2018 TOYOTA RAV4 display

1
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
INDEX
Engine maintenance 9
Fuel tank door release & cap 8
Hood release 8
Indicator symbols 4-5
Instrument cluster 4
Instrument panel 2-3
Instrument panel light control 9
Keyless (and remote) entry
1 6-7
Smart Key system1 7
1 Visit your Toyota dealer for information on customizing this feature.2 Programmable by customer. Refer to the Owner’s Manual for instructions and more information.3 HomeLink® is a registered trademark of Gentex Corporation.
OVERVIEW
FEATURES & OPERATIONSFEATURES & OPERATIONS (continued)
SAFETY & EMERGENCY FEATURES TOYOTA SAFETY SENSE™ P (TSS-P)
Air conditioning/heating 15
All-Wheel Drive Lock
(AWD models) 22
Audio 17
Auto lock/unlock
1 10
Automatic transmission 10
Bird’s Eye View Camera
with Perimeter Scan function 20
Blind Spot Monitor with Rear
$SPTT5SBGmD"MFSU #4.X3$5"

Clock 20
Cup holders 24
Door locks 13
Door-Power Liftgate 14
ECO drive mode 23
Garage door opener (Homelink
®)3 24
Intuitive parking assist 22
Lights
1,2 & turn signals1 11-12
Moonroof 16
Multi-Information Display (MID)
2 19
Parking brake 10
Power outlets-12V DC & 120V AC 19
Rear view monitor system 21
Seat adjustments-Front 13
Seat adjustments-Rear 13
Seat heaters 16
Seats-Head restraints 13Sport drive mode 23
Steering wheel-Heater 16
Steering wheel switches
(Audio & phone: Bluetooth
®) 18
Tilt & telescopic steering wheel 11
USB/AUX Port 18
Vehicle Stability Control
(VSC) OFF button 23
Windows-Power 24
Windshield wipers & washers 12
Automatic High Beams (AHB) 35
Dynamic Radar
Cruise Control (DRCC) 31-34
Lane Departure Alert with Steering
Assist function (LDA w/SA) 28-31
Pre-Collision System with Pedestrian
Detection function (PCS w/PD) 26-28
Quick overview-
Toyota Safety Sense
™ P (TSS-P) 25
Sensors 25
BLUETOOTH® DEVICE
PAIRING SECTION 40-49 Floor mat installation 39
Rear door child safety locks
37
Seat belts 36
Seat belts-Shoulder belt anchor
37
Spare tire & tools 37
Star Safety System
TM 38-39
Tire Pressure Monitoring
(warning) System (TPMS) 36

22
OVERVIEW
Instrument panel
Steering wheel controls
Voice command
switch2
Tilt and telescopic
steering lock release lever
Audio control
switches2
Paddle shift switches1
Multi-Information Display
(MID) controls1
Dynamic Radar Cruise
Control (DRCC) vehicle-
to-vehicle distance
button
Dynamic Radar Cruise
Control (DRCC) or Cruise
control switch
Hood lock release lever Headlight, turn signal, fog light
1 and
Auto High Beam (AHB) controls
Fuel tank door release lever
Power Liftgate main switch1
All-wheel drive (AWD) lock switch
Lane Departure Alert
(LDA) switch
Tire Pressure Monitoring (warning)
System (TPMS) reset switch1
Instrument panel
light control dial
Outside rear view
mirror switches
Heated steering
wheel switch1
Windshield wiper and washer controls
Instrument cluster

1 If equipped.2 If indicator does not turn off within a few seconds of starting engine, there may be a malfunction.
Have vehicle inspected by your Toyota dealer.
4 4
OVERVIEW
Instrument cluster
For details, refer to “Indicators and warning lights,” Section 2-2, 2018 Owner’s
Manual.
ODO
68°F
1000 miles
Blind Spot Monitor (BSM)
warning1,2
Blind Spot Monitor outside mirror
indicators1
Brake system warning2
Arrow direction indicates fuel tank
door positionAirbag ON/OFF indicator
Anti-lock Brake System warning2
All-wheel drive lock indicator1
AUTO LSD indicator1,2
Automatic High Beam (AHB)
indicator
Constant speed cruise control
indicator/Constant speed
cruise control SET indicator
Dynamic Radar Cruise
Control (DRCC) indicator/
DRCC SET indicator
Indicator symbols
Tachometer
Engine coolant
temperature gaugeOdometer and trip meter Multi-Information
Display (MID)Fuel gauge Speedometer Outside temperature Shift position & range
Service indicators and reminders

