2018 VAUXHALL COMBO D ignition

162Vehicle careIf w illuminates, stop as soon as
possible and inflate the tyres as
recommended 3 191.
After inflating, driving may be
required to update the tyre pressure
values in the system. During this time
w may illuminate.
If w illuminates at lower temperatures
and extinguishes after some driving,
this could be an indicator for
approaching a low tyre pressure
condition. Check tyre pressure of all
four tyres.
If the tyre pressure must be reduced
or increased, switch off ignition.
Only mount wheels with pressure
sensors, otherwise the tyre pressure
value cannot be recognised by the
system and w flashes for several
seconds then illuminates
continuously. In vehicles with
Multifunction version of the Driver
Information Centre, a corresponding message is also displayed.
A spare wheel or temporary spare
wheel is not equipped with pressure
sensors. The tyre pressure
monitoring system is not operationalfor these wheels. For the further three
wheels, tyre pressure monitoring
system remains operational.
Spare wheel 3 168, Wheel changing
3 166.
Control indicator w and (depending
on version) a corresponding message appears at each ignition cycle until
the tyres are inflated to the correct
tyre pressure.
Driver Information Centre 3 90.
Relearn function
After changing wheels, the tyre
pressure monitoring system needs to
recalculate. The relearn process
takes up to 20 minutes of driving with
a minimum speed of 12 mph.
If problems occur during the relearn
process, control indicator w flashes
for several seconds then illuminates
continuously and (depending on
version) a warning message is
displayed in the Driver Information
Centre.
Driver Information Centre 3 90.General information
The use of tyre chains or
commercially available liquid tyre
repair kits can impair the function of
the system. Factory-approved tyre
repair kits can be used.
Tyre repair kit 3 164.
Tyre chains 3 163.
Operating electronic devices or being
close to facilities using similar wave
frequencies could disrupt the tyre
pressure monitoring system.
Each time the tyres are replaced, tyre pressure monitoring system sensors
must be dismounted and serviced by
a workshop.
Tread depth
Check tread depth at regular
intervals.
Tyres should be replaced for safety
reasons at a tread depth of 2-3 mm
(4 mm for winter tyres).
For safety reasons, it is
recommended that the tread depth of the tyres on one axle should not vary
by more than 2 mm.

172Vehicle careTowingTowing the vehicle
Release the cap by carefully lifting
with a screwdriver. To prevent
damage, it is recommended to place
a cloth between the screwdriver and
the frame.
The towing eye is stowed with the vehicle tools 3 159.
Screw in the towing eye as far as it will
go until it stops in a horizontal
position.
Attach a tow rope – or better still a tow
rod – to the towing eye.
Caution
The towing eye must only be used for towing and not for recovering
the vehicle.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wiper.
Switch the selector lever to neutral.
Release the parking brake.
Notice
If neutral cannot be selected on
vehicles with manual transmission
automated (MTA), the vehicle must
only be towed with the drive wheels
raised off the ground.
Caution
Drive slowly. Do not drive jerkily.
Excessive tractive force can
damage the vehicle.
When the engine is not running,
considerably more force is needed to
brake and steer.
To prevent the entry of exhaust gases from the towing vehicle, switch on the
air recirculation 3 107 and close the
windows.
Seek the assistance of a workshop. After towing, unscrew the towing eye
and replace the cap.
Towing another vehicle
Insert a screwdriver in the slot at the
side of the cap. Release the cap by
carefully levering the screwdriver. To
prevent damage it is recommended to place a cloth between the screwdriver
and the frame.

