Page 493 of 589
Display messages
Possible causes/consequences and M
MSolutions
ë Off *T
he HOLD function is deactivated because theve hicle is skidding or a condition for activation is not met. #
Reactivate the HOLD function later or check the activation conditions forth e HOLD function (→ page 208).
Speed Limit Assist inopera-
tive *S
peed Limit Assist is malfunctioning. #
Consult a qualified specialist workshop.
Speed Limit Assist cur-
rently unavailable See Own-
er's Manual *S
peed Limit Assist is temp orarily una vailable. #
Drive on.
Once the cause of the problem is no longer present, the sy stem will be available again.
ç
Off *A
ctive Dis tance Assi stDISTRONIC was deactivated. If a warning tone also sounds, theAc tive Dis tance Assi sthas
deactivated automatically (→ page198).
ç
- - - km/h *A
ctive Dis tance Assi stDISTRONIC cannot be acti vated as not all activation conditions ha vebeen fulfilled. #
Comply with the activation conditions of Active Dis tance Assi stDISTRONIC (→ page 198). 490
Displaymessa ges and warning/indicator lamps
Page 494 of 589
Display messages
Possible causes/consequences and M
MSolutions
ç suspended *I
fyo u activate the accelera tor pedal be yond theAc tive Dis tance Assi stDISTRONIC setting, the sy stem will be put
into passive mode (→ page 206).
Active Distance Assist cur-
rently unavailable See Own-
er's Manual *A
ctive Dis tance Assi stDISTRONIC is temp orarily una vailable.
The ambient conditions are outside the sy stem limits (→ page196). #
Drive on.
As soon as the ambient conditions are within the sy stem limits, the sy stem will become available again.
Active Distance Assist inop-
erative *A
ctive Dis tance Assi stDISTRONIC is malfunctioning.
Other driving sy stems and driving saf ety sy stems may also be malfunctioning. #
Consult a qualified specialist workshop.
Active Distance Assist
available again *A
ctive Dis tance Assi stDISTRONIC is operational again and can be acti vated (→ page 198).
¯
- - - km/h *C
ruise control cannot be activated as not all activation conditions are fulfilled. #
Obser vethe activation conditions for cruise control (→ page194).
Cruise control off *C
ruise control has been deactivated.
If th ere is an additional warning tone, cruise control has been deacti vated automatically (→ page192). Displ
aymessa ges and warning/indicator lamps 491
Page 495 of 589
Display messages
Possible causes/consequences and M
MSolutions
Cruise control inoperative *C
ruise control is malfunctioning. #
Consult a qualified specialist workshop.
Cruise control and Limiter
inoperative *C
ruise control and the limiter are malfunctioning. #
Consult a qualified specialist workshop.
È - - - km/h *T
he limiter cannot be activated as not all activation conditions ha vebeen fulfilled. #
Obser vethe activation conditions of the limiter (→ page194).
Limi ter inoperative *T
he limiter is malfunctioning. #
Consult a qualified specialist workshop.
Limiter passive *I
fyo u depress the accelera tor pedal be yond the pressure point (kickdown), the limiter is switched topassive mode
(→ page 194).
Speed limit (winter tyres)
XXX km/h *Y
ou ha vereached thestored maximum speed for winter tyres. It is not possible toexc eed this speed.
ð Maximum speed exceeded *T
he maximum permissible speed has been exceeded (for cer tain countries only). #
Drive more slowl y.492
Display messages and warning/indicator lamps
Page 496 of 589
Engine
Display messages
Possible causes/consequences and M
MSolutions
Top up coolant See Own-
er’s Manual *T
he coolant le vel is too lo w.
* NO
TEEngine dama gedue toinsuf ficient coolant #
Avoid long journe yswith insuf ficient coolant. #
Add coolant (→ page 393).
?
