857
Maintenance
Temperature -A, B & C
The temperature grades are A (the
highest), B and C representing the
tire’s resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled condi-
tions on a specified indoor laboratory
test wheel.
Sustained high temperature can
cause the material of the tire to
degenerate and reduce tire life, and
excessive temperature can lead to
sudden tire failure. The grade C cor-
responds to a level of performance
which all passenger car tires must
meet under the Federal Motor
Vehicle Safety Standard No. 109.
Grades B and A represent higher
levels of performance on the labora-
tory test wheel than the minimum
required by law.Tire terminology and defini-
tions
Air Pressure:The amount of air
inside the tire pressing outward on
the tire. Air pressure is expressed in
kilopascal (kPa) or pounds per
square inch (psi).
Accessory Weight: This means the
combined weight of optional acces-
sories. Some examples of optional
accessories are, dual clutch trans-
mission, power seats, and air condi-
tioning.
Aspect Ratio: The relationship of a
tire's height to its width.
Belt: A rubber coated layer of cords
that is located between the plies and
the tread. Cords may be made from
steel or other reinforcing materials.
Bead: The tire bead contains steel
wires wrapped by steel cords that
hold the tire onto the rim.
Bias Ply Tire: A pneumatic tire in
which the plies are laid at alternate
angles less than 90 degrees to the
centerline of the tread. Cold Tire Pressure:
The amount of
air pressure in a tire, measured in
kilopascals (kPa) or pounds per
square inch (psi) before a tire has
built up heat from driving.
Curb Weight: This means the weight
of a motor vehicle with standard and
optional equipment including the
maximum capacity of fuel, oil and
coolant, but without passengers and
cargo.
DOT Markings: A code molded into
the sidewall of a tire signifying that
the tire is in compliance with the U.S.
Department of Transportation motor
vehicle safety standards. The DOT
code includes the Tire Identification
Number (TIN), an alphanumeric des-
ignator which can also identify the
tire manufacturer, production plant,
brand and date of production.
Maintenance
110
8
Keep paint and trim in good con-
dition
Scratches or chips in the finish
should be covered with "touch-up"
paint as soon as possible to reduce
the possibility of corrosion. If bare
metal is showing through, the atten-
tion of a qualified body and paint
shop is recommended.
Bird droppings : Bird droppings are
highly corrosive and may damage
painted surfaces in just a few hours.
Always remove bird droppings as
soon as possible.
Don't neglect the interior
Moisture can collect under the floor
mats and carpeting and cause corro-
sion. Check under the mats periodi-
cally to be sure the carpeting is dry.
Use particular care if you carry fertil-
izers, cleaning materials or chemi-
cals in the vehicle.
These should be carried only in prop-
er containers and any spills or leaks
should be cleaned up, flushed with
clean water and thoroughly dried.Interior care
Interior general precautions
Prevent chemicals such as perfume,
cosmetic oil, sun cream, hand clean-
er, and air freshener from contacting
the interior parts because they may
cause damage or discoloration. If
they do contact the interior parts,
wipe them off immediately. If neces-
sary, use a vinyl cleaner, see product
instructions for correct usage.
CAUTION - Electrical
components
Never allow water or other liq-
uids to come in contact withelectrical/electronic compo-nents inside the vehicle as thismay damage them.
CAUTION - Leather
When cleaning leather products(steering wheel, seats etc.), useneutral detergents or low alco-hol content solutions. If you usehigh alcohol content solutionsor acid/alkaline detergents, thecolor of the leather may fade orthe surface may get stripped off.
8111
Maintenance
Taking care of leather seats
Vacuum the seat periodically toremove dust and sand on the seat.
It will prevent abrasion or damage of
the leather and maintain its quality.
Wipe the natural leather seat cover often with dry or soft cloth.
Sufficient use of a leather protec- tive may prevent abrasion of the
cover and helps maintain the color.
