2018 NISSAN VERSA SEDAN check engine

[x] Cancel search: check engine

Page 277 of 702

NISSAN VERSA SEDAN 2018  Owner´s Manual 1. Water pump pulley
2. Generator pulley
3. Manual tensioner pulley
4. Air conditioner compressor pulley
5. Crankshaf t pulley
WARNING
Be sure the ignition switch is placed in
the OFF or LOCK position

Page 281 of 702

NISSAN VERSA SEDAN 2018  Owner´s Manual If any electrical equipment does not oper-
ate, check for an open fuse.
Fuses are used in the passenger compart-
ment. Spare fuses are provided and can be
found in the passenger compartment fuse
box.

Page 305 of 702

NISSAN VERSA SEDAN 2018  Owner´s Manual Some day-to-day and regular mainte-
nance is essential to maintain your vehicle
good mechanical condition, as well as its
emissions and engine performance.
It is the owner’s responsibility to make s

Page 307 of 702

NISSAN VERSA SEDAN 2018  Owner´s Manual Seats:Check seat position controls such
as seat adjusters, seatback recliner, etc., to
ensure they operate smoothly and all
latches lock securely in every position.
Check that the head restraints/head

Page 308 of 702

NISSAN VERSA SEDAN 2018  Owner´s Manual Radiator and hoses:Check the front of the
radiator and clean off any dirt, insects,
leaves, etc., that may have accumulated.
Make sure the hoses have no cracks, defor-
mation, rot or loose connections

Page 309 of 702

NISSAN VERSA SEDAN 2018  Owner´s Manual Engine coolant*:Replace coolant at the
specified interval. When adding or replac-
ing coolant, be sure to use only Genuine
NISSAN Long Life Antifreeze/Coolant (blue)
or equivalent with the proper mixt

Page 325 of 702

NISSAN VERSA SEDAN 2018  Owner´s Manual spark knock even when using gasoline
of the stated octane rating, or if you hear
steady spark knock while holding a
steady speed on level roads, it is recom-
mended that you have a NISSAN dealer
corre

Page 339 of 702

NISSAN VERSA SEDAN 2018  Owner´s Manual Due to legal requirements in some states
and Canadian Provinces, your vehicle may
be required to be in what is called the
“ready condition” for an
Inspection/Maintenance (I/M) test of the
emission