2018 KIA STONIC brake sensor

Non-operational conditions of
rear parking assist system
The rear parking assist systemmay not operate properly when:
1. Moisture is frozen to the sensor. (Itwill operate normally when the
moisture has been cleared.)
2. The sensor is covered with foreign matter, such as snow or water, or
the sensor cover is blocked. (It will
operate normally when the materi‐
al is removed or the sensor is no
longer blocked.)
3. Driving on uneven road surfaces (unpaved roads, gravel, bumps, gra‐ dient).
4. Objects generating excessive noise (vehicle horns, loud motorcycle en‐
gines, or truck air brakes) are with‐
in range of the sensor.
5. Heavy rain or water spray exists.
6. Wireless transmitters or mobile phones are within range of the
sensor.
7. The sensor is covered with snow.
8. Trailer towing.
The detecting range may decreasewhen:
1. The sensor is stained with foreign matter such as snow or water. (The
sensing range will return to normal
when removed.)
2. Outside air temperature is ex‐ tremely hot or cold.
The following objects may not berecognized by the sensor:
1. Sharp or slim objects such as ropes,chains or small poles.
2. Objects which tend to absorb the sensor frequency such as clothes,
spongy material or snow.
3. Undetectable objects smaller than 1 m (40 in.) in height and narrower
than 14 cm (6 in.) in diameter.
Rear parking assist system
precautions
• The rear parking assist system may not sound consistently depending on
the speed and shapes of the objects detected. • The rear parking assist system may
malfunction if the vehicle bumper
height or sensor installation has been
modified or damaged. Any non-fac‐
tory installed equipment or accesso‐ ries may also interfere with the sen‐
sor performance.
• The sensor may not recognize ob‐ jects less than 30 cm (12 in.) from
the sensor, or it may sense an incor‐
rect distance. Use caution.
• When the sensor is frozen or stained with snow, dirt, or water, the sensor
may be inoperative until the stains
are removed using a soft cloth.
• Do not push, scratch or strike the sensor. Sensor damage could occur.
NOTICE
This system can only sense objects
within the range and location of the
sensors; It can not detect objects in
other areas where sensors are not
installed. Also, small or slim objects,
such as poles or objects located be‐
(Continued)

4-77
4
Features of your vehicle

Engine exhaust can be dangerous!........................................ 6-03
Before driving............................................................................ 6-04Before entering vehicle........................................................ 6-04
Necessary inspections..........................................................6-04
Before starting...................................................................... 6-04
Key positions..............................................................................6-06 Ignition switch position........................................................ 6-06
Starting the engine............................................................... 6-07
ENGINE START/STOP button ..................................................6-10 Illuminated ENGINE START/STOP button.......................... 6-10
ENGINE START/STOP button position............................... 6-10
Starting the engine............................................................... 6-12
ISG (Idle Stop and Go) system ............................................... 6-16 Auto stop................................................................................ 6-16
Auto start............................................................................... 6-17
Condition of ISG system operation.................................... 6-18
ISG system deactivation...................................................... 6-18
ISG system malfunction.......................................................6-19
Manual transaxle ......................................................................6-20 Manual transaxle operation................................................ 6-20
Good driving practices.......................................................... 6-22
Automatic transaxle................................................................. 6-24 Automatic transaxle operation...........................................6-24
Good driving practices.......................................................... 6-28
Brake system.............................................................................6-30 Power brakes......................................................................... 6-30
Parking brake......................................................................... 6-31
Anti-lock brake system (ABS) ........................................... 6-34
Electronic stability control (ESC) ....................................... 6-36
Hill-start assist control (HAC) ............................................ 6-39 Vehicle stability management (VSM) ............................... 6-39
ESS : Emergency Stop Signal ............................................. 6-40
Good braking practices.........................................................6-41
Cruise control system ............................................................. 6-43 Cruise control switch............................................................ 6-44
To set cruise control speed:................................................ 6-44
To increase cruise control set speed:................................ 6-46
To decrease the cruising speed:......................................... 6-46
To temporarily accelerate with the cruise control on:.... 6-47
To cancel cruise control, do one of the following:........... 6-47
To resume cruising speed at more than approxi‐
mately 30 km/h (20 mph):.................................................. 6-48
To turn cruise control off, do one of the following:........ 6-49
Speed limit control system .................................................... 6-50 Speed limit control switch................................................... 6-50
To set speed limit:................................................................. 6-50
To turn off the speed limit control, do one of
the following:......................................................................... 6-51
Forward Collision-Avoidance Assist (FCA) System ............. 6-53 System setting and activation............................................6-53
FCA warning message and system control...................... 6-54
Brake operation..................................................................... 6-55
Sensor to detect the distance from the vehicle
in front (front radar)............................................................ 6-56
System malfunction............................................................. 6-57
Limitation of the system..................................................... 6-58
Recognizing pedestrians...................................................... 6-60
Lane Departure Warning (LDW) System .............................. 6-62 Warning indicator.................................................................. 6-64
Driving your vehicle