Be sure to read the instructions
and consult a specialist when
using leather coating or protective
agents.
Leather with bright colors(beige, cream beige) is easily contaminat-
ed and clear in appearance. Clean
the seats frequently.
Avoid wiping with wet cloth. It may cause the surface to crack.
Cleaning the leather seats
Remove all contaminations instant-ly. Refer to instructions below for
removal of each contaminant.
Cosmetic products(sunscreen, foundation, etc.)
- Apply cleansing cream on a clothand wipe the contaminated point.
Wipe off the cream with a wet
cloth and remove water with a dry
cloth.
Beverages(coffee, soft drink, etc.) - Apply a small amount of neutraldetergent and wipe until contami-
nations do not smear.
Oil - Remove oil instantly withabsorbable cloth and wipe with
stain remover for natural leather
only.
Chewing gum - Harden the gum with ice andremove gradually.
Fabric seat cover using precau-
tions (If equipped)
Please clean the fabric seats regu-
larly with a vacuum cleaner in con-
sideration of fabric material charac-
teristics. If they are heavily soiled
with beverage stains, etc., use a suit-
able interior cleaner. To prevent dam-
age to seat covers, wipe off the seat
covers down to the seams with a
large wiping motion and moderate
pressure using a soft sponge or
microfiber cloth.
Velcro closures on clothing or sharp
objects may cause snagging or
scratches on the surface of the
seats. Make sure not to rub such
objects against the surface.
I11
Index
Non-operational conditions of rear parking assist system. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-10\
8
Rear parking assist system precautions . . . . . . . . . 4-109
Self-diagnosis . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-109
Rear seat adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-14
Rear view camera . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-115
Recommended lubricants and capacities . . . . . . . . . . . . 9-7 Recommended SAE viscosity number. . . . . . . . . . . . 9-8
Record your key number . . . . . . . . . . . . . . . . . . . . . . . . 4-4
Reducing the risk of a rollover . . . . . . . . . . . . . . . . . . . 6-89
Refrigerant label . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-11
Remote control (Outside rear view mirror) . . . . . . . . . 4-51
Reporting safety defects . . . . . . . . . . . . . . . . . . . . . . . . 9-16
Resetting the sunroof . . . . . . . . . . . . . . . . . . . . . . . . . . 4-42
Road warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-2
Rocking the vehicle . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-91
Room lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-125
Room lamp (Bulb type) bulb replacement . . . . . . . . . 8-103
Room lamp (LED type) bulb replacement . . . . . . . . . 8-104
Rotation (Tire) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-50
Scheduled maintenance service . . . . . . . . . . . . . . . . . . . 8-9 Normal maintenance schedule . . . . . . . . . . . . . . . . . 8-10
Maintenance under severe usage conditions . . . . . . 8-21
Seat belt restraint system . . . . . . . . . . . . . . . . . . . . . . . 3-19
Seat belt warning (Front) . . . . . . . . . . . . . . . . . . . . . . . 3-21 Seat belts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
3-19
Seat belt restraint system . . . . . . . . . . . . . . . . . . . . . 3-19
Seat belt warning (Front) . . . . . . . . . . . . . . . . . . . . . 3-21
"Driver's 3-point systemwith emergency locking retractor". . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . 3-22
Pre-tensioner seat belt . . . . . . . . . . . . . . . . . . . . . . . 3-26
Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-28
Care of seat belts . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-30
Seat warmer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-152
Seatback pocket (Front) . . . . . . . . . . . . . . . . . . . . . . . . 3-14
Seats . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . 3-2 Headrest(Front) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-11
Seatback pocket (Front) . . . . . . . . . . . . . . . . . . . . . . 3-14
Rear seat adjustment . . . . . . . . . . . . . . . . . . . . . . . . 3-14
Headrest (Rear) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-14
Armrest (Rear) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-15
Folding the rear seat . . . . . . . . . . . . . . . