2018 MAZDA MODEL 6 Oil spec
[x] Cancel search: Oil specPage 409 of 863
¾The front doors or the liftgate/boot is not fully closed.
¾The vehicle is on a road incline.
¾The door mirrors are retracted.
¾Do not hit the front/rear camera, front bumper, and door mirrors forcefully. The camera
position or installation angle may shift.
¾The cameras are of a waterproof structure. Do not disassemble, modify, or remove a
camera.
¾The camera cover is made of hard plastic, therefore do not apply oil film remover, organic
solvents, wax, or coating agents. If any such agent gets on the camera cover, wipe it off
using a soft cloth immediately.
¾Do not rub the camera lens forcefully, or clean it with an abrasive or hard brush. Otherwise,
it could scratch the camera lens and negatively affect the images.
¾Consult an Authorised Mazda Repairer for repair, painting, or replacement of the front/rear
camera, front bumper and door mirrors.
¾Heed the following cautions to assure that the 360°View Monitor operates normally.
¾Do not modify the suspensions.
¾Always use wheels of the specified type and size for the front and rear wheels. Consult an
Authorised Mazda Repairer for tyre replacement.
¾When the display is cold, images may leave trails or the screen might be darker than usual,
making it difficult to check the vehicle surroundings. Always confirm the safety at the front
and around the vehicle visually when driving.
¾The method for parking/stopping the vehicle using the 360°View Monitor differs depending
on the road circumstances/conditions and the vehicle conditions. When and how much you
turn the steering wheel will differ depending on the situation, , therefore always check the
vehicle surroundings directly with your eyes while using the system.
Also, before using the system, always make sure that the vehicle can be parked/stopped in
the parking/stopping space.
NOTE
xIf there are water droplets, snow, or mud on the camera lens, wipe it off using a soft cloth.
If the camera lens is especially dirty, wash it off with mild detergent.
xIf the area where the camera is installed, such as the liftgate/boot or door mirrors, has
been damaged in a vehicle accident, the camera (position, installation angle) may have
shifted. Always consult an Authorised Mazda Repairer to have the vehicle inspected.
xIf the camera is subjected to excessive changes in temperature such as by pouring hot
water on the camera during cold weather, the 360°View Monitor may not operate
normally.
xIf the battery voltage is low or the engine is restarted by the i-stop function, the screen
might be temporarily difficult to view, however, this does not indicate a problem.
: K H Q ' U L Y L Q J
L $ & 7 , 9 6 ( 1 6 (
Page 436 of 863
¾Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS)
¾Traffic Sign Recognition System (TSR)
¾Advanced Smart City Brake Support (Advanced SCBS)
¾Smart City Brake Support [Forward] (SCBS F)
¾Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function)
¾Smart Brake Support (SBS)
¾The direction in which the Forward Sensing Camera (FSC) is pointed has been finely
adjusted. Do not change the installation position of the Forward Sensing Camera (FSC) or
remove it. Otherwise, it could result in damage or malfunction.
¾Always use tyres for all wheels that are of the specified size, and the same manufacturer,
brand, and tread pattern. In addition, do not use tyres with significantly different wear
patterns on the same vehicle as the system may not operate normally.
¾The Forward Sensing Camera (FSC) includes a function for detecting a soiled windscreen
and informing the driver, however, depending on the conditions, it may not detect plastic
shopping bags, ice or snow on the windscreen. In such cases, the system cannot accurately
determine a vehicle ahead and may not be able to operate normally. Always drive carefully
and pay attention to the road ahead.
NOTE
xIn the following cases, the Forward Sensing Camera (FSC) cannot detect target objects
correctly, and each system may be unable to operate normally.
xThe height of the vehicle ahead is low.
xYou drive your vehicle at the same speed as the vehicle ahead.
xHeadlights are not turned on during the night or when going through a tunnel.
xIn the following cases, the Forward Sensing Camera (FSC) may not be able to detect
target objects correctly.
xUnder bad weather condition, such as rain, fog and snow.
xThe window washer is being used or the windscreen wipers are not used when it's
raining.
xIce, fog, snow, frost, rainfall, dirt, or foreign matter such as a plastic bag is stuck on the
windscreen.
xTrucks with low loading platforms and vehicles with an extremely low or high profile.
xWhen driving next to walls with no patterning (including fences and longitudinally
striped walls).
xThe tail lights of the vehicle ahead are turned off.
xA vehicle is outside the illumination range of the headlights.
xThe vehicle is making a sharp turn, or ascending or descending a steep slope.
xEntering or exiting a tunnel.
xHeavy luggage is loaded causing the vehicle to tilt.
