2018 RENAULT KANGOO Z.E. rims

1.6
The engine brake should
under no circumstances be
used as a substitute for the
brake pedal.
ELECTRIC VEHICLE: introduction (5/6)
Driving
As with a car with an automatic gear-
box, you will have to get used to not
using your left foot, and not using this
foot to brake.
When driving, if you lift your foot off the
accelerator pedal or depress the brake
pedal, the motor generates electrical
current during deceleration, and this
energy is used to brake the vehicle and
recharge the traction battery. Please
refer to the information on the “Charge
meter” in Section 2.
Special conditions
After a maximum charge of the battery
and during the first few miles of using
the vehicle, the engine brake will be
temporarily reduced. Please adapt your
driving style appropriately. Bad weather, flooded roads:Do not drive through
floods if the depth of water
is above the lower edge of
the wheel rims.
Obstructions to the driver
On the driver’s side, only
use mats suitable for the
vehicle, attached with the
pre-fitted components, and check
the fitting regularly. Do not lay one
mat on top of another.
There is a risk of wedging the
pedals

5.6
Remove tools or, depending on the ve-
hicle, the tool kit.
To remove the tool kit 1 from the lug-
gage compartment
Depending on the vehicle, it may be
stored behind a flap. Open it. Undo
wheel 2 and pull the tool kit towards
you.
To reposition the tool kit position tool
kit pin 4 into housing 3. Make sure the
kit is correctly positioned so as to be
able to tighten wheel 2.
The tools included in the tool kit depend
on the vehicle.
TOOL KIT
1
3
2
4
Do not leave the tools unse-
cured inside the vehicle as
they may come loose under
braking. After use, check
that the tools are correctly clipped
into the vehicle or, depending on the
vehicle, into the tool kit, then posi-
tion it correctly in its housing: risk of
injury.
If wheel bolts are supplied in the tool
kit, you must use these bolts only for
the emergency spare wheel: refer to
the label affixed to the emergency
spare wheel.
The jack is designed for wheel
changing purposes only. Under no
circumstances should it be used for
carrying out repairs underneath the
vehicle or to gain access to the un-
derside of the vehicle.
Jack 9
Refer to Section 5 “Changing a wheel”.
Retaining belt (depending on vehicle)
After use, reposition it, making sure that
it retains all components in the tool kit.
5
67
89
Hubcap tool 5
To remove the wheel trims.
Guide bolt 6 (depending on vehicle)
To finish loosening or starting to tighten
the wheel bolts.
Tow eye 7 Refer to the information on the “Towing:
breakdown” in Section 5.
Wheel brace 8
To undo the wheel bolt and the emer-
gency spare wheel cage nut.

5.10
TYRES (1/3)Maintaining the tyres
The tyres must be in good condition
and the tread form must have sufficient
depth; tyres approved by our Technical
Department have tread wear indica-
tors 1 which are indicators moulded
into the tread at several points .
The tyres are the only contact between
the vehicle and the road, so it is essen-
tial to keep them in good condition.
You must make sure that your tyres
conform to local road traffic regulations.
When the tyre tread has been eroded
to the level of the warning strips, they
become visible 2: it is then necessary
to replace your tyres because the tread
profile is no more than 1.6
mm deep
and this causes poor road holding
on wet roads.
An overloaded vehicle, long journeys
by motorway, particularly in very hot
weather, or continual driving on poorly
surfaced minor roads will lead to more
rapid tyre wear and affect safety.
Incidents which occur when
driving, such as striking the
kerb, may damage the tyres
and wheel rims, and could
also lead to misalignment of the
front or rear axle geometry. In this
case, have the condition of these
checked by an approved dealer.
1
2

7.5
ALPHABETICAL INDEX (5/5)
transporting objectsin the luggage compartment ............................. 3.25 – 3.26
trims ..................................................................\
................... 5.7
trip computer and warning system... 1.66 → 1.68, 1.74 → 1.80
tyre inflation kit...........................................................5.3 → 5.5
tyre pressure................................................... 2.11 → 2.14, 4.8
tyre pressure loss warning..................................... 2.11 → 2.14
tyre pressures ........................................4.8 – 4.9, 5.10 → 5.12
tyres .......................................... 2.11 → 2.14, 4.8, 5.10 → 5.12
U
unlocking the doors ................................................ 1.26 – 1.27
V
vehicle identification ............................................................ 6.2
vehicle identification plates .................................................. 6.2
vehicle range .............................................................2.6 → 2.9
ventilation ..............................................3.2 → 3.9, 3.12 – 3.13
W
warning lights............................1.66 → 1.68, 1.72 – 1.73, 1.79
washing ................................................................\
.4.10 → 4.12
weights ................................................................\
................ 6.6
wheelbrace .............................................................\
............. 5.6
wheels (safety) .................................................................. 5.10
windscreen de-icing/demisting ............................................ 3.5
windscreen washer .........................................1.90 → 1.92, 4.5
windscreen washer/wiper replacing blades ................................................ 5.23 – 5.24
wiper blades ........................................................... 5.23 – 5.24
wipers .................................................................\
...1.90 → 1.92