Page 4 of 33
2
Remote Keyless Entry
1. Lock/Arm
• Press to lock all doors and the rear
gate and activate the security alarm.
• If any of the doors or the rear gate are
not fully closed, an electronic chirp
will sound and the hazard lights will
flash to alert you that the doors or the
rear gate are not properly closed.
• To activate the vehicle finder function,
press three times (within five seconds).
If you are within 30 feet of the vehicle,
the horn will sound one time and the
hazard lights will flash three times.
2. Unlock/Disarm
• Press once to unlock the driver’s door.
• Press twice (within five seconds) to
unlock all doors.
• When the “Unlock/Disarm” button
is pressed, the dome and map
lights will illuminate if the dome light
switch is in the middle position.
3. Unlocking the Rear Gate
• Press to unlock the rear gate. An
electronic chirp will sound twice and
the hazard lights will flash twice.
4. Panic Alarm
• Press once and the horn will sound
and the hazard lights will flash.
• Press any button on the remote
to deactivate.
1
23
4
Keyless Access with
Push Button Start System
(if equipped)
By simply carrying the access key in your pocket, you can
lock and unlock doors, open the rear gate and start your car
without ever having to take the key fob out of your pocket.
1
2
3
4
3053393_18b_Crosstrek_QG_071917.indd 27/19/17 3:55 PM
Page 10 of 33
8
Seatbelt warning
Front passenger
seatbelt warning
SRS airbag system
Security indicator light
Door open
Charge warning
Oil pressure warning
Power steering warningBrake system
Hot coolant temperature/
Cold coolant temperature
High beam indicator light
AT OIL TEMP
(Automatic Transmission)
ABS warning
Low fuel
All-Wheel Drive
(Automatic Transmission)
Vehicle Dynamics Control/
Vehicle Dynamics
Control operation
Immediate Attention
Caution
Informational
Gauges - Vehicles without EyeSight
Tachometer Select lever/Gear position indicator
3053393_18b_Crosstrek_QG_071917.indd 87/19/17 3:55 PM
Page 11 of 33
9
Gauges
Vehicle Dynamics Control OFF
CHECK ENGINE/
Malfunction indicator
Tire pressure warning light
Front passenger frontal airbag ON
(Located on overhead console)
Front passenger frontal airbag OFF
(Located on overhead console)
Engine oil level warning light
Windshield washer
fluid warning
Incline start assistKeyless Access with
Push Button Start System
(if equipped)
Turn signals
Front fog light indicator
light (if equipped)
Fuel gauge
Speedometer
Trip meter and odometer
ECO gauge
3053393_18b_Crosstrek_QG_071917.indd 97/19/17 3:55 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 12 of 33
10
Seatbelt warning
Front passenger
seatbelt warning
SRS airbag system
Security indicator light
Door open
Charge warning
Oil pressure warning
Power steering warningBrake system
Hot coolant temperature/
Cold coolant temperature
High beam indicator light
AT OIL TEMP
(Automatic Transmission)
ABS warning
Low fuel
All-Wheel Drive
(Automatic Transmission)
Vehicle Dynamics Control/
Vehicle Dynamics
Control operation
Gauges - Vehicles with EyeSight
Immediate Attention
Caution
Informational
Tachometer Combination meter display
Select lever/Gear position indicator
3053393_18b_Crosstrek_QG_071917.indd 107/19/17 3:55 PM
Page 13 of 33
11
Vehicle Dynamics Control OFF
CHECK ENGINE/
Malfunction indicator
Tire pressure warning light
Front passenger frontal airbag ON
(Located on overhead console)
Front passenger frontal airbag OFF
(Located on overhead console)
Engine oil level warning light
Windshield washer
fluid warning
Incline start assistKeyless Access with
Push Button Start System
(if equipped)
Turn signals
Front fog light indicator
light (if equipped)
Gauges
Fuel gauge Speedometer
Trip meter and odometer
3053393_18b_Crosstrek_QG_071917.indd 117/19/17 3:55 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 15 of 33
13
Personalize
HomeLink® 5 Accessory Mirror (if equipped)
The HomeLink 5 accessory mirror provides three buttons to replace up to three
hand-held radio frequency remotes used to activate devices such as garage
door openers, gate openers, entry door locks, security systems and home \
lighting. Please see your Owner’s Manual for programming instructions or visit
www.subaru.com/homelink to view a how-to video.
Power Moonroof (if equipped)
With the moonroof in the fully closed position, press and hold the switch 1 to tilt
the rear of the moonroof up. Press and hold the switch
2 to lower the moonroof.
Press and hold the switch
3 to fully open the moonroof. Press and hold the switch
4 to close the moonroof. To stop the moonroof in a midway position while opening
or closing, momentarily press the switch to side
3 or side 4.
13
24
3053393_18b_Crosstrek_QG_071917.indd 137/19/17 3:55 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 16 of 33
14
Controls
Light Controls
While the light switch is on, rotate the dial downward to dim the instrument panel illumination.
Rotate the dial upward to make the illumination brighter. When the dial is fully rotated upward,
the instrument panel illumination becomes full bright.
Turns on instrument panel
lights, tail lights, parking lights
and license plate lights.Turns on headlights, instrument
panel illumination, parking lights,
tail lights and license plate lights.
Turns on
fog lights
(if equipped).
Push up
for right
turn signal.
Push down for
left turn signal.AUTO (if equipped): The vehicle’s
lights are automatically on or off,
depending on the level of outside light.
Push forward to change from low
beam to high beam. Pull the lever
back to center to return to low beam.
3053393_18b_Crosstrek_QG_071917.indd 147/19/17 3:55 PM
Page 17 of 33
15
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you.
To operate the rear wiper, rotate the end of the knob upward to the intermittent,
continuous, or wash position. When the rear wiper is off, rotate the knob downward
to wash and wipe the rear window.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only a reduced brightness
high beam will be automatically turned on when the engine has started, the parking
brake is fully released and the light switch is in the “OFF” or “
” position. The
brightness of the illumination of the high beam headlights is reduced by the daytime
running light system. You must always switch on your headlights when it is dark
outside by turning the light switch to the “
” position.
1
2
3
INT.
LOW
HIGH
OFF
Controls
3053393_18b_Crosstrek_QG_071917.indd 157/19/17 3:55 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