: K H Q ' U L Y L Q J
L $ & 7 , 9 6 ( 1 6 (
Page 441 of 863
¾Do not use the front bumper to push other vehicles or obstructions such as when pulling
out of a parking space. Otherwise, the radar sensor (front) could be hit and its position
deviated.
¾Do not remove, disassemble, or modify the radar sensor (front).
¾For repairs, replacement or paint work around the radar sensor (front), consult an
Authorised Mazda Repairer.
¾Do not modify the suspension. If the suspension are modified, the vehicle's posture could
change and the radar sensor (front) may not be able to correctly detect a vehicle ahead or
an obstruction.
NOTE
xUnder the following conditions, the
radar sensor (front) may not be able to
detect vehicles ahead or obstructions
correctly and each system may not
operate normally.
xThe rear surface of a vehicle ahead
does not reflect radio waves
effectively, such as an unloaded
trailer or an automobile with a
loading platform covered by a soft
top, vehicles with a hard plastic
tailgate, and round-shaped vehicles.
xVehicles ahead with low vehicle
height and thus less area for
reflecting radio waves.
xVisibility is reduced due to a vehicle
ahead casting off water, snow, or
sand from its tyres and onto your
windscreen.
xThe boot/luggage compartment is
loaded with heavy objects or the rear
passenger seats are occupied.
xIce, snow, or soiling is on the front
surface of the front emblem.
xDuring inclement weather such as
rain, snow, or sand storms.
xWhen driving near facilities or
objects emitting strong radio waves.
xUnder the following conditions, the
radar sensor (front) may not be able to
detect vehicles ahead or obstructions.
xThe beginning and end of a curve.
xRoads with continuous curves.
xNarrow lane roads due to road
construction or lane closures.
xThe vehicle ahead enters the radar
sensor's blind spot.
xThe vehicle ahead is running
abnormally due to accident or
vehicle damage.
xRoads with repeated up and down
slopes
xDriving on poor roads or unpaved
roads.
xThe distance between your vehicle
and the vehicle ahead is extremely
short.
xA vehicle suddenly comes close such
as by cutting into the lane.
xTo prevent incorrect operation of the
system, use tyres of the same specified
size, manufacturer, brand, and tread
pattern on all 4 wheels. In addition, do
not use tyres with significantly different
wear patterns or tyre pressures on the
same vehicle (Including the temporary
spare tyre).
xIf the battery power is weak, the system
may not operate correctly.
: K H Q ' U L Y L Q J
L $ & 7 , 9 6 ( 1 6 (
Page 658 of 863
(Europe)
(Except Europe)
GradeTemperature Range SAE Viscosity Numbers
ACEA C3
–30 –20 –10 0
1020 30
40
–200
2040
60
80100
–40
–40
SKYACTIV-D 2.2
Temperature Range SAE Viscosity Numbers
Grade
Mazda Original Oil Ultra DPF 5W-30 Mazda Original Oil Supra DPF 0W-30
Alternative Oil QualityRecommended oils
–30 –20 –10 0
1020 30
40
–200
2040
60
80100
–40
–40
ACEA C3
5W-30 0W-30
( Q J L Q H R L O Y L V F R V L W \ R U W K L F N Q H V V K D V D Q H I I H F W R Q I X H O H F R Q R P \ D Q G F R O G Z H D W K H U R S H U D W L R Q
V W D U W L Q J D Q G R L O I O R Z
/ R Z Y L V F R V L W \ H Q J L Q H R L O V F D Q S U R Y L G H L P S U R Y H G I X H O H F R Q R P \ D Q G F R O G Z H D W K H U
S H U I R U P D Q F H
: K H Q F K R R V L Q J D Q R L O F R Q V L G H U W K H W H P S H U D W X U H U D Q J H \ R X U Y H K L F O H Z L O O R S H U D W H L Q E H I R U H
W K H Q H [ W R L O F K D Q J H
7 K H Q V H O H F W W K H U H F R P P H Q G H G Y L V F R V L W \ I U R P W K H F K D U W
& $ 8 7 , 2 1
¾Using oils of viscosity besides those recommended for specific temperature ranges could
result in engine damage.