194Customer informationVehicle data recording
and privacy
Event data recorders Data storage modules in the
vehicle
A large number of electronic
components of your vehicle contain
data storage modules temporarily or
permanently storing technical data
about the condition of the vehicle,
events and errors. In general, this
technical information documents the
condition of parts, modules, systems
or the environment:
● operating conditions of system components (e.g. filling levels)
● status messages of the vehicle and its single components (e.g.
number of wheel revolutions / rotational speed, deceleration,
lateral acceleration)
● dysfunctions and defects in important system components● vehicle reactions in particulardriving situations (e.g. inflation of
an airbag, activation of the
stability regulation system)
● environmental conditions (e.g. temperature)
This data is exclusively technical and
helps identifying and correcting errors as well as optimizing vehicle
functions.
Motion profiles indicating travelled
routes cannot be created with this
data.
If services are used (e.g. repair
works, service processes, warranty
cases, quality assurance),
employees of the service network
(manufacturer included) are able to
read out this technical information
from the event and error data storage
modules applying special diagnostic
devices. If required, you will receive
further information at these
workshops. After an error has been
corrected, the data is deleted from the
error storage module or it is
constantly overwritten.When using the vehicle, situations
may occur in which technical data
related to other information (accident
report, damages on the vehicle,
witness statements etc.) may be
associated with a specific person -
possibly, with the assistance of an
expert.
Additional functions contractually
agreed upon with the client (e.g.
vehicle location in emergency cases)
allow the transmission of particular
vehicle data from the vehicle.
Radio Frequency
Identification (RFID)
RFID technology is used in some
vehicles for functions such as tyre
pressure monitoring and ignition
system security. It is also used in
connection with conveniences such
as radio remote controls for door
locking/unlocking and starting, and in- vehicle transmitters for garage dooropeners. RFID technology in
Vauxhall vehicles does not use or
record personal information or link
with any other Vauxhall system
containing personal information.

198GGauges ......................................... 76
Gear shifting ................................. 85
General information ...................138
Generic warning .............81, 96, 115
Glovebox ..................................... 61
Gross Vehicle Weight ...................67
H
Halogen headlights ....................149
Hand brake ................................. 127
Hazard warning flashers ............100
Headlamp washer......................... 72
Headlight flash ............................. 99
Headlight range adjustment ......100
Headlights..................................... 99
Headlights when driving abroad 100
Head restraint adjustment .............8
Head restraints ............................ 34
Heated mirrors ............................. 30
Heated rear window ..................... 33
Heating ........................................ 39
Heating and ventilation system . 106
High beam ............................. 89, 99
Hill start assist ...................... 85, 127
Horn ....................................... 13, 70
I Identification plate .....................181
Ignition switch positions .............114
Immobiliser ............................ 28, 89Indicators...................................... 76
Information displays...................... 90
Initial drive information.................... 6
Installing seats .............................. 41
Instrument cluster ........................76
Instrument panel fuse box .........157
Instrument panel illumination .....154
Instrument panel illumination control .................................... 102
Instrument panel overview ........... 10
Instrument panel storage ..............60
Interior care ............................... 175
Interior lighting ......................90, 102
Interior lights ...................... 103, 153
Interior mirrors .............................. 30
Introduction .................................... 3
ISOFIX .......................................... 54
J Jump starting ............................. 170
K Kerb weight................................... 67Key number .................................. 19
Keys ............................................. 19
Keys, locks ................................... 19
L
Language ..................................... 90
Lashing eyes ......................... 65, 67
Laying up the vehicle ..................146Light switch .................................. 99
Load compartment ................27, 62
Load compartment cover .............63
Load compartment grille ...............66
Load compartment lighting .........104
Loading ............................. 37, 40, 41
Loading information .............67, 188
Loadspace dimensions ...............188
Lock cylinders ............................... 19
Low engine oil level .....................88
Low fuel ....................................... 88
Luggage floor net .........................65
Lumbar support ............................ 36
M Malfunction indicator light ............83
Manual adjustment ......................29
Manual anti-dazzle ......................30
Manual door locks ........................21
Manual mode ............................. 124
Manual transmission .................. 121
Manual transmission automated 122
Manual windows ..........................31
Mirror adjustment ........................... 8
Misted light covers .....................102
Multifunction display .....................90
N
Natural gas ................................. 190
New vehicle running-in ..............114
Number plate light .....................152