Coolant Stop vehicle
Switch engine off *T
he coolant is too hot. #
Stop theve hicle immediately, paying attention toroad and traf fic conditions, and switch off the engine. &
WARNING Danger of bu rns when opening the bonn et
If yo u open the engine bonn etwhen the engine has overheated or during a fire inthe engine compartment, you
could come into contact wi thhot gases or other escaping operating fluids. #
Before opening the bonn et, allow the engine tocool down. #
Intheeve nt of a fire inthe engine compartment, keep the engine bonn etclosed and call thefire service. #
Wait until the engine has cooled down. #
Make sure that the air supply tothera diator is not obstructed. #
Avoiding significant loads on the engine, drive tothe nearest qualified specialist workshop. In doing so, ensure
th at the coolant temp erature display remains below 120 °C. Displ
aymessa ges and warning/indicator lamps 493
Page 497 of 589
Display messages
Possible causes/consequences and M
MSolutions
? *T
hefan mo tor is defective. #
Avoiding high loads on the engine, drive tothe nearest qualified specialist workshop. In doing so, ensure that
th e coolant temp erature display remains below 120 °C.
#
See Owner's Manual *T
he battery is not being charge d.
* NO
TEPossible engine damage if you continue driving #
Do not continue driving under any circum stances. #
Consult a qualified specialist workshop. #
Stop theve hicle immediately, paying attention toroad and traf fic conditions, and switch off the engine. #
Consult a qualified specialist workshop. 494
Display messages and warning/indicator lamps
Page 498 of 589
Display messages
Possible causes/consequences and M
MSolutions
# Stop vehicle See Owner's
Manual *T
he battery is no longer being charge d and the battery charge leve l is too lo w.
* NO
TEPossible engine damage if you continue driving #
Do not continue driving under any circum stances. #
Consult a qualified specialist workshop. #
Pull over and stop theve hicle safely as soon as possible, paying attention toroad and traf fic conditions. Do not
continue driving under any circums tances. #
Switch off the engine. #
Consult a qualified specialist workshop.
# 12 V battery See Owner's
Manual *T
he engine is off and the battery charge leve l is too lo w. #
Switch off electrical consumers that are not required. #
Lea vethe engine running for a few minutes, or drive for a longer dis tance.
The battery will charge.
# Stop vehicle Leave engine
running *T
he battery charge leve l is too lo w. #
Pull over and stop theve hicle safely as soon as possible, paying attention toroad and traf fic conditions. Do not
continue driving under any circums tances. #
Lea vethe engine running. #
Wait until the display message disappears before pulling away. Displ
aymessa ges and warning/indicator lamps 495
Page 499 of 589
Display messages
Possible causes/consequences and M
MSolutions
# 48 V battery See Owner's
Manual *T
he 48 V sy stem is malfunctioning. Con venience functions may be restricted. #
Consult a qualified specialist workshop immediatel y.
Cannot start engine See
Owner's Manual *T
hecharge leve l of the 48 V battery is too lo w.You can no lon gerst art the engine. #
Switch off electrical consumers that are not required. #
Connect a suitable charge r appro vedby Mercedes-Benz with suf ficient charge output tothe jump-s tart connec‐
tion point of the12 V battery (→ page417).
The 48 V battery is charge d via thevo ltage con verter in theve hicle.
Motor can be started again *T
he 48 V battery has been charge d automatically via thevo ltage con verter. #
Start the engine and drive theve hicle for a while tocharge the12 V battery and the 48 V batter y. 496
Display messages and warning/indicator lamps
Page 500 of 589
Display messages
Possible causes/consequences and M
MSolutions
Û Please wait Charging high-
voltage battery *T
he 48 V battery is dischar ged. You ha veswitched on the ignition while the12 V battery is being charge d with a
suitable charge r or while ano ther vehicle is pr oviding starting assis tance.
The discha rged 48 V battery is charge d automatically via thevo ltage con verter. Af ter a few minutes, theMotor can
be started again display message is shown on the multifunction displa y. #
Start the engine. #
Drive theve hicle for a while tocharge the12 V battery and the 48 V battery af ter disconnecting thech arger
from theve hicle.
If th eMotor can be started again display message does not appear af ter a few minutes: #
Tryto start the engine again. #
Ifth e engine does not start, consult a qualified specialist workshop. Display messages and
warning/indicator lamps 497
