2018 MITSUBISHI OUTLANDER SPORT window

5CONTROLS
WINDSHIELD WIPERS
The wipers will operate once.
INT: Intermittent intervals can be adjusted
by turning the knob
.
AUTO: The wipers will be operated
automatically by rain sensor (if equipped).
Slow
Fast
RAIN SENSING WIPERS (IF EQUIPPED)
Turn the knob to operate the rear
window wiper.
The wiper operates continuously for several
seconds then operates intermittently at
intervals of about 8 seconds.
Washer fluid is sprayed, the wiper will
automatically operate 2 or 3 times.

6
SEAT HEATER SWITCH (IF EQUIPPED)POSITION ACTION
HI For quick heating
NEUTRAL Heater off
LO Keeps seat warm
- Turn for temperature control.
- Push to select outside air (Indicator light off) or recirculated air
(Indicator light on).
- Turn to select the blower speed. To the right increases blower speed. To
the left decreases blower speed. Turned all the way to the left turns the
blower off. Note: OFF is located above AUTO.
- Push for air conditioning ON/OFF (Indicator light on/Indicator light off).
- Turn to select the air flow and direction mode.
- Push to defog the rear window (Indicator light on). Rear window
defogger light automatically turns off after 20 minutes.
TO DEFOG FRONT WINDSHIELD (FOR BOTH AUTOMATIC AND MANUAL)
1. Set the Mode Dial
to defrost position.
2. Set the blower speed
to the maximum position.
3. Set the temperature
to the highest position.
PANORAMIC SUNSHADE (IF EQUIPPED)
The sunshade can be operated with
the ignition switch or the operation
mode in ON.
- Push the switch in the arrow direction to close the sunshade.
Pushing the switch all the way automatically closes the sunshade
completely.
- Push the switch up to stop the moving sunshade. If an object
obstructs the sunshade from closing, the safety mechanism
will cause the sunshade to re-open automatically. The opened
sunshade will become operational again after a few seconds.
- The sunshade illumination turns on with the ignition switch or
when the operation mode is in ON or ACC.
• Push the switch to change brightness of the sunshade
illumination. The brightness switches in sequence from
High → Middle → Low → Off → High.

19
Q: What are the different ways of playing music from my portable music player through the audio system in my vehicle?
A: There are two ways of playing music through your vehicle’s audio system.
• USB port - The system will find the songs in your device and categorize them according to Artist, Album, and Genre. Then you can have the system
find and play the song in your device that you prefer without physically searching your device. This is done on the Audio System screen.
NOTE: In this mode the storage device will also be charged.
• Bluetooth
® Streaming - Once your device is paired to the system, you can stream music from your device through the system to your vehicle’s
audio system. No wires or cords are required. Your music stops and restarts at the same song when you exit and when you re-enter the vehicle.
Voice commands are not available.
Q: Why can’t I control the music track selection via voice commands while Bluetooth
® streaming?
A: The Mitsubishi system is not configured to support this functionality.
Q: My Outlander Sport is equipped with “Micron Air Filtration.” Where is the filter located and does it need servicing?
A: The micron air filter is a small filter element which is located in the HVAC box just behind the glove box. The filter should be inspected frequently for
debris. The filter works well at filtering incoming air however the filter will clog and lead to reduced outlet air volume if not serviced on a regular basis.
Q: My Outlander Sport has two 12V accessory outlets. What devices can be plugged into these outlets?
A: Both of these outlets are protected with 15 amp fuses. Always check the current draw rating of any device prior to use in the vehicle. If the device is
rated above 12 amps, this could lead to circuit overload and the electrical fuse opening (no current flow).
Q: A buffeting noise is heard when the rear windows are rolled down. How can I reduce this noise?
A: Roll down the front windows about 2-3” to even out the air pressure within the vehicle.
Q: I only have one remote for the remote start system on my Outlander Sport. Can I get a second one?
A: No. Only one remote can be programmed per vehicle for security reasons.
FAQ'S

20
Q: How can I get the MPG stated on the window sticker?
A: Vehicle driving styles will greatly affect MPG.
• Avoid sudden starts from a stop and let the vehicle coast to a traffic light. Both of these styles will increase mileage and reduce brake lining wear.
• Vehicles are designed to achieve the best fuel mileage when they are driven at the speed limits on the freeway. Avoid driving over 65 mph.
• Under inflated tires will increase rolling resistance and will reduce fuel mileage. Check tire pressure frequently to increase miles per gallon.
Proper tire pressure also ensures optimum tire performance (including tire wear).
Q: Why does my Anti-Lock Braking System (ABS) make a noise?
A: Each time your vehicle is started and driven a short distance, you will hear the sound of the ABS motor operating from the right front engine
compartment. This is the normal sound the Anti-Lock Braking System makes when performing a self check.
Q: Why do my Rain Sensing Windshield Wipers operate on their own when it’s not raining?
A: • When the lever is in the AUTO position, the rain sensor detects rain or snow and automatically turns on the wipers.
• The wipers may automatically operate when things such as insects or foreign objects are affixed to the windshield on top of the rain sensor or
when the windshield is frosted over.
• To stop the wipers, place the lever in the OFF position.
Q: Why does my check engine light come on after I put gas in my car?
A: There are many reasons why your check engine light may illuminate. Before calling your dealership, make sure the fuel cap is fully engaged and you
have heard three clicks when tightening it. If after checking and hearing three clicks and driving for awhile the light is still on, contact
your dealership.
Q: How do I use the emergency key when the FAST-key battery or vehicle battery is run down?
A: Remove the emergency key from the FAST-key fob and manually unlock the door. Once inside the vehicle, insert the FAST-key fob into the slot in the
glove box. Starting the engine and changing the operation mode should now be possible. Remove the FAST-key from the slot after starting the engine
or changing the operation mode.
FAQ'S