6

NOTICE
•Do not install any accessories,
such as license plate molding or
sticker, on the sensor area. Nor ar‐
bitrarily replace the bumper.
Those may adversely affect the
sensing performance.
•Always keep the sensor/bumper
area clean.
•Use only soft clothes to wash the
vehicle. Also, do not spray highly-
pressurized water on the sensor
installed on the bumper.
•Be careful not to apply unnecessa‐
ry force on the frontal sensor
area. When the sensor moves out
of the correct position due to ex‐
ternal force, the system may not
normally operate even without the
warning light or message. In this
case, have the vehicle inspected by
a professional workshop. Kia rec‐
ommends to visit an authorized
Kia dealer/service partner.
(Continued)
(Continued)
•Use only the genuine Kia sensor
cover. Do not arbitrarily apply
paint on the sensor cover.
System malfunction
0:#-
• When the FCA is not working proper‐ly, the FCA warning light () will illu‐
minate and the warning message will
appear for a few seconds.
After the message disappears, the
master warning light (
) will illumi‐
nate. In this case, have the vehicle in‐
spected by a professional workshop.
Kia recommends to visit an author‐
ized Kia dealer/service partner. • The FCA warning message may ap‐
pear along with the illumination of
the ESC warning light.
WARNING
•The FCA is only a supplementalsystem for the driver’s conven‐ience. The driver should hold theresponsibility to control the vehicleoperation. Do not solely depend onthe FCA system. Rather, maintaina safe braking distance, and, ifnecessary, depress the brake ped‐al to lower the driving speed.
•The FCA may unnecessarily pro‐duce the warning message and thewarning alarms. Also, due to thesensing limitation, the FCA maynot produce the warning messageand the warning alarm at all.
•When there is a malfunction withthe FCA, the braking control doesnot operate upon detecting a colli‐sion risk even with other brakingsystems normally operating.
(Continued)

6-57
6
Driving your vehicle

(Continued)
•The FCA operates only for the ve‐hicle / pedestrian in front, whiledriving forward. It does not oper‐ate for any animals or vehicles inthe opposite direction.
•The FCA does not recognize thevehicle, which horizontally drivesacross the crossroad, or the vehi‐cle, which is parked in the horizon‐tal direction.
Limitation of the system
The FCA is an assistant system for a
driver in a certain risky driving condition
and it does not take every responsibili‐ ty for all risks from driving condition.
The FCA monitors the driving situations
through the radar and the camera sen‐
sor. Thus, for a situation out of the sensing range, the FCA may not nor‐
mally operate. The driver should pay
great caution in the following situa‐ tions. The FCA operation may be limi‐
ted.
Recognizing vehicles
- The radar or the camera is contami‐
nated with foreign substances.
- It heavily rains or snows. -
There is interruption by electric
waves.
- There is severe irregular reflection
from the radar.
- The vehicle in front has a narrow
body. (i.e. motor cycle and bicycle)
- The driver’s view is unclear due to
the backlight, the reflected light, or
darkness.
- The camera cannot contain the full
image of the vehicle in front.
- The vehicle in front is a special vehi‐
cle, such as a heavily-loaded truck or
a trailer.
The vehicle in front does not turn ON
the rear lights, does not have rear
lights, has asymmetric rear lights, or
has rear lights out of angle.
- The outside brightness is greatly
changed, such as entering/exiting the tunnel.
- The vehicle driving is unstable.
- The radar/camera sensor recognition
is limited.
- Driving on unpaved and uneven road
surfaces, or through sudden gradient changes. -
In construction zones or on railroad
tracks, or there are metallic objects
on the road.
- Driving indoors such as in an under‐
ground parking lot.
- Driving on a curve
The FCA performance decreases
while driving on a curve. The FCA may
not recognize the vehicle in front even in the same lane. It may unnec‐
essarily produce the warning mes‐
sage and the warning alarm, or it
may not produce the warning mes‐
sage and the warning alarm at all.
While driving on a curve, pay great caution, and, if necessary, depress
the brake pedal.
Driving your vehicle
6-58

