2018 Peugeot 208 ECO mode

3
.
bit.ly/helpPSA
.
Driving advice 80
Starting – Switching off the engine 8 1
Parking brake

8
2
Manual gearbox
8

3
Automatic gearbox (EAT6)

8
4
Gear shift indicator

8
6
Hill start assist

87
S

top & Start
87
U

nder-inflation detection
8
9
Speed limiter

9
1
Cruise control

9
3
Memorising speeds

9
5
Active City Brake

9
6
Parking sensors

9
8
Reversing camera
1

00
Park Assist

1
00Compatibility of fuels 1
06
Fuel tank 1 07
Misfuel prevention (Diesel)
1

08
Snow chains

1
08
Towing device

1
09
Load reduction mode

1
09
Energy economy mode
1

10
Fitting roof bars

1
10
B o n n e t


111
Engine


112
Checking levels

1
12
C h e c k s


114
AdBlue
® (BlueHDi engines) 1 17
Warning triangle
1
21
Running out of fuel (Diesel)

1
21
Temporary puncture repair kit
1

22
Spare wheel

1
25
Changing a
bulb
1
29
Changing a


fuse
1
33
12

V battery
1
37
To w i n g


14 0Engine technical data and towed loads

1
42
Engines and towed loads - PETROL
1
43
Engines and towed loads - DIESEL
1
45
Dimensions
1
47
Identification markings
1
48
Driving
Practical information
In the event of a breakdown Technical data
Alphabetical index
Access to additional videos
Audio equipment and telematics
Audio system
Bluetooth audio system
PEUGEOT Connect Radio
PEUGEOT Connect Nav
.
Contents

6
As a passenger, if you avoid connecting your
m ultimedia devices (film, music, video game,
etc.), you will contribute towards limiting the
consumption of electrical energy, and so of
fuel.
Disconnect your portable devices before
leaving the vehicle.
Eco- driving
Optimise the use of your
gearbox
With a manual gearbox, move off gently
a nd change up without waiting. When
accelerating, change up early.
With an automatic gearbox, give preference
to automatic mode and avoid pressing the
accelerator pedal heavily or suddenly.
The gear shift indicator invites you to engage
the most suitable gear: as soon as the
indication is displayed in the instrument panel,
follow it straight away.
For vehicles fitted with an automatic gearbox,
this indicator appears only in manual mode.
Drive smoothly
Maintain a safe distance between vehicles,
u se engine braking rather than the
brake pedal, and press the accelerator
progressively. These practices contribute
towards a
reduction in fuel consumption and
CO
2 emissions and also help reduce the
b
ackground traffic noise.
If your vehicle has cruise control, make use of
the system at speeds above 25
mph (40 km/h)
when the traffic is flowing well.
Control the use of your electrical
equipment
Before moving off, if the passenger
compartment is too warm, ventilate it by
opening the windows and air vents before
using the air conditioning.
Above 31
mph (50 km/h), close the windows
and leave the air vents open.
Consider using equipment that can help
keep the temperature in the passenger
compartment down (sunroof blind and window
blinds, etc.). Switch off the headlamps and front foglamps
when the ambient light level does not require
their use.
Avoid running the engine before moving off,
particularly in winter; your vehicle will warm up
much faster while driving. Switch off the air conditioning, unless it has
automatic regulation, as soon as the desired
temperature is attained.
Switch off the demisting and defrosting
controls when not required, if they are not
automatically controlled.
Switch off the heated seat as soon as
possible.
Eco-driving is a

range of everyday practices that allow the motorist to optimise their fuel consumption and CO
2 emissions.
Eco-driving

9
Trip distance recorder (miles
o r k m).
Engine oil level indicator
(depending on version).
Gear shift indicator with
a

manual gearbox.
Selector position and gear
with an automatic gearbox.
Digital speedometer (mph or
km/h).
Displaying/hiding the digital speedometer
(Depending on version)
Cruise control settings.
Speed limiter settings.
Service indicator.
Total distance recorder (miles
o r k m). Hold this button down.
"- -" or "0" is displayed.
Press this button to display or
hide the digital speedometer.Displays
Trip computer
Stop & Start time counter.
Remaining driving range.
Current or average fuel consumption.
Average speed of the vehicle.
Distance travelled by the vehicle.
Gearbox
Park.
Reverse.
Neutral.
Automatic mode (Drive).
Sequential mode.
Change up/down a


