2018 Seat Toledo light

Emergencies
Changing the fog light bulbs Fr ont f
og light bulb Fig. 96
Fog light: remove the grille Fig. 97
Fog light: detach the bulb holder

Fuses and bulbs
Fig. 105
Remove the bulb holder. The rear lid must be open to change the
bulbs.
Y
ou can access the bulb hol
der f
or the inner
tail lights through the inside of the rear lid.

Emergencies
Note
Check the condition of the seal. If dam-
aged, a repl acement can be acquir
ed from
an Official Service. Changing the side and num-
ber plat
e bulbs
Side t

urn signals Fig. 107
Turn signal integrated in the rear view
mirr or The side turn signals are LEDS and are inte-
gr
at
ed in the e

xterior mirrors.
In case of failure, go to an authorised work-
shop to have them replaced. Changing the bulb on the number
plate
Fig. 108
Removing number plate light Fig. 109
Changing the bulb. Removing the bulb holder

Operation
If an obstacle is present, the closing mecha-
nism will st op and the windo
w will r
oll back a
few centimetres.
If an obstacle prevents closing for the next 10
seconds, the closing mechanism will once
again stop and the window will roll back an-
other few centimetres.
If in the next 10 seconds you attempt to close
the window after it has rolled back the sec-
ond time, only the closing mechanism will be
stopped even if the obstacle is still present.
The roll-back function is still connected.
The roll-back function will only be disconnec-
ted if you once again attempt to close the
window in the following 10 seconds. In this
case, the window will close at full force.
If you wait for a further 10 seconds, the roll-
back function will be once again connected. Lights and visibility
Lights Intr oduction Read the additional information carefully

Lights and visibility

It lights up
Main beam on or flasher on

Lights and visibility
long as you hold the lever, e.g. when chang-
ing l anes.
Conv enience t
urn signals
For the convenience turn signals, move the
lever as far as possible upwards or down-
wards and release the lever. The turn signal
will flash three times.
The convenience turn signals are activated
and deactivated in the Easy Connect system
via the  button and the
SETTINGS function
butt on

Operation
Fog lights* Fig. 132
Instrument panel: light panel. Switching on front fog lights

Lights and visibility
The light is adjusted according to the data re-
cor ded by the light sensor that is inst
all
ed be-
tween the windscreen and the inside rear
view mirror.
The function automatically turns on the side
lights and headlights, the lighting for the en-
try area on the exterior mirrors and the num-
ber plate light.
“Coming Home” function
The light is automatically switched on when
the driver door is opened (for 60 seconds af-
ter the ignition is switched off).
The light is switched off when all the doors
and the rear lid are closed.
If a door or the rear lid remains open, the light
will switch off after 60 seconds.
“Leaving Home” function
The light is automatically switched on when
the vehicle is unlocked using the remote con-
trol.
The light is switched off after 10 seconds or
when the vehicle is locked. Hazard warning lights switch
Fig. 133
Instrument panel: switch for hazard
w arning lights.