0 D L Q W H Q D Q F H D Q G & D U H
2 Z Q H U 0 D L Q W H Q D Q F H
Page 659 of 863
¾(SKYACTIV-D 2.2)
SKYACTIV-D 2.2 uses specified oil. Please confirm the specification in owner's manual. If
engine oil other than the
specified oil is used, the Diesel Particulate Filter
effective period of
use will be shortened or the Diesel Particulate Filter may be damaged.
NOTE
(SKYACTIV-G 2.0, SKYACTIV-G 2.5, and SKYACTIV-G 2.5T)
xIt is normal for all engines to consume engine oil under normal driving conditions.
Engine oil consumption may be as high as 0.8 L/1,000 km (1 L/800 miles). This may be as
a result of evaporation, internal ventilation or burning of the lubricating oil in the
working engine. Oil consumption may be higher when the engine is new due to the
running-in process. Oil consumption is also dependant on engine speed and engine load.
Under extreme driving conditions, oil consumption may be higher.
(SKYACTIV-D 2.2)
xWhenever the engine oil is replaced, the vehicles engine control unit needs to be reset as
soon as possible. Otherwise the wrench indicator light or engine oil warning light may
turn on. To reset the engine control unit, consult an expert repairer, we recommend an
Authorised Mazda Repairer or refer to the vehicle engine control unit reset procedure on
page 6-28.
xInspect the engine oil level periodically. When inspecting the engine oil, if the engine oil
level is exceeds the “X” mark on the dipstick, replace the engine oil. This should be done
by an expert repairer, we recommend an Authorised Mazda Repairer. When replacing the
engine oil, inspect the oil level using the oil dipstick and refill so that the engine oil level
is within the range between MIN and MAX as shown in the figure.
X Mark MAX MIN
0 D L Q W H Q D Q F H D Q G & D U H
2 Z Q H U 0 D L Q W H Q D Q F H
Page 661 of 863
▼ , Q V S H F W L Q J ( Q J L Q H 2 L O / H Y H O
% H V X U H W K H Y H K L F O H L V R Q D O H Y H O
V X U I D F H
: D U P X S W K H H Q J L Q H W R Q R U P D O
R S H U D W L Q J W H P S H U D W X U H
7 X U Q L W R I I D Q G Z D L W D W O H D V W P L Q X W H V
I R U W K H R L O W R U H W X U Q W R W K H V X P S
3 X O O R X W W K H G L S V W L F N Z L S H L W F O H D Q D Q G
U H L Q V H U W L W I X O O \
6 . < $ & 7 , 9 * 6 . < $ & 7 , 9 *
D Q G 6 . < $ & 7 , 9 * 7
MAX
OK
MIN
6 . < $ & 7 , 9 '
MINOK MAXX Mark
NOTE
(SKYACTIV-D 2.2)
When inspecting the engine oil level,
pull out the dipstick straight without
twisting. In addition, when inserting
the dipstick, always insert it without
twisting so that the “X” mark faces the
front of the vehicle.
3 X O O L W R X W D J D L Q D Q G H [ D P L Q H W K H O H Y H O
7 K H O H Y H O L V Q R U P D O L I L W L V E H W Z H H Q W K H
0 , 1 D Q G 0 $ ; P D U N V
, I L W L V Q H D U R U E H O R Z 0 , 1 D G G H Q R X J K
R L O W R E U L Q J W K H O H Y H O W R 0 $ ;
& $ 8 7 , 2 1
Do not overfill the engine oil. This may
cause engine damage.
0 D N H V X U H W K H 2 U L Q J R Q W K H G L S V W L F N L V
S R V L W L R Q H G S U R S H U O \ E H I R U H U H L Q V H U W L Q J
W K H G L S V W L F N
5 H L Q V H U W W K H G L S V W L F N I X O O \
0 D L Q W H Q D Q F H D Q G & D U H
2 Z Q H U 0 D L Q W H Q D Q F H