The following are displayed on the Energy
Flow screen:∙ When the vehicle is powered only by the electric motor
Aor gasoline engineE
∙ When the vehicle is powered by boththe electric motor and the gasoline en-
gine
B
∙ When the vehicle is charging the Li-ionbattery with the regenerative brake
D
or gasoline engineH
∙ When the vehicle is charging the Li-ionbattery with the regenerative brake and
gasoline engine
C
∙ When the vehicle is powered by thegasoline engine and is charging the Li-
ion battery
G
∙ When there is no Energy Flow in thevehicle
F
*Remaining capacity of Li-ion battery
The Energy Flow and remaining Li-ion bat-
tery charge can also be shown on the ve-
hicle information display. For additional in-
formation, refer to “Vehicle information
display” in the “Instruments and controls”
section of this manual.
LHV2062
HEV-8HEV Overview
NISSAN INTELLIGENT KEY®
Replace the battery in the Intelligent Key as
follows:1. Remove the mechanical key from the Intelligent Key.
2. Insert a small screwdriver
Ainto the
slit
Bof the corner and twist it to sepa-
rate the upper part from the lower part.
Use a cloth to protect the casing.
3. Replace the battery with a new one. Recommended battery: CR2032 or
equivalent.
∙ Do not touch the internal circuit andelectric terminals as doing so could
cause a malfunction.
∙ Hold the battery by the edges. Hold- ing the battery across the contact
points will seriously deplete the stor-
age capacity.
∙ Make sure that the + side faces the bottom of the case. 4. Close the lid securely as illustrated with
CandD.
5. Operate the buttons to check the op- eration.
It is recommended that you visit a NISSAN
dealer for this service if you need assis-
tance for replacement. FCC Notice:
For USA:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Note: Changes or modifications not ex-
pressly approved by the party respon-
sible for compliance could void the user’s
authority to operate the equipment.
For Canada:
This device complies with Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must ac-
cept any interference, including interfer-
ence that may cause undesired opera-
tion of the device.
WDI0568
8-22Do-it-yourself
