2018 TOYOTA CAMRY Owners Manual (in English)

4816-3. Do-it-yourself maintenance
CAMRY_U (01999-06122)
6
Maintenance and care
Remove the light unit.
Attach a long piece of
packing tape to the light
unit and fold the excess in
half.
Hold the folded portion
and pull it toward the rear
of the vehicle to remove
the light unit.
Turn the bulb base counterclockwise.
Remove the light bulb.4
1
2
5
Rear turn signal lightsRear side marker lights
6
Rear turn signal lightsRear side marker lights

4826-3. Do-it-yourself maintenance
CAMRY_U (01999-06122)
Install a new light bulb and then install the bulb base to the light
unit by inserting it and turning it clockwise.
Install the light unit.
Align the tabs and push the light
unit toward the front of the vehi-
cle to install it.
Install the 2 bolts.
7
Rear turn signal lightsRear side marker lights
8
9

4836-3. Do-it-yourself maintenance
CAMRY_U (01999-06122)
6
Maintenance and care
Install the cover.
Remove the protective tape.
■Replacing the following bulbs
If any of the lights listed below has burnt out, have it replaced by
your Toyota dealer.
●Headlights
●Daytime running lights
●Parking lights (LED type)
●Front turn signal lights (LED type)
●Front side marker lights (LED type)
●Side turn signal lights (if equipped)
●Tail lights
●Rear side marker lights (LED type)
●Stoplights
●Rear turn signal lights (LED type)
●Back-up lights (LED type)
●High mounted stoplight
●License plate lights
■LED light bulbs
The lights other than the front turn signal/parking lights (bulb type), front side
marker lights (bulb type), back-up lights (bulb type), rear turn signal lights
(bulb type) and rear side marker lights (bulb type) consist of a number of
LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to
have the light replaced.
■Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction.
Contact your Toyota dealer for more information in the following situations:
●Large drops of water have built up on the inside of the lens.
●Water has built up inside the headlight.
10
11

4846-3. Do-it-yourself maintenance
CAMRY_U (01999-06122)
WARNING
■Replacing light bulbs
●Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
●Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth
to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
●Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
■To prevent damage or fire
Make sure bulbs are fully seated and locked.

485
7When trouble arises
CAMRY_U (01999-06122)7-1. Essential information
Emergency flashers .......... 486
If your vehicle has to be
stopped in an
emergency ...................... 487
7-2. Steps to take in an
emergency
If your vehicle needs to
be towed ......................... 489
If you think something is
wrong .............................. 495
Fuel pump shut off
system ............................ 496
If a warning light turns
on or a warning buzzer
sounds ............................ 497
If a warning message
is displayed ..................... 507
If you have a flat tire.......... 512
If the engine will
not start ........................... 524
If the electronic key does
not operate properly........ 526
If the vehicle battery is
discharged ...................... 529
If your vehicle
overheats ........................ 534
If the vehicle becomes
stuck ............................... 537

486
CAMRY_U (01999-06122)
7-1. Essential information
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch
once again.
■Emergency flashers
If the emergency flashers are used for a long time while the engine is not
operating, the battery may discharge.
Emergency flashers
The emergency flashers are used to warn other drivers when the
vehicle has to be stopped on the road due to a breakdown, etc.

4877-1. Essential information
7
When trouble arises
CAMRY_U (01999-06122)
Steadily step on the brake pedal with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort
required to slow the vehicle.
Shift the shift lever to N.
If the shift lever is shifted to N
After slowing down, stop the vehicle in a safe place by the road.
Stop the engine.
If the shift lever cannot be shifted to N
Keep depressing the brake pedal with both feet to reduce vehicle
speed as much as possible.
Vehicles without a smart key
system: Stop the engine by
turning the engine switch to the
“ACC” position.
Vehicles with a smart key sys-
tem: To stop the engine, press
and hold the engine switch for 2
consecutive seconds or more,
or press it briefly 3 times or
more in succession.
Stop the vehicle in a safe place by the road.
If your vehicle has to be stopped in an
emergency
Only in an emergency, such as if it becomes impossible to stop
the vehicle in the normal way, stop the vehicle using the follow-
ing procedure:
1
2
3
4
3
4
Press and hold for 2 seconds or
more, or press briefly 3 times or more
4
5

4887-1. Essential information
CAMRY_U (01999-06122)
WARNING
■If the engine has to be turned off while driving
●Power assist for the brakes and steering wheel will be lost, making the
brake pedal harder to depress and the steering wheel heavier to turn.
Decelerate as much as possible before turning off the engine.
●Vehicles without a smart key system: Never attempt to remove the key, as
doing so will lock the steering wheel.