gear.
1
Instruments

26
This function is only displayed from
19 mph (30 km/h).
Average fuel consumption
(mpg or l/100 km or km/l)
C alculated since the last trip computer
reset.
Distance travelled
(miles or km)
Calculated since the last trip computer
reset.
Average speed
(mph or km/h) Calculated since the last trip
computer reset.
Total time in stop mode
(minutes/seconds or hours/minutes)
If your vehicle is fitted with Stop & Start, a time
counter adds up the time spent in STOP mode
during a

journey.
It resets to zero every time the ignition is
switched on.
Setting the time and date
Instrument panel
F Each press of this button toggles between the following settings:
-


h o u r,
-


minutes,
-

1
2 or 24 hour format.
With PEUGEOT Connect
Radio
F Select the Settings menu in
the upper banner of the touch
screen.
F

Sel

ect " System configuration ".
F

Sel
ect "Date and time ".
F

Sel

ect " Date " or "Time ".
F

C

hoose the display formats.
F

C

hange the date and/or time using the
numeric keypad.
F

C

onfirm with " OK".
With PEUGEOT Connect
Nav
Setting of the time and date is only available if
synchronisation with the GPS is deactivated.
F

Sel
ect the "Settings " menu.
F

P
ress the " OPTIONS " button to go to the
secondary page.
F

Sel
ect "Setting the time- date".
F

Sel
ect the " Date" or " Time" tab.
F

A
djust the date and time using the numeric
keypad and confirm.
F

I
n the selected tab, press this
key to confirm.
Additional settings
You can choose:
- T o change the date format (DD/MM/ Y Y Y Y,
YYYY/MM/DD, etc.)
-

T
o change the time format (12h/24h).
-

T
o change the time zone.
-

T
o activate or deactivate synchronisation
with the GPS (UTC).
Instruments

44
AUTO mode
F Press the "AUTO" button 6 su c c e s s i ve l y.
The active mode appears in the display screen,
as described below: Provides soft and quiet operation by
limiting air flow.
Offers the best compromise between
a
comfortable temperature and quiet
operation.
Provides dynamic and effective air
f low.
When the engine is cold, the air flow will
only reach its optimum level gradually
to prevent too much cold air being
distributed.
In cold weather, it favours the distribution
of warm air to the windscreen, the side
windows and the footwells only.
Manual mode
If you wish, you can make a different choice
f rom that offered by the system by changing
a
setting. The other functions will still be
automatically managed.
When you modify a
setting, the indicator lamp
in the button 6
goes off. F

P
ress the button 6 again to return to the
automatic comfort programme.
Visibility programme
For information on how to use the visibility
programme 7 , refer to the corresponding
section in " Front demisting – defrosting ".
Temperature
The driver and front passenger can each set
the temperature individually.
The value shown on the display is a
level
of comfort, not a
temperature in Celsius or
Fahrenheit.
F

P
ush the button 1 down (blue) to reduce the
value or up (red) to increase it.
A setting of around 21
provides optimum
comfort. Depending on your requirements, a
setting between 18
and 24 is normal.
It is also recommended to avoid a
left /right
setting difference of more than 3.
For maximum cooling or heating of the
passenger compartment, it is possible
to exceed the minimum value 14
or the
maximum value 28.
F

P
ush the button 1 down until "LO" is
displayed or up until " HI" is displayed. On entering the vehicle, if the interior
temperature is much colder or warmer
than the comfort value setting, there is no
need to alter the value displayed in order
to reach the required level of comfort. The
system compensates automatically and
corrects the temperature difference as
quickly as possible.Air conditioning
With the engine running, the air conditioning is
designed to operate effectively in all seasons,
with the windows closed.
It allows you:
-

i
n summer, to lower the temperature,
-

t
o increase the effectiveness of the
demisting in winter, above 3°C.
On/Off
F Press button 5 to activate/deactivate the air
conditioning system.
To cool the air more quickly, you can use
interior air recirculation for a
few moments by
pressing button 4 . Then return to the intake of
exterior air.
The air conditioning does not operate
when the air flow adjustment control 2
is in
position " 0".
Ease of use and comfort

