2018 SKODA KAROQ wheel

Adjusting the steering wheel positionFig. 15
Adjusting the steering wheel position

Safety instructionsFig. 22
Safe distance from the steering
wheel and the dashboard
WARNINGGeneral information
vThe seat belts and the airbag system can only offer proper protection
if the driver and passengers are seated properly

Fuel gaugeFig. 32
Fuel gauge: version 1/version 2
The display only works if the ignition is switched on.
The capacity of the fuel tank is approximately 50 litres for vehicles with front- wheel drive, and approximately 55 litres for vehicles with four-wheel drive.
If the fuel level reaches the reserve level
A
, the

The area under the variable loading floor can be used to stow small objects.
The maximum permissible load of the variable loading floor is 75 kg. For the
transport of heavy loads, adjust the variable loading floor in the lower position.
“Parking position”
Fig. 151
Adjustment options for the variable loading floor
For instance, to reach the spare wheel more easily, the variable loading floor
can be set to the “parking position”.

vDo not use the system if snow chains or an emergency wheel are fitted.
vIf wheels other than those approved by

If the position within the lane is changed, the system quickly adapts and holds
the newly-selected position.
Steering wheel vibrations
In the following situations, it may occasionally be the case that due to the
steering wheel vibrations the syst4em indicates that a driver steering interven-
tion is required.

vDo not polish the paintwork in a dusty environment - risk of paint scratch-
es.

v Do not apply any paint care products to door seals or window guides.
v
Plastic parts

v Do not use paint care products.

v
Chromed and anodised parts

v Do not polish the chrome parts in a dusty environment - risk of surface
scratches.

v
Foils
The following instructions must be observed, otherwise there is a risk of foil
damage.

v Do not clean with dirty cloths or sponges.

v To remove ice and snow, do not use a scraper or other means.

v Do not polish the foils

v Do not use a pressure washer to clean the foils

v
Rubber seals

v Do not treat the door seals and window guides with any products - the pro-
tective lacquer layer could be affected.

v
Windows and external mirror glass

v Do not clean the inside of the windows with sharp objects - there is a risk
of damage to the filaments or glass antenna.

v Do not use a cloth, which was used to polish the body - this could soil the
window and reduce visibility.

v
Headlights/lights

v Do not dry off the headlights/lights, do not use sharp objects - there is a
risk of damage to the protective coating and subsequent cracking of the
headlight glass.

v
Reversing camera
The following instructions must be observed, otherwise there is a risk of
camera damage.

v Do not remove snow / ice with warm / hot water.

v To wash, never use a pressure washer or steam jet.

v For cleaning, do not use abrasive cleaners.

v
Door lock cylinder

v Make sure that as little water as possible gets into the locking cylinder
when washing the vehicle - there is a risk of freezing the lock cylinder!

v
Wheels
v Heavy contamination of the wheels can affect the balance of the wheels -
this can result in vibrations and, under some circumstances, can cause pre-
mature wear of the steering wheel.
Removing snow and ice from the windscreensFig. 296
Installation location of the ice
scraper, removing the scraper

Wheels
Wheels and tyres
Advice on tyre/wheel usage
New tyres , during the first 500 km, new tyres do not offer optimum grip and
appropriate care should therefore be taken when driving.
Always fit tyres with a greater profile depth on the front wheels.
Wheels and bolts are matched to each other in terms of design. We recom-
mend that you use wheel rims and wheel bolts from