2018 LEXUS LX570 rear view mirror

368
LX570_OM_OM60Q78U_(U) 4-5. Using the driving support systems
The areas that vehicles can be detected in are outlined below.
The range of each detection area is:
Approximately 1.6 ft. (0.5 m) to 11.5 ft. (3 .5 m) from either side of the vehicle
*
* : The area between the side of the vehicle and 1.6 ft. (0.5 m) from the side of the vehicle
cannot be detected.
Approximately 3.3 ft. (1 m) forward of the rear bumper
Approximately 9.8 ft. (3 m) from the rear bumper
Approximately 9.8 ft. (3 m) to 197 ft. (60 m) from the rear bumper
*
* : The greater the difference in speed betwee n your vehicle and the detected vehicle is,
the farther away the vehicle will be detect ed, causing the outside rear view mirror
indicator to illuminate or flash.BSM function detection areas
WARNING ■
Cautions regarding the use of the function
The driver is solely responsible for safe driving. Always drive safely, taking care to
observe your surroundings.
The BSM function is a supplementary function which alerts the driver that a vehicle is in
a blind spot of the outside rear view mirrors or is approaching rapidly from behind into
a blind spot. Do not overly rely on the BSM function. As the function cannot judge if it is
safe to change lanes, over reliance could lead to an accident resulting in death or seri-
ous injury.
As the system may not function correctly under certain conditions, the driver’s own
visual confirmation of safety is necessary. 1
2
3
4

LX570_OM_OM60Q78U_(U) 3714-5. Using the driving support systems
4
Driving The RCTA function uses radar sensors to detect vehicles approaching from the
right or left at the rear of the vehicle an d alerts the driver of the presence of such
vehicles by flashing the outside rear view mirror indicators and sounding a
buzzer.
Approaching vehicles
Detection areas of approaching vehiclesRCTA function
1
2

400 5-3. Using the air conditioning system and defogger
LX570_OM_OM60Q78U_(U) ■
Change the airflow mode
To change the air outlets, press .
The air outlets used are switched
each time the button is pressed.
Air flows to the upper body.
Air flows to the upper body and
feet.
Air flows to the feet.
Air flows to the feet and the wind-
shield defogger operates■
Other functions ●
Switching between outside air and recirculated air modes ( → P. 405)●
Defogging the windshield ( → P. 405)●
Defogging the rear window and outside rear view mirrors ( → P. 405)1
2
3
4

LX570_OM_OM60Q78U_(U) 4055-3. Using the air conditio ning system and defogger
5
Interior features ■
Switching between outside air and recirculated air modes
Press on the control panel. The mode switches among (recirculated air mode), “AUTO” and
(outside air mode) each time is pressed.
When the system is switched to auto matic mode, it operates automatically.■
Defogging the windshield
Defoggers are used to defog the wi ndshield and front side windows.
Press on the control panel. Set the outside/recirculated air mode button to outside air mode if the recirculated
air mode is used. (It may switch automatically.)
To defog the windshield and the side wind ows early, turn the air flow and tempera-
ture up.
To return to the previous mode, press
again when the windshield is
defogged.■
Defogging the rear window and outside rear view mirrors
Defoggers are used to defog the rear window and to remove raindrops, dew
and frost from the outside rear view mirrors.
Press on the control panel. Press again to turn the defogger off.
■
Micro dust and pollen filter
Pollen is removed from the air and the air flows to the upper part of the body.
Select on the option control screen. In order to prevent the windshield from fo gging up when the outside air is cold, the
dehumidification function may operate.
The pollens are filtered out even if the micro dust and pollen filter is turned off.
■
Windshield wiper de-icer
This feature is used to prevent ice fr om building up on the windshield and
wiper blades.
Select on the option control screen. When the windshield wiper de-ice r is on, the indicator turns on.
The windshield wiper de-icer will automati cally turn off after a period of time.Other functions

