Page 5 of 33
3
Getting
Started
Seating
Power Driver’s Seat (if equipped)
1. Forward/Backward, Angle
and Height
Move the switch toward the
front or rear to move the seat
forward or backward. Pull the
switch up or push down on
the front of the switch to adjust
the angle of the seat cushion.
Pulling the switch straight up
or pushing the switch straight
down will adjust the height of
the entire seat cushion.
2. Seatback Move the switch in the corresponding direction to adjust the angle of
the seatback.
2
1
3033672_18b_WRX_WRX_STI_QG_051617.indd 35/16/17 2:29 PM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 6 of 33
4
Seating
Seat Controls
1. Forward/Backward
Pull up on the lever below the front
of the driver’s seat to move the seat
forward or backward.
2. Raise/Lower Seat Cushion To adjust the height of the driver’s
seat, pull up or push down the seat
height adjustment lever, located on
the lower left side front of the seat.
3. Recline Seatback To adjust the seatback to the desired position, pull up on the recline lever, located on the
lower left rear of the driver’s seat or lower right rear of the passenger’s seat. Do not adjust
seats while driving.
1
32
Heated Seats (if equipped)
The switches are located on the center console between the driver and passenger seats. \
Choose low (bottom of switch) for normal heating or high (top of swit\
ch) for rapid heating.
Choose the center position to turn off the seat heaters.
3033672_18b_WRX_WRX_STI_QG_051617.indd 45/16/17 2:29 PM
Page 12 of 33
10
Tilt and Telescopic Steering Column
Push the lever down firmly to adjust the height and lengthwise positio\
n of the column;
firmly lift the lever back up to lock the column in place. Do not adju\
st while driving.
Power Exterior Mirrors
Turn the knob to the “L” side to adjust the left-hand mirror or to the “R” side to adjust the
right-hand mirror. Move the knob in the direction you want to move the mirror. Then return
the knob to the neutral/center position.
Personalize
Combination Meter Display Controls
Use the i/SET controls to display and switch selected items in the Combination Meter
Display located between the tachometer and speedometer. Please refer to your Owner’s
Manual for details on these controls.
3033672_18b_WRX_WRX_STI_QG_051617.indd 105/16/17 2:29 PM