47
Map reading lamps
Interior ambient lighting
Switching on
At night, panoramic sunroof light-emitting
diodes (LEDs) come on automatically when the
sidelamps are switched on.
It switches off gradually:
-

w

hen the vehicle is locked,
-

w

hen the ignition is switched on,
-

3

0

seconds after the last door is closed.
Permanently off.
Permanent lighting.
In "permanent lighting" mode, the lighting
time varies according to the circumstances:
-
w
hen the ignition is off, approximately
ten minutes,
-

i
n energy economy mode,
approximately 30


seconds,
-
w

ith the engine running, unlimited.
F With the ignition on, press the corresponding switch.
Take care not to put anything in contact
with the courtesy lamp.
Switching off
The interior ambient lighting switches off
automatically when the sidelamps are switched
of f. The interior ambient lighting can be
configured in the Driving/Vehicle
menu.
Sunroof blind
Opening
F Take the blind by its handle and push it rearward to the desired position.
3
Ease of use and comfort

51
Lighting control stalk
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a few minutes.
Travelling abroad
If planning to use your vehicle in a
country
that drives on the other side of the road,
the dipped beam headlamps must be
adjusted to avoid dazzling oncoming
drivers. Contact a
PEUGEOT dealer or
a


qualified workshop.
Selection of main lighting
mode
Lighting off (ignition off)/Front daytime
running lamps (engine running).
Sidelamps only.
Dipped or main beam headlamps.
Automatic illumination of headlamps.
Headlamp dipping
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining
a pull on the stalk.
Display
Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
lighting selected is on.
Foglamps
The foglamps operate with dipped or main
beam headlamps on.
Turn the ring to align the desired symbol with
the marking. Pull the stalk to switch between dipped and
main beam headlamps.
Rear foglamp only
F To switch it on, turn the ring for wards.
When the lighting is switched off automatically
(version with AUTO lighting), the foglamp and
the dipped beam headlamps will remain on.
F

T
o switch it off, turn the ring rear wards.
Front foglamps and rear foglamp
Rotate and release the ring:
F o nce for wards to switch on the front
foglamps,
F

f
or wards a second time to switch on the rear
foglamp,
F

o
nce rear wards to switch off the rear
foglamp,
F

r
ear wards a second time to switch off the
front foglamps.
4
Lighting and visibility

86
If the lever is not in position P, an alert
message appears on the screen on
opening the driver's door or approximately
45
seconds after switching off the ignition.
F

R
eposition the lever at position P ; the
message disappears.
When driving on flooded roads or when
crossing a
ford, proceed at walking pace.
When the ignition is on, the lighting
of this warning lamp, accompanied
by an audible signal and a
message
on the screen, indicates a
gearbox
fault.
In this case, the gearbox goes into back-up
mode by staying in 3rd gear. You may feel
a

substantial jolt when changing from P to
R and from N to R . This will not cause any
damage to the gearbox.
Do not exceed 62
mph (100 km/h), local speed
restrictions permitting.
Contact a
PEUGEOT dealer or a qualified
workshop as soon as possible. There is a
risk of damage to the gearbox:
F i f you press the accelerator and brake
pedals at the same time,
F

w
ith a flat battery, if you force the
movement of the lever from position P
to another position.
To reduce fuel consumption during
prolonged stops with the engine running
(e.g. traffic jam), position the gear lever at
N and apply the parking brake.
Gear shift indicator
(Depending on engine.)
System which reduces fuel consumption by
recommending the most appropriate gear.
Operation
Depending on the driving situation and your
vehicle's equipment, the system may advise
you to skip one or more gears. You can
follow this indication without engaging the
intermediate gears.
Gear shift recommendations must not be
considered as compulsory. In fact, the road
layout, the traffic density and safety remain the
deciding factors when choosing the best gear. With an automatic gearbox, the system is
only active in manual operation.
The information appears in the
instrument panel, in the form of an
ascending or descending arrow and
the recommended gear.
The system adapts its gear shift
recommendation according to the driving
conditions (slope, load, etc.) and the
driver's requirements (power, acceleration,
b r a k i n g , e t c .) .
The system never suggests:
-
e
ngaging first gear,
-
enga
ging reverse.
On vehicles fitted with a manual gearbox,
the arrow may be accompanied by the
gear recommended. The system always
recommends to change up if necessary.
Depending on the engine, it may also
recommend to change down if necessary.
The driver therefore remains responsible for
deciding whether or not to follow the indications
issued by the system.
This function cannot be deactivated.
Driving