2018 LEXUS LX570 belt

711-1. For safe use
LX570_OM_OM60Q78U_(U) 1
For safety and security Adjust the head restraint to the
downmost position. 
Second center seat
Secure the child restraint system
using a seat belt and remove the
head restraint.
Open the anchor bracket cover,
latch the hook onto the anchor
bracket and tighten the top tether
strap. Make sure the top tether strap is
securely latched.
Install the head restraint.
■
Laws and regulations pertaining to Anchors
The LATCH system conforms to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMV SS213 or CMVSS213 specifications can be
used.
This vehicle is designed to conform to the SAE J1819.3
1
2
3

72 1-1. For safe use
LX570_OM_OM60Q78U_(U) WARNING ■
When installing a booster seat
To prevent the belt from going into ALR lock mode, do not fully extend the shoulder
belt. ALR mode causes the belt to tighten on ly. This could cause injury or discomfort to
the child. ( → P. 34)■
When installing a child restraint system
Follow the directions given in the child rest raint system installation manual and fix the
child restraint system securely in place.
If the child restraint system is not correctly fixed in place, the child or other passengers
may be seriously injured or even killed in th e event of sudden braking, sudden swerving
or an accident.
●
When installing a child restraint system on the second center seat, adjust both seat
cushions to the same position and align bo th seatbacks at the sa me angle. The seat-
backs must be adjusted to the same angle. Otherwise, the child restraint system can-
not be securely restrained an d this may cause death or seri ous injuries in the event of
sudden braking, sudden swerving or an accident. ●
When using the LATCH anchors for a child restraint system, move the seat as far
back as possible, with the seatback close to the child restraint system.●
If the driver’s seat interferes with the child
restraint system and prevents it from being
attached correctly, atta ch the child restraint
system to the right-hand rear seat. ●
Adjust the front passenger seat so that it does
not interfere with the child restraint system. ●
Vehicles with third seat s: Child restraint sys-
tem installed on the thir d seat should not con-
tact the second seatbacks. ●
Only put a forward-faci ng child restraint sys-
tem on the front seat when unavoidable.
When installing a forward-facing child
restraint system on the front passenger seat,
move the seat as far back as possible even if
the “AIR BAG OFF” indicator light is illumi-
nated. Failure to do so may result in death or
serious injury if the airbags deploy (inflate).

731-1. For safe use
LX570_OM_OM60Q78U_(U) 1
For safety and security WARNING ■
When installing a child restraint system ●
When a booster seat is installed, always en sure that the shoulder belt is positioned
across the center of the child’s shoulder. The belt should be kept away from the child’s
neck, but not so that it could fall off the ch ild’s shoulder. Failing to do so may result in
death or serious injury in the event of su dden braking, sudden swerving or an acci-
dent. ●
Ensure that the belt and plate are securely locked and the seat belt is not twisted.●
Shake the child restraint syst em left and right, and forward and backward to ensure
that it has been securely installed. ●
After securing a child restraint system, ne ver adjust the seat.●
Follow all installation instructions provided by the child restraint system manufacturer.●
When securing some types of child restraint systems in se cond or third row seats, it
may not be possible to properly use the se at belts in position s next to the child
restraint without interfering with it or affe cting seat belt effect iveness. Be sure your
seat belt fits snugly across your shoulder and low on your hips. If it does not, or if it
interferes with the child restraint, move to a different position. Failure to do so may
result in death or serious injury. ■
Do not use a seat belt extender
If a seat belt extender is used when insta lling a child restraint system, the seat belt will
not securely hold the child restraint system , which could cause death or serious injury
to the child or other passengers in the event of sudden braking, sudden swerving or an
accident. ■
To correctly attach a child re straint system to the anchors
When using the LATCH anchors, be sure that there are no foreig n objects around the
anchors and that the seat belt is not caught behind the child restraint system. Make sure
the child restraint system is securely attached , or it may cause death or serious injury to
the child or other passengers in the event of a sudden stop, sudden swerve or accident.

