2018 TOYOTA C-HR Door light

3886-3. Do-it-yourself maintenance
C-HR_OM_USA_OM10526U■
License plate lights
Open the back door and
remove the cover.
To prevent damaging the vehi-
cle, wrap the flathead screw-
driver with a tape.
Turn the bulb base counter-
clockwise.
Remove the light bulb.
When installing, reve rse the steps listed.
1
2
3
4

4137-2. Steps to take in an emergency
7
When trouble arises
C-HR_OM_USA_OM10526UFront passenger’s seat belt warning buzzer:
The front passenger’s seat belt warning buzzer sounds to alert the front
passenger that his or her seat belt is not fastened. The buzzer sounds
once if the vehicle reaches a speed of 12 mph (20 km/h). If the seat belt is
still unfastened after 24 seconds, the buzzer will sound intermittently for 6
seconds. Then, if the seat belt is still unfastened, the buzzer will sound in a
different tone for 90 more seconds.
Rear passengers’ seat belt warning buzzer:
The rear passengers’ seat belt warning buzzer sounds to alert the rear
passengers that his or her seat belt is not fastened. If the vehicle reaches a
speed of 12 mph (20 km/h), the buzzer will sound intermittently for 6 sec-
onds. Then, if the seat belt is still unfastened, the buzzer will sound in a dif-
ferent tone for 24 more seconds.
■
SRS warning light
This warning light system monitors the airbag sensor assembly, front impact
sensors, side impact sensors (front door), side impact sensors (front), side
impact sensors (rear), driver’s seat posit ion sensor, driver’s seat belt buckle
switch, front passenger occupant classification system, “AIR BAG ON” indica-
tor light, “AIR BAG OFF” indicator li ght, front passenger’s seat belt buckle
switch, driver’s seat belt pretensioner, front passenger’s seat belt preten-
sioner and force limiter, airbags, interconnecting wiring and power sources.
( →P. 32)
■ Electric power steering system warning light (warning buzzer)
When the battery charge becomes insufficient or the voltage temporarily
drops, the electric power steering system warning light may come on and \
the
warning buzzer may sound.
■ If the malfunction indicator la mp comes on while driving
For some models, the malfunction indicator lamp will come on if the fuel tank
becomes completely empty. If the fuel tank is empty, refuel the vehicle imme-
diately. The malfunction indicator lamp will go off after several trips.
If the malfunction indicator lamp does not go off, contact your Toyota dealer.
■ Front passenger detection sensor, seat belt reminder and warning
buzzer
● If luggage is placed on the front passenger seat, the front passenger de\
tec-
tion sensor may cause the warning light to flash and the warning buzzer to
sound even if a passenger is not sitting in the seat.
● If a cushion is placed on the seat, the sensor may not detect a passenger,
and the warning light may not operate properly.

4147-2. Steps to take in an emergency
C-HR_OM_USA_OM10526U■
Warning light operations for unf astened rear passenger seat belts
● When opening and closing the rear door, the warning light comes on for
approximately 34 seconds.
● When any of the rear seat belts are unfastened, the warning light comes on.
When the rear doors are opened and closed while the warning light is on,
the warning light will turn off after approximately 34 seconds.
■
When the tire pressure warning light comes on
Inspect the appearance of the tire to check that the tire is not punctured.
If the tire is punctured: → P. 423
If the tire is not punctured:
Carry out the following procedure after the tire temperature has lowered
sufficiently.
●Check the tire inflation pressure and adjust to the appropriate level.
●If the warning light does not go out even after several minutes, check
that the tire inflation pressure is at the specified level and carry out ini-
tialization. ( →P. 355)
The warning light may come on again if the above operations are con-
ducted without first allowing the tire temperature to lower sufficiently.
■The tire pressure warning light may come on due to natural causes
The tire pressure warning light may come on due to natural causes such
as natural air leaks and tire inflat ion pressure changes caused by tem-
perature. In this case, adjusting the ti re inflation pressure will turn off the
warning light (afte r a few minutes).
■When a tire is replaced with a spare tire
The compact spare tire is not equipped with a tire pressure warning valve
and transmitter. If a tire goes flat, the tire pressure warning light will not
turn off even though the flat tire ha s been replaced with the spare tire.
Replace the spare tire with the repair ed tire and adjust the tire inflation
pressure. The tire pressu re warning light will go off after a few minutes.
■Conditions that the tire pressure warning system may not function
properly
→ P. 3 5 8