408 5-3. Using the air conditioning system and defogger
LX570_OM_OM60Q78U_(U) ■
When the outside temperature is low
The dehumidification function may not operate even when is selected. ■
Micro dust and pollen filter ●
In order to prevent the windows from fogging up when the outside air is cold, the fol-
lowing may occur.
• Outside air mode does not swit ch to recirculated air mode.
• The air conditioning system operates automatically.
• The operation cancels after 1 minute. ●
In rainy weather, the windows may fog up. Press . ■
The rear window defogger, outside rear vi ew mirror defogger and windshield wiper de-
icer can be operated when
The engine switch is in IGNITION ON mode. ■
When the windshield wiper de-icer is on
The windshield wiper de-icer will automatically turn off after approximately 15 minutes.■
Ventilation and air conditioning odors ●
To let fresh air in, set the air conditioning system to the outside air mode. ●
During use, various odors from inside and outside the vehicle may enter into and accu-
mulate in the air conditioning system. This may then cause odor to be emitted from the
vents. ●
To reduce potential odors from occurring:
• It is recommended that the air conditioning system be set to outside air mode prior
to turning the vehicle off.
• The start timing of the blower may be dela yed for a short period of time immediately
after the air conditioning system is started in automatic mode.■
While the cool box is on (if equipped)
The front air conditioning sy stem cannot be turned off.■
Air conditioning filter
→ P. 501 ■
Customization
Settings (e.g. Exhaust gas sensor sensitivity) can be changed.
(Customizable features: → P. 580)
WARNING ■
To prevent the windshield from fogging up ●
Do not use during cool air operation in extremely humid weather. The differ-
ence between the temperature of the outside air and that of the windshield can cause
the outer surface of the windshield to fog up, blocking your vision.■
To prevent burns ●
Do not touch the rear view mirror surfaces when the outside rear view mirror defog-
gers are on. ●
Do not touch the glass at lower part of the windshield or to the side of the front pillars
when the windshield wiper de-icer is on.

446
LX570_OM_OM60Q78U_(U) 5-6. Using the other interior features■
Programming the HomeLink ®
Steps through must be performed within 60 seconds, otherwise the
indicator light will stop flashing and pr ogramming will not be able to be com-
pleted.
Press and release the HomeLink ®
button you want to program and check
that the HomeLink ®
indicator light flashes (orange).
Point the remote control transmit-
ter for the device at the rear view
mirror, 1 to 3 in. (25 to 75 mm)
from the HomeLink ®
buttons.Keep the HomeLink ®
indicator light
in view while programming.
Program a device. 
Programming a device other
than an entry gate (for U.S.A.
owners)
Press and hold the remote control
transmitter button until the
HomeLink ®
indicator light
changes from slowly flashing
orange to rapidly flashing green
(rolling code) or continuously lit
green (fixed code), then release
the button. 
Programming an entry gate (for U. S.A. owners)/Programming a device
in the Canadian market
Press and release the remo te control transm itter button at 2 second inter-
vals, repeatedly, until the HomeLink ®
indicator light changes from slowly
flashing (orange) to rapidly flashing (green) (rolling code) or continuously
lit (green) (fixed code).
Test the HomeLink ®

operation by pressing the newly programmed button
and observing the indicator light: ●
Indicator light illuminates: Programming of a fixed code device has com-
pleted. The garage door or other de vice should operate when a Home-
Link ®
button is pressed and released. 1 3
1
2
3
4

LX570_OM_OM60Q78U_(U) 5878-2. Customization
8
Vehicle specifications ■
Rear window wiper and washer ( → P. 235)
■
Driving position memory ( → P. 151)
■
Outside rear view mirrors ( → P. 162)Function Default setting Customized
setting
Drip prevention function On Off — — O
Rear window wiper opera-
tion linked with washer On Off — — O
Linked operation when the
shift lever in R position On Off — — O
Times of the linked opera-
tion when the shift lever in R
position Once Continuously — — O 1 2 3
Function Default setting Customized
setting
Driver’s seat movement
when exiting the vehicle Standard Off
O — O
Partial
Selection the door linking
driving position memory
with door unlock operation Driver’s door All doors — — O 1 2 3
Function Default setting Customized
setting
Automatic folding/extend-
ing operation Linked to locking/
unlocking of the
doors Off
— — O
Linked to engine
switch operation
Linked mirror function
when reversing On Off — — O 1 2 3

LX570_OM_OM60Q78U_(U) 5918-2. Customization
8
Vehicle specifications ■
LDA (Lane Departure Alert)
* ( → P. 261)
* : If equipped ■
BSM (Blind Spot Monitor) ( → P. 363)Function Default
setting Customized
setting
Alert method
(Steering
vibration) (Buzzer) — O —
Alert sensitivity Standard High — O —
Vehicle sway warning On Off — O —
Vehicle sway warning sensi-
tivity Standard Low
— O —
High 1 2 3
Function Default setting Customized set-
ting
BSM (Blind Spot Monitor) On Off — O —
RCTA (Rear Cross Traffic
Alert function) On Off — O —
Outside rear view mirror indi-
cator brightness Bright Dim O — O
Alert timing for presence of
approaching vehicle (BSM
function only) Intermediate Early
O — OLate
Only when in
blind spot
RCTA buzzer volume Level 2 Level 1
O — O
Level 3 1 2
3