday, November 7, 2017 9:38 AM
8-37
8
EBU33691V-belt case drain plugThe V-belt case drain plug is located behind
the left panel. (See page 8-11 for left panel re-
moval and installation procedures.)
After operating in water deep enough to allow
water to enter the V-belt case, remove the
drain plug to drain any water from the case.
If water drains from the V-belt case after re-
moving the drain plug, have a Yamaha dealer
inspect the vehicle, as the water may affect
other engine parts.
EBU32450Cleaning the spark arrester
WARNING
EWB03370Hot exhaust system may cause burns. To
avoid burns or fires, make sure that the en-
gine is stopped and the exhaust system is
cool before cleaning the spark arrester. Do
not start the engine while cleaning the ex-
haust system. 1. Remove the tailpipe bolts.
1. Air intake duct check hose
2. Air filter case check hose2
1
1. V-belt case drain plug
1
UB3D7AE0.book Page 37 Tuesday, November 7, 2017 9:38 AM
