Tire-mounting tools should not be used near
the valve. This could damage the electronic
components.
Only have tires changed at aq ualified spe-
cialist workshop.
Observe the instructions and safety notes in the
"Changing aw heel" section ( Y
page 307).
The wear pattern sont he front and rear tires
differ, depending on the operating conditions.
Rotate the wheels before ac lear wear pattern
has formed on the tires. Fron tt ires typically
wear more on the shoulders and the rear tires in
the center.
On vehicles that have the same size front and
rear wheels, you can rotat et he wheels accord-
ing to the intervals in the tire manufacturer's
warranty book in your vehicle documents. If no
warranty book is available, the tires should be
rotated every 3,000 to 6,000 miles (5,000 to
10,00 0k m) .D ependin gont ire wear, this may
be required earlier. Do not change the direction
of wheel rotation.
Clean the contact surfaces of the wheel and the
brake disc thoroughly every time aw heel is rota-
ted. Check the tire pressure and, if necessary,
restart the tire pressure loss warning system
(Canada only) or the tire pressure monitor (USA
only).
Direction of rotation Tires with as pecified direction of rotation have
additional benefits ,e .g. if there is ar isk of hydro-
planing. These advantages can only be gained if
the tires are installed corresponding to the
direction of rotation.
An arrow on the sidewall of the tire indicates its
correc td irection of rotation.
Storing wheels Stor ew heels that are not being used in ac ool,
dry and preferably dark place. Protec tt he tires
from oil, grease, gasoline and diesel. Mounting aw heel
Preparing the vehicle X
Stop the vehicle on solid, non-slippery and
level ground. X
Apply the electric parking brake manually. X
Bring the front wheels into the straight-ahead
position. X
Shift the transmission to position  ] .X
Switch off the engine. X
Vehicles without KEYLESS-GO: remove the
SmartKey from the ignition lock. X
Vehicles with KEYLESS-GO start-function
or KEYLESS-GO: open the driver's door.
The vehicle electronics are now in position
 
         
        
        The antifreeze concentrate/corrosion inhibitor
concentration in the engine cooling system
should: R
be at least 50%. This will protec tt he engine
cooling system against freezin gd own to
approximately -35 ‡( -37 †)R
not exceed 55% (antifreez ep rotection down
to -49 ‡[ -45 †]) .O th erwise ,h ea tw ill no tb e
dissipated as effectively
Mercedes-Ben zr ecommends ac oo lan torc or -
rosio ni nh ibitor/antifreez ec oncentrat ei n
accordance wit h
MB Specification sf or Servic eP ro ducts 310. 1.
i When the vehicle is first delivered, it is filled
with ac oolant mixture that ensures adequate
antifreeze and anti-corrosion protection.
i The coolant is checked with every mainte-
nanc ei nterval at aq ualified specialist work-
shop.
Filling capacities Model Capacity
Mercedes ‑ AMG
vehicles Approx .1 2. 6USq t
(11. 9l )
Al lo th er models
Approx. 8.2 US qt
(7.8 l)
Windshield washe rs ystem
Important safety notes
G WARNING
Windshiel dw as her concentrate coul di gnite if
it comes into contact with hot engine compo-
nents or the exhaust system .T here is ar isk of
fire and injury.
Make sure that no windshield washer con-
centrate is spilled next to the filler neck.
! Only MB SummerFi ta nd MB WinterFit
washer flui ds hould be mixed together. The
spra yn ozzles may otherwise become
blocked.
Do not use distille dord e-ionized water. Other-
wise, the leve ls ensor may give af als er eading. When handling washer fluid, observe the impor-
tant safety notes on service products
( Y
pag e3 15).
At temperatures above freezing: X
Fill the washer flui dr eservoir with am ixture of
water and windshield washer fluid, e.g. MB
SummerFit.
Add 1p art MB SummerFi tto1 00 parts water.
At temperatures below freezing: X
Fill the washer flui dr eservoir with am ixture of
water and washer fluid, e.g. MB WinterFit.
For the correct mixing ratio refer to the infor-
mation on the antifreeze reservoir.
i Add windshield washer fluid, e.g. MB Sum-
merFit or MB WinterFit, to the washer flui da ll
yea rr ound.
Climate control system refrigerant
Important safety notes The climate control system of you rv ehicl eisf il-
led with refrigerant R ‑ 134a.
The instruction label regarding the refrigerant
type use dc an be found on the left, on the under-
side of the hood.
! Only the refrigerant R ‑ 134a and the PAG oil
approved by Mercedes-Benz may be used.
The approved PAG oil may not be mixed with
any other PAG oil that is not approved for
R-134a refrigerant. Otherwise, the climate
control system may be damaged.
Service work, such as refilling with refrigerant or
replacing component parts, may only be carried
out by aq ualified specialist workshop. All appli-
cabl er egulations, as wel lasS AE standard J639,
must be adhered to.
Always have work on the climate control system
carrie do ut at aq ualified specialist workshop.Service products and filling capacities 319
Technical data Z