-When the stopped vehicle in front
gets out of the lane, it may not be
recognized by your FCA. Always pay great attention.
- Recognizing the vehicle
When the vehicle in front has heavy
loading extended rearward, or when
the vehicle in front has higher ground clearance, it may induce a hazardous
situation.
Recognizing pedestrians
- The pedestrian is not fully captured
by the camera sensor, or the pedes‐
trian does not walk in the upright po‐ sition.
- The pedestrian moves very fast.
- The pedestrian abruptly appears in
front.
- The pedestrian wears clothes in the
color similar to the background.
- The outside is too bright or too dark.
- The vehicle drives at night or in the
darkness.
- There is an item similar to a person’s
body structure.
- The pedestrian is small.
- The pedestrian has impaired mobility.
- It is difficult to distinguish the pedes‐
trian from the surroundings.
- The sensor recognition is limited. -
There is a group of pedestrians.
WARNING
•Cancel the FCA in the User Set‐tings on the LCD display, beforetowing another vehicle. While tow‐ing, the brake application may ad‐versely affect your vehicle safety.
•Pay great caution to the vehicle infront, when it has heavy loadingextended rearward, or when it hashigher ground clearance.
•The sensor only detects pedes‐trian, not carts, bicycles, motorcy‐cles, luggage bags, or strollers.
•The FCA does not operate in a cer‐tain situation. Thus, never test-operate the FCA against a personor an object. It may cause a severeinjury or even death.
•When reinstalling the windshield orLane Departure Warning (LDW)camera after replacement or re‐moval, have the vehicle inspectedby a professional workshop. Kiarecommends to visit an authorizedKia dealer/service partner.
Driving your vehicle

6-60

APPEARANCE CARE
Exterior care
Exterior general caution
It is very important to follow the label
directions when using any chemical cleaner or polish. Read all warning and
caution statements that appear on the
label.
Finish maintenance
Washing
To help protect your vehicle’s finish
from rust and deterioration, wash it thoroughly and frequently at least once
a month with lukewarm or cold water.
If you use your vehicle for off-road
driving, you should wash it after each off-road trip. Pay special attention to
the removal of any accumulation of
salt, dirt, mud, and other foreign mate‐ rials. Make sure the drain holes in the
lower edges of the doors and rocker
panels are kept clear and clean.
Insects, tar, tree sap, bird droppings, in‐ dustrial pollution and similar deposits
can damage your vehicle’s finish if not
removed immediately.
Even prompt washing with plain water
may not completely remove all these
deposits. A mild soap, safe for use on
painted surfaces, may be used. After washing, rinse the vehicle thor‐
oughly with lukewarm or cold water. Do
not allow soap to dry on the finish.
CAUTION
•Do not use strong soap, chemicaldetergents or hot water, and donot wash the vehicle in direct sun‐light or when the body of the vehi‐cle is warm.
•Be careful when washing the sidewindows of your vehicle.Especially, with high-pressure wa‐ter, water may leak through thewindows and wet the interior.
•To prevent damage to the plasticparts and lamps, do not clean withchemical solvents or strong deter‐gents.
WARNING
nWet brakes
After washing the vehicle, test thebrakes while driving slowly to see if
(Continued)
(Continued)
they have been affected by water. Ifbraking performance is impaired, drythe brakes by applying them lightlywhile maintaining a slow forwardspeed.
High-pressure washing
• When using high-pressure washers, make sure to maintain sufficient dis‐
tance from the vehicle.
Insufficient clearance or excessive pressure can lead to component
damage or water penetration.
• Do not spray the camera, sensors or its surrounding area directly with a
high pressure washer. Shock applied
from high pressure water may cause the device to not operate normally.
• Do not bring the nozzle tip close to boots (rubber or plastic covers) or
connectors as they may be damaged
if they come into contact with high
pressure water.
Maintenance
8-128