5. Remove the lug nuts and pull the wheel off. On singlerear-wheel (SRW) trucks, install the spare wheel and lug
nuts with the cone shaped end of the wheel nuts toward
the wheel. On 3500 dual rear-wheel models (DRW)
trucks, if the outer tire is being replaced then leave the
inner wheel on the vehicle. If the inner wheel is being
replaced remove the outer wheel and replace the inner
wheel. The wheel nuts are a two-piece assembly with a
flat face. Lightly tighten the lug nuts. To avoid the risk of
forcing the vehicle off the jack, do not fully tighten the
lug nuts until the vehicle has been lowered.
6. Finish tightening the lug nuts. Push down on the lugwrench while at the end of the handle for increased
leverage. Tighten the lug nuts in a star pattern until each
nut has been tightened twice. For the correct lug nut
torque refer to “Torque Specifications” in “Technical
Specifications”. If in doubt about the correct tightness,
have them checked with a torque wrench by an autho-
rized dealer or service station.
Rear Inner Wheel Proper Placement
(Dual Rear Wheel Equipped)
Dual Rear Wheel Jack Placement
496 IN CASE OF EMERGENCY
WARNING!(Continued)
in a tightly closed container. Keep the master cylin-
der reservoir cap secured at all times. Brake fluid in
a open container absorbs moisture from the air
resulting in a lower boiling point. This may cause it
to boil unexpectedly during hard or prolonged brak-
ing, resulting in sudden brake failure. This could
result in a collision.
• Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts, causing the
brake fluid to catch fire. Brake fluid can also damage
painted and vinyl surfaces, care should be taken to
avoid its contact with these surfaces.
• Do not allow petroleum based fluid to contaminate
the brake fluid. Brake seal components could be
damaged, causing partial or complete brake failure.
This could result in a collision.
Automatic Transmission
Selection Of Lubricant
It is important to use the proper transmission fluid to
ensure optimum transmission performance and life. Use
only the manufacturer ’s specified transmission fluid. Refer
to “Fluids And Lubricants” in “Technical Specifications”. It is important to maintain the transmission fluid at the
correct level using the recommended fluid. No chemical
flushes should be used in any transmission; only the
approved lubricant should be used.
CAUTION!
Using a transmission fluid other than the manufactur-
er ’s recommended fluid may cause deterioration in
transmission shift quality and/or torque converter
shudder, and will require more frequent fluid and
filter changes. Refer to “Fluids And Lubricants” in
“Technical Specifications” for fluid specifications.
Special Additives
The manufacturer strongly recommends against using any
special additives in the transmission. Automatic Transmis-
sion Fluid (ATF) is an engineered product and its perfor-
mance may be impaired by supplemental additives. There-
fore, do not add any fluid additives to the transmission.
The only exception to this policy is the use of special dyes
for diagnosing fluid leaks in six-speed transmissions.
Avoid using transmission sealers as they may adversely
affect seals.
8
SERVICING AND MAINTENANCE 553
TECHNICAL SPECIFICATIONS
CONTENTS
IDENTIFICATION DATA ...................593
▫ Vehicle Identification Number .............593
BRAKE SYSTEM ........................593
▫ Hydraulic Brake Assist — 2500/3500 Models Only
(Except Power Wagon) ...................593
WHEEL AND TIRE TORQUE SPECIFICATIONS . .594
▫ Torque Specifications ....................594
FUEL REQUIREMENTS ...................596
▫ 3.6L Engine .......................... .596
▫ 5.7L Engine .......................... .596
▫ 6.4L Engine .......................... .597
▫ Reformulated Gasoline ..................597
▫ Materials Added To Fuel .................597
▫ Gasoline/Oxygenate Blends ...............598 ▫
Do Not Use E-85 In Non-Flex Fuel Vehicles . . . .598
▫ CNG And LP Fuel System Modifications ......599
▫ MMT In Gasoline .......................599
▫ Fuel System Cautions ....................599
▫ Carbon Monoxide Warnings ...............600
FLEXIBLE FUEL (3.6L ENGINE ONLY) ........600
▫ E-85 General Information .................600
▫ Ethanol Fuel (E-85) ..................... .600
▫ Fuel Requirements .....................601
▫ Selection Of Engine Oil For Flexible Fuel Vehicles
(E-85) And Gasoline Vehicles ..............601
▫ Starting ............................ .602
▫ Cruising Range ........................602
▫ Replacement Parts ..................... .602
9
WHEEL AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to ensure that
the wheel is properly mounted to the vehicle. Any time a
wheel has been removed and reinstalled on the vehicle, the
lug nuts/bolts should be torqued using a properly cali-
brated torque wrench using a high quality six sided (hex)
deep wall socket.