LX570_OM_OM60Q78U_(U) 832. Instrument cluster
2
Instrument cluster Warning lights inform the driver of malfun ctions in any of the vehicle’s systems.
Warning lights * 1
(U.S.A.)
Brake system warning light
( → P. 520)
* 1
Automatic headlight
leveling system warning
light ( → P. 521)
* 1
(Canada)
Brake system warning light
( → P. 520)
* 2
Low speed four-wheel
drive indicator light
( → P. 522)
* 1
Charging system warning
light ( → P. 520)
* 2
Center differential lock
indicator light ( → P. 522)
* 1
(U.S.A.)
Malfunction indicator lamp
( → P. 520) Open door warning light
( → P. 522)
* 1
(Canada)
Malfunction indicator lamp
( → P. 520) Low fuel level warning light
( → P. 522)
* 1
SRS warning light
( → P. 520) Driver’s seat belt reminder
light ( → P. 522)
* 1
(U.S.A.)
ABS warning light
( → P. 520) * 3
Front passenger’s seat belt
reminder light ( → P. 522)
* 1
(Canada)
ABS warning light
( → P. 520) * 1
Master warning light
( → P. 522)
* 1, 4
(if equipped) PCS warning light
( → P. 521) * 1
Tire pressure warning light
( → P. 522)
* 1
Slip indicator light
( → P. 521) * 2
(U.S.A.) Parking brake indicator
( → P. 522)

LX570_OM_OM60Q78U_(U) 1413-3. Adjusting the seats
3
Operation of each component ■
Power easy access system
The driver’s seat and steering wheel move in accordance with engine switch mode and
the driver’s seat belt condition. ( → P. 151)■
Active head restraints
Even small forces applied to the seatback may cause the head restraint to move. Pushing
up a locked head restraint fo rcibly may appear the head re straint inner st ructure. These
do not indicate problems.
WARNING ■
When adjusting the seat position ●
Take care when adjusting the seat position to ensure that other passengers are not
injured by the moving seat. ●
Do not put your hands under the seat or near the moving parts to avoid injury.
Fingers or hands may become jammed in the se at mechanism.■
Seat adjustment
To reduce the risk of sliding under the lap be lt during a collision, do not recline the seat
more than necessary.
If the seat is too reclined, the lap belt may slide past the hips and apply restraint forces
directly to the abdomen, or your neck may contact the shou lder belt, increasing the risk
of death or serious injury in the event of an accident.
Adjustments should not be made while drivin g as the seat may unexpectedly move and
cause the driver to lose control of the vehicle. Inner
structure During rear-end collision

LX570_OM_OM60Q78U_(U) 1433-3. Adjusting the seats
3
Operation of each component For easy access to the third seat (if eq uipped), perform in “Tumbling the sec-
ond seats” ( → P. 144). ■
Before tumbling the second seats
Stow the seat belt buckles and
lower the head restraints to the
lowest position.
Pass the outer seat belts through
the seat belt hangers and secure
the seat belt plates. This prevents the shoulder belt from
being damaged.
Make sure that th e seat belts are
removed from the hangers before
using them.
Vehicles with rear seat entertain-
ment system: Install the display
cover for the rear seat entertain-
ment system.
Pass the cover belt under the dis-
play and slide the cover up.
Slide the cover down from the top
of the display to cover it.Tumbling the second seats and third seat entry 1
1
2
3

LX570_OM_OM60Q78U_(U) 1453-3. Adjusting the seats
3
Operation of each component ■
Before folding the third seats
Stow the seat belts buckles.
Stow the center head restraint in the seatback. ( → P. 157)
Pass the outer seat belts through
the seat belt hangers and secure
the seat belt plates. This prevents the shoulder belt from
being damaged.
Make sure that th e seat belts are
removed from the hangers before
using them.
Stow the center seat belt tabs in the cover set in the roof. ( → P. 32)■
Folding down the third seatback
For right side
For left sideFolding the third seats (if equipped) 1
2
3
4
1
2

150
LX570_OM_OM60Q78U_(U) 3-3. Adjusting the seats
WARNING ■
Seat adjustment
To reduce the risk of sliding under the lap be lt during a collision, do not recline the seat
more than necessary.
If the seat is too reclined, the lap belt may slide past the hips and apply restraint forces
directly to the abdomen, or your neck may contact the shou lder belt, increasing the risk
of death or serious injury in the event of an accident.
Adjustments should not be made while drivin g as the seat may unexpectedly move and
cause the driver to lose control of the vehicle. ■
When the seatback is folded ●
Do not sit on or place anything on the seatback while driving.●
Be sure to install the seat hook covers on the seat hooks, or you may get burned when
they become hot. ■
When returning the seatbacks to their original position
Observe the following precautions. Failure to do so may result in death or serious
injury. ●
Be careful not to get your hand s or feet pinched in the seat.●
Make sure the seats are secure ly locked. Failure to do so will prevent the seat belt
from operating properly. ●
Check that the seat belts are not twisted or caught under the seat. ●
Arrange the seat belts in the proper positions for ready use. ■
Avoiding damage to seat components
Do not hang or attach anythi ng on the seatback striker.
NOTICE ■
Before tumbling, fo lding up the seats
The seat belts and buc kles must be stowed.■
After returning the third seat (if equipped)
Make sure that the handle on the re ar of the seatback has been secured.