14
FEATURES & OPERATIONS
NOTE: If battery is disconnected, the power back door needs to be reinitialized.
1. When the liftgate reaches the desired height, push the rear liftgate close-button
(on the door jam of the liftgate) once. Press and hold the button until the buzzer
sounds.
2. To reset the height, with the liftgate open and not moving, press and hold the
rear liftgate close-button until it buzzer sounds 4 times, and continue to hold until
it buzzes again -then let go. Push the same button to close the liftgate. When you
next open the liftgate it will open to the maximum height.
3. To set the height using the Multi-Information Display, press
or meter control
switches and select
from the MID. Press or and select and
then press
. Select Opening Adjustment, then press . Select desired
position (5 height options to choose from,) then press
.
NOTE: If the liftgate has stopped operating, check inside the glove box, on the
left side, to ensure the PWR DOOR OFF button has not been pushed.
For more details, see Owner’s Manual.
To automatically open/close Power Liftgate Put your foot near the lower center
part of the rear bumper for less than 2-seconds to trigger sensor. To operate, make
sure that the touchless sensor operation is enabled and that you are carrying the
remote.
Door-Power Liftgate (if equipped)
Instrument panel
Power Liftgate (back door)
Touchless Power Liftgate (if equipped)
Open: Push and hold
Close: Push and hold again
(open only)
Sensor area
(close only)
Carry remote
Smart key feature
PROGRAMMABLE POWER LIFTGATE

Push MID control switches to view or change information in the following:
Drive information
Navigation system linked display (if equipped)
Audio system-linked display
Driving assist information (if equipped)
Warning messages
Settings display
19
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Refer to the Owner’s Manual for more information.
NOTE: Designed for car accessories. Engine switch must be in the “ACC” or
“ON” position to be used.
Power outlets-12V DC & 120V AC
12V DC - Front12V DC - Rear
120V AC (if equipped)
Multi-Information Display (MID)
Enter/Set:
Press to enter/set,
press and hold to
reset
Return to previous screen
“” and “” Press to select an item/change
pages

See-through view switch Moving view switchRotation pause switch Rotation pause switch
20
FEATURES & OPERATIONS
The Bird’s Eye View Camera with Perimeter Scan function assists the driver in
viewing the surroundings, when operating at low speeds or parking, by combining
front, side and rear cameras and displaying an overhead image on the Entune™
screen.
To view or turn OFF the screen, press the camera switch when the shift lever is in
the “P” position. It will display two angles, the Moving view and the See Through
view.
For limitations and more details, refer to section 6-3 in the “Navigation System
Owner’s Manual.”
Moving viewSee through view
Refer to the Owner’s Manual or the Navigation System Owner’s Manual for more
information.
Bird’s Eye View Camera
with Perimeter Scan Function
(if equipped)
1) Push “SETUP” next to the screen. The system displays the Setup screen.
2) Select “General” to access General settings screen.
3) Select “Clock” to access settings. To find your system, refer to the Audio section of this guide.
1) Push “APPS” button next to the screen, then select “Setup” on the touch screen.
2) Select “General” on the touch screen. The system displays the “General Settings”
screen.
3) Then select “Clock” to access settings.
FOR ENTUNE™ AUDIO
Clock
FOR ENTUNE™ AUDIO PLUS WITH CONNECTED NAVIGATION APP AND ENTUNE™
PREMIUM (JBL®) AUDIO WITH INTEGRATED NAVIGATION AND APP SUITE

21
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
The Blind Spot Monitor is a system that has two functions:
• The Blind Spot Monitor function (assists the driver in making the decision when
changing lanes)
• The Rear Cross Traffic Alert function (assists the driver when backing up)
The system is designed to use radar sensors to detect vehicles traveling in the
RAV4’s blind spot and advises the driver of the vehicles’ presence via the outside
rear view mirror indicators.
Refer to the Owner‘s Manual for limitations and more details on this system before
attempting to use it.
Rear view monitor system (if equipped)
The rear view monitor system displays an image of the view from the bumper of
the rear area of the vehicle. The camera for the rear view monitor system is located
above the license plate.
To adjust the image on the rear view monitor screen, press the “APPS” button
and select “Display” on the “Setup” screen. Select “Camera” to adjust the screen
contrast and brightness.
Refer to the Owner‘s Manual for limitations and more details on this system.
Refer to the Owner’s Manual for more information.
Blind Spot Monitor with Rear Cross
Traffic Alert (BSM w/RCTA)
(if equipped)
Buzzer
System ON/OFF
IndicatorIndicator

22
FEATURES & OPERATIONS
All-Wheel Drive Lock (AWD models)
Push the switch to ensure that the engine torque is applied to the four wheels.
NOTE: Should ONLY be used when wheel spinning occurs on loose or
unpaved surfaces.
Refer to the Owner’s Manual for more details.
Intuitive parking assist (if equipped)
If the sensors detect an obstacle, the buzzer and MID display informs the driver of
the approximate position and distance of the obstacle by illuminating continuously
(far) or blinking (near). Depending on your Entune™ Audio system, you can adjust
settings.
To turn system ON/OFF:
1) Press “
/”, “/” and “” of the meter control switches and select
from the Multi-Information Display (MID).
2) Select
and press “”. The system displays when the the system is
operational.
Refer to section Intuitive parking assist in the Owner’s Manual for more details.
Front
center sensor
Rear
center sensor Corner sensors
(front)Corner sensors
(front)
Corner sensors
(rear)Corner sensors
(rear)