2018 NISSAN MAXIMA PLATINUM sensor

[x] Cancel search: sensor

Page 64 of 428

NISSAN MAXIMA PLATINUM 2018  Owners Manual WARNING
∙ The front air bags ordinarily will notinflate in the event of a side impact,
rear impact, rollover, or lower severity
frontal collision. Always wear your
seat belts to help reduce the risk

Page 70 of 428

NISSAN MAXIMA PLATINUM 2018  Owners Manual 5. Supplemental front-impact air bagmodules
6. Crash zone sensor
7. Occupant classification system control unit
8. Occupant classification sensor (weight sensor)
9. Seat belt buckle switches for drive

Page 77 of 428

NISSAN MAXIMA PLATINUM 2018  Owners Manual ∙ Modif ying or tampering with the frontpassenger seat may result in serious
personal injury. For example, do not
change the front seats by placing ma-
terial on the seat cushion or by install-
ing

Page 82 of 428

NISSAN MAXIMA PLATINUM 2018  Owners Manual ∙ If there is an impact to your vehiclefrom any direction, your Occupant
Classification Sensor (OCS) should be
checked to verif y it is still functioning
correctly. It is recommended that you
visit

Page 128 of 428

NISSAN MAXIMA PLATINUM 2018  Owners Manual RAIN-SENSING AUTO WIPER
SYSTEM (if so equipped)
The rain-sensing auto wiper system can
automatically turn on the wipers and ad-
just the wiper speed depending on the
rainfall by using the rain sensor

Page 131 of 428

NISSAN MAXIMA PLATINUM 2018  Owners Manual Be sure you do not put anything on top
of the autolight sensor located in the top
side of the instrument panel. The auto-
light sensor controls the autolight; if it is
covered, the autolight sensor re

Page 231 of 428

NISSAN MAXIMA PLATINUM 2018  Owners Manual ∙ When replacing a wheel without theTPMS such as the spare tire, when a
spare tire is mounted or a wheel is
replaced, tire pressure will not be indi-
cated, the TPMS will not function and
the low ti

Page 232 of 428

NISSAN MAXIMA PLATINUM 2018  Owners Manual Vehicle set-up1. Park the vehicle in a safe and level place.
2. Apply the parking brake and place the shif t lever in the P (Park) position.
3. Place the ignition switch in the ON po- sition. Do not s
Page:   1-8 9-16 17-24 next >