4207-2. Steps to take in an emergency
C-HR_OM_USA_OM10526U
■Warning messages
The warning messages explained below may differ from the actual messages
according to operation conditions and vehicle specifications.
■ System warning lights
The master warning light does not come on or flash in the following cases.
Instead, a separate system warning light will come on along with a message
shown on the multi-information display.
“Anti-lock Brake System Malfunction Visit Your Dealer”:
The ABS warning light comes on. ( →P. 409)
■ If “Visit Your Dealer” is shown
The system or part shown on the multi-information display is malfunctioning.
Have the vehicle inspected by your Toyota dealer.
■ If a message about an operation is shown
●If a message about an operation of the accelerator pedal or brake pedal is
shown
A warning message about an operation of the brake pedal may be shown
while the driving assist systems such as PCS (Pre-Collision System) or the
dynamic radar cruise control with full-speed range is operating. If a warning
message is shown, be sure to decelerate the vehicle or follow the instruction
shown on the multi-information display.
● A warning message is shown when Brake Override System or Drive-Start
Control operates ( →P. 148). Follow the instructions on the multi-informa-
tion display.
● If a message about an operation of the engine switch is shown
An instruction for operation of the engine switch is shown when the inco\
rrect
procedure for starting the engine is performed or the engine switch is oper-
ated incorrectly. Follow the instructions shown on the multi -information dis-
play to operate the engine switch again.
● If a message about a shift lever operation is shown
To prevent the shift lever from being operated incorrectly or the vehicle from
moving unexpectedly, a message that requires shifting the shift lever may
be shown on the multi-information display. In that case, follow the instruction
of the message and shift the shift lever.
● If a message or image about an open/close state of a part or replenishment
of a consumable is shown
Confirm the part indicated by the multi-information display or a warning light,
and then perform the coping method such as closing the open door or
replenishing a consumable.

4407-2. Steps to take in an emergency
C-HR_OM_USA_OM10526U
Connect the jumper cables according to the following procedure:Connect a positive jumper cable clamp to the positive (+) battery
terminal on your vehicle.
Connect the clamp on the other e nd of the positive cable to the
positive (+) battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery termi-
nal on the second vehicle.
Connect the clamp at the other end of the negative cable to a
solid, stationary, unpainted metallic point away from the battery
and any moving parts, as shown in the illustration.
Start the engine of the second v ehicle. Increase the engine speed
slightly and maintain at that level for approximately 5 minutes to
recharge the batter y of your vehicle.
Vehicles with a smart key system: Open and close any of the doors
of your vehicle with the engine switch off.3
32
4
4
5

4788-2. Customization
C-HR_OM_USA_OM10526U■
Power windows (
→P. 140)
*1: Vehicles without a smart key system
*2: Vehicles with a smart key system
■
Turn signal lever ( →P. 176)
■Automatic light control system ( →P. 185)
FunctionDefault settingCustomized
setting
Key*1 or mechanical
key
*2 linked operation
(open)OffOn—O
Key*1 or mechanical
key
*2 linked operation
(close)OffOn—O
Wireless remote control
linked operation (open
only)
OffOn—O
Key*1 or mechanical
key
*2, wireless remote
control linked operation
signal (buzzer)OnOff—O
FunctionDefault settingCustomized
setting
Times of flashing of the
lane change signal flash-
ers
3
Off
—O5
7
FunctionDefault settingCustomized setting
Light sensor sensitivity Level 0 Level -2 to 2—O
Time elapsed before
headlights automatically
turn off after doors are
closed
30 seconds
Off
—O60 seconds
90 seconds

4808-2. Customization
C-HR_OM_USA_OM10526U■
Illumination (
→P. 300)
*1: Vehicles with a smart key system
*2: If equipped
FunctionDefault settingCustomized
setting
Time elapsed before the
interior lights turn off15 seconds
Off
—O7.5 seconds
30 seconds
Operation after the engine
switch is turned offOnOff—O
Operation when the doors
are unlockedOnOff—O
Operation when you
approach the vehicle with
the electronic key on your
person
*1
OnOff—O
Outer mirror illumination*2OnOff—O
Time elapsed before the
outer mirror illumination
turn off
*215 seconds
Off
—O7.5 seconds
30 seconds
Operation of the outer mir-
ror illumination when you
approach the vehicle with
the electronic key on your
person
*1, 2
OnOff—O
Operation of the outer mir-
ror illumination when the
doors are unlocked
*2OnOff—O
Interior lights illumination
controlOnOff—O

502Alphabetical index
C-HR_OM_USA_OM10526U
Alphabetical index
A/C ............................................ 290Air conditioning filter ............. 370
ABS (Anti-lock Brake System)...... 279 Warning light ......................... 409
Air conditioning filter .............. 370
Air conditioning system .................................... 290
Air conditioning filter ............. 370
Airbags ....................................... 32 Airbag operating conditions .... 41
Airbag precautions for
your child .............................. 35
Correct driving posture ........... 24
Curtain shield airbag
operating conditions ............. 41
Curtain shield airbag
precautions ........................... 38
General airbag precautions .... 35
Locations of airbags................ 32
Modification and disposal of airbags ............... 40
Side airbag operating
conditions ............................. 41
Side airbag precautions .......... 35
Side and curtain shield airbags operating conditions ............. 41
Side and curtain shield airbags precautions ........................... 35
SRS airbags............................ 32
SRS warning light ................. 409
Anchor brackets ........................ 57
Anti-lock Brake System (ABS) ...................................... 279 Warning light ......................... 409
Assist grips .............................. 316
Automatic High Beam ............. 190
Automatic light control system .................................... 185
Auxiliary boxes ........................ 308 Back door ................................. 112
Back-up lights
Replacing light bulb .............. 387
Wattage ................................ 457
Battery ...................................... 349
Checking............................... 349
If the vehicle has discharged battery ................................ 439
Preparing and checking before winter ...................... 285
Warning light......................... 408
Bottle holders .......................... 305
Brake Fluid ...................................... 455
Parking brake ....................... 177
Warning light......................... 408
Brake assist ............................. 279
Break-in tips ............................ 149
Brightness control Instrument panel
light control ........................... 88
AB