Torque Specifications
Lug Nut/
Bolt Torque Lug Nut/
Bolt Type **Lug Nut/
Bolt Size Lug Nut/
Bolt Socket Size
130 Ft-Lbs (176 N·m) Cone M14 x 1.50 22 mm
140 Ft-Lbs (190 N·m) Flanged
**Use only your authorized dealer recommended lug nuts/
bolts and clean or remove any dirt or oil before tightening. NOTE:
Dual wheels are flat mounted, center piloted. The
lug nuts are a two-piece assembly. When the tires are being
rotated or replaced, clean these lug nuts and add two drops
of oil at the interface between the lug nut/bolt and the
washer. Do not oil wheel studs.
Two-Piece Lug Nut
594 TECHNICAL SPECIFICATIONS
Inspect the wheel mounting surface prior to mounting the
tire and remove any corrosion or loose particles.
Tighten the lug nuts/bolts in a star pattern until each
nut/bolt has been tightened twice. Ensure that the socket is
fully engaged on the lug nut/bolt (do not insert it half-
way).
After 25 miles (40 km), check the lug nut/bolt torque to be
sure that all the lug nuts/bolts are properly seated against
the wheel.
WARNING!
To avoid the risk of forcing the vehicle off the jack, do
not tighten the lug nuts fully until the vehicle has been
lowered. Failure to follow this warning may result in
personal injury.Wheel Mounting Surface
Four And Five Lug Nuts/Bolts Torque Pattern
9
TECHNICAL SPECIFICATIONS 595
Steering Wheel Audio Controls.................653
Steering Wheel Mounted Sound System Controls . . . .653
Storage Compartment, Center Seat ..............123
Storage, Vehicle ........................105, 584
Storing Your Vehicle ........................584
Sun Roof .................................110
Suspension, Air ........................344, 350
Sway Control, Trailer ........................213
Synthetic Engine Oil ........................530
Tailgate .................................153
Telescoping Steering Column ...................61
Temperature Control, Automatic (ATC) ...........104
Tilt Down ...............................47, 49
Up .................................47, 49
Tilt Steering Column .........................61
Tip Start .................................289
Tire And Loading Information Placard ............564
Tire Markings ............................ .558
Tires......................... .281, 568, 575, 583
Aging (Life Of Tires) ..................... .572
Air Pressure ............................568
Chains ............................... .579
Changing ............................. .468Compact Spare
..........................575
Dual ............................. .582, 594
General Information ...................568, 575
High Speed ............................ .570
Inflation Pressures ........................569
Jacking ............................... .468
Life Of Tires ............................572
Load Capacity .......................564, 565
Pressure Monitor System (TPMS) .............216
Pressure Warning Light ....................194
Quality Grading ........................ .583
Radial ............................... .570
Replacement ............................573
Rotation ...............................580
Safety ............................ .558,568
Sizes .................................560
Snow
Tires ............................ .575
Spare Tire ..........................575, 577
Spinning ...............................571
Trailer Towing .......................... .425
Tread Wear Indicators .....................572
Wheel Nut Torque ........................594
Tire Safety Information .......................558
Tongue Weight/Trailer Weight .................423
694 INDEX
Tonneau Cover............................585
Tonneau Cover Cleaning .....................585
To Open Hood ............................112
Torque Converter Clutch ..................315, 323
Towing ............................. .416, 510
Disabled Vehicle ........................ .510
Guide .................................423
Recreational ............................436
Weight ............................... .423
Towing Vehicle Behind A Motorhome ............436
Traction .................................441
Traction Control .......................... .209
Trailer Sway Control (TSC) ....................213
Trailer Towing ............................ .416
Cooling System Tips ..................... .432
Hitches ............................... .422
Minimum Requirements ....................424
Mirrors ................................70
Tips ................................. .431
Trailer And Tongue Weight ..................423
Wiring ............................... .430
Trailer Towing Guide ........................423
Trailer Weight ............................ .423Transfer Case
............................ .557
Electronically Shifted ............327, 332, 336, 339
Fluid .................................607
Transmission ............................. .299
Automatic ....................299, 306, 315, 553
Fluid .................................607
Maintenance ............................553
Shifting ...............................297
Transporting Pets ..........................278
Tread Wear Indicators .......................572
Turn Signals .....................78, 198, 454, 456
Uconnect Customer Programmable Features .........623,644
Uconnect
Settings ........................613
Uconnect Settings .....................623, 644
Uconnect Settings Customer Programmable Features .......39, 621, 641
Passive Entry Programming ...........39, 621, 641
Uconnect Settings .....................621, 641
Uconnect Voice Command ....................656
Uniform Tire Quality Grades ..................583
12
INDEX 695