2018 MERCEDES-BENZ C-CLASS COUPE fold seats

Fi
tting/ removing the rear seat head
re stra ints
Re mo val 0007
Release there ar seat backrest and fold it
slight lyforw ards (0013 page113). 0007
Pull the head restra int upwards as far as it
will go. 0007
Push release knob 1inthe direction of the
ar row and pull out the head restra int.
Fi tting 0007
Inse rtthe head restra int such that the
notches on the bar are on the left when
vie we d in the direction of tra vel. 0007
Push the head restra int down until you hear
it en gage in position. 0007
Foldthere ar seat backrest back until it
engages. Configuring
the seat settings Multimedia sy
stem:
0018 © 0019
Comfort 0019
Seat comfort 0007
Select a seat.
Ad justing the backrest side bols ters 0007
Select Side bolsters . 0007
Adjust the air cushions. Ad
justing the seat contour in the lumbar
re gion of the seat backrest (lumbar) 0007
Select Lumbar . 0007
Adjust the air cushions. Selecting
the massage prog ramme for the
front seats Multimedia sy
stem:
0018 Vehicle 0019
a Seats 0007
Select Driver's seat orPassenger . 0007
Select Massage. 0007
Select a massage programme.
The massage programme runs for appro x‐
ima tely 9to 15 minutes, depending on the
setting. 0007
Toset the massage intensit y:switch High
intensity on0073 or off 0053. Seats and
stowing 103

Re
setting seat adjustments Multimedia sy
stem:
0018 Vehicle 0019
a Seats 0019
Reset 0007
Select YesorNo.
Depending on whe ther the settings forth e driver
or front passenger seat are selected, only the
selected seat can be reset. Fo
lding the front seat backrest forw ards/
back (vehicles with memo ryfunction) Wi
th th e EASY -ENTRY function, the seat will
mo veforw ards if you ha vefolded the seat back‐
re st forw ards. This makes it easier for passen‐
ge rs to get into and out of there ar of theve hi‐
cle. 0007
Tofold forw ards: pullthe seat release han‐
dle 1and fold the seat backrest forw ards
as far as it will go.
The seat will mo veautomatically tothefo re‐
most position. 0007
Tofold back: swing back the seat backrest
horizon tally.
If th e seat backrest is not engaged, this will
be shown on the multifunction display of the instrument clus
ter.A wa rning tone will also
sound.
The seat will mo veautomatically tothe
st ored position.
If th e set seat position can no longer be reached,
e.g. because of luggage in there ar foot we ll or
af te r occupants ha veentered there ar of the
ve hicle: 0007
Pull the seat release handle 1again and
re turn the seat backrest toan upright posi‐
tion.
The seat will lock in the new fore -and-aft
position. Fo
lding the front seat backrest forw ards/
backwards (vehicles with out memory func‐
tion) Fo
lding forw ards
Wi th th e EASY -ENTRY function, the seat will
mo veforw ards if you ha vefolded the seat back‐
re st forw ards. This makes it easier for passen‐
ge rs to get into and out of there ar of theve hi‐
cle. 104
Seats and stowing

0007
If necessar y,release the head restra int and
push it down. 0007
Pull the seat release handle 1and fold the
seat backrest forw ards until the seat back‐
re st engages. 0007
Push the seat as farfo rw ards as it will go. Fo
lding back 0007
Push the seat back horizon tally by the seat
backrest until it reaches the seat position
th at wa s pr eviously set. 0007
Foldthe seat backrest back until it engages.
Do so as smoo thly as possible.
If th e seat backrest is not engaged, this will
be shown on the multifunction display of the
instrument clus ter.A wa rning tone will also
sound. 0007
Afterth e seat backrest has been folded
bac k,check the position of the head restra int
and set it tothe cor rect position.
If th e set seat position can no longer be reached,
e.g. because of luggage in there ar foot we ll or
af te r occupants ha veentered there ar of the
ve hicle: 0007
Pull the seat release handle 1again and
re turn the seat backrest toan upright posi‐
tion.
The seat will lock in the new fore -and-aft
position. Switching the seat heating on/o
ff 000A
WARNING Risk of bu rns due torepeat‐
edly switching on the seat heater
Re peatedly switching on the seat heater can
cause the seat cushion and seat backrest
padding tobecome very hot.
The health of persons with limited temp era‐
ture sensitivity or a limited ability toreact to
high temp eratures may be af fected or they
may even su ffer burn-like injuries. 0007
Do not repeatedly switch on the seat
heater. To
protect against overheating, the seat heating
may be temp orarily deactivated af ter it is
switched on repeatedly.
000E NO
TEDama getothe seats caused by
objects or documents when the seat
heater is switched on When
the seat heater is switched on, over‐
heating can occur due toobjects or docu‐ Seats and
stowing 105

Opening
the spectacles compa rtment 0007
Press button 1. Through-loading
feature in there ar ben ch
seat Fo
lding there ar seat backrest forw ards 000A
WARNING Risk of inju ryifth ere ar
ben chseat/rear seat and seat backrest
are not engaged
If th ere ar ben chseat/rear seat and seat
backrest are not engaged they could fold for‐ wa
rds, e.g. when braking suddenly or in the
ev ent of an accident.
R Ifth is is the case, theve hicle occupant
wo uld be forc ed into the seat belt bythe
re ar ben chseat/rear seat or bythe seat
backrest. The seat belt cann otprotect as
intended and could result in additional
injur y.
R Objects or loads in the boot/load com‐
partment cann otbe restra ined bythe
seat backrest. 0007
Make sure that the seat backrest and
th ere ar ben chseat/rear seat are
engaged before everytrip. If
th e left and right seat backrests are not
engaged and loc ked, this will be shown on the
multifunction display of the instrument clus ter. A
wa rning tone will also sound.
If th e cent reseat backrest is not engaged and
loc ked, there d lock verification indicator will be
visible.
The centre and ou ter seat backrests can be fol‐
ded forw ards separatel y. 0007
Vehicles without a memory function:
mo vethe driver's or front passenger seat for‐
wa rds, if necessar y. 0007
Vehicles with a memory function: if at
lea stone section of there ar seat backrest is
fo lded forw ards, the cor responding front seat
will mo veforw ards slightl y,if necessar y,to
av oid a collision. Seats and
stowing 11 3

0007
If necessar y,fully insert there ar seat back‐
re st head restra ints. 0007
Left and right seat backrests: pullthe left
or right release handle 1.
The cor responding seat backrest will fold for‐
wa rds. 0007
Centre seat backres t:pull release cat ch3
of seat backrest 2forw ards. 0007
Foldthe seat backrest 2forw ards. 0007
If necessar y,reset the driver's or front
passenger seat.
Fo lding there ar seat backrest back
000E NO
TEDama getothe seat belt The seat belt could become trapped and
thus
damaged when folding back the seat back‐
re st. 0007
Make sure that the seat belt is not trap‐
ped when folding back the seat back‐
re st. 0007
Movethe driver's or front passenger seat for‐
wa rds, if necessar y. 0007
Foldthe cor responding seat backrest 1
back until it engages.
Left and right seat backrests: ifth e seat
backrest is not engaged and loc ked, this will
be shown on the multifunction display on the
instrument clus ter.
A wa rning tone will also sound. 11 4
Seats and stowing

Centre seat backres
t:ifth e seat backrest is
not engaged and loc ked, red lock verification
indicator 2will be visible.
Lo cking there lease catch of the centre rear
seat backrest
Re quirements:
R The left and centre seat backrests are
engaged and joined toge ther.
Yo u can lock the cent reseat backrest release
cat chifyo uwa nttosecure the boot against
unauthorised access. The cent reseat backrest
can then be folded forw ards on lytoge ther with
th e left seat backrest. 0007
Foldthe cent reand left seat backrests for‐
wa rds. 0007
Tolock: slide cat ch1 upwards.
The release cat chofthe cent reseat backrest
will be loc ked. 0007
Tounlo ck:slide catch 1down wards. Overview of
the tie-down eyes Obser
vethe no tes on loading theve hicle
(0013 page111). 1
Tie-down eyes (vehicles with thro ugh-loading
fe ature in there ar ben chseat) Seats and
stowing 11 5

0007
Alw aysstow and secure objects that
are heavy, hard, poin ted, sharp-edged,
fragile or too large in the boot. Obser
vethe no tes on loading theve hicle. 0007
Vehicles with through-loading feature in
th ere ar ben chseat: fold up the tie-down
ey es. 0007
Hook the luggage net 1into the front and
re ar tie-down eyes. 0007
Vehicles without a through-loading fea‐
ture in there ar ben chseat: hooktherings
into the luggage net's hooks 1. 0007
Hook therings into the hooks on the boot
fl oor. Opening
thesto wage space under the boot
floor 000E
NO
TEDama getothe handle in the boot
fl oor If
th e handle in the boot is left pr otru ding,
th e handle may be damaged. 0007
Unhinge the handle before you close
th e boot lid and press the handle closed
again. 0007
Pull handle 1up and hook it into drip rail
2. Seats and
stowing 117

000E
NO
TEDama getothe co vers The co
vers may be dama ged and scratched
when being opened. 0007
Do not use me tallic or hard objects. 0007
Carefully fold the co vers 1 upwards in the
direction of the ar row. 0007
Secu rethero of rack tothe anchorage points
under the co vers 1 . 0007
Comply with thero of rack manufacturer's
ins tallation instructions. 0007
Secure the load on thero of rack. Cup holders
Fi
tting the cup holder in or removing it from
the centre console (au tomatic transmission) 000A
WARNING ‑ Risk of accident or inju ry
when using the cup holder while the
ve hicle is in motion
The cup holder cannot hold a container
secure while theve hicle is in motion. If
yo u use a cup holder while theve hicle is in
motion, the conta iner may be flung around
and liquids could be spilled. The vehicle
occupants may come into contact with the
liquid and if it is hot, they could be scalded.
Yo u could be distracted from traf fic condi‐
tions and you may lose cont rol of theve hicle. 0007
Only use the cup holder when theve hi‐
cle is stationar y. 0007
Only use the cup holder for containers
of theright size. 0007
Alw ays close the conta iner, particularly
if th e liquid is hot. 0007
Toremo ve:slide catch 2forw ards and pull
out cup holder 1. 0007
Tofit: inse rtcup holder 1and slide ba ck
catch 2.
0009 The cup holder rubber mat can be remo ved
fo r cleaning, e.g. using clean, luk ewarm
wate r. Seats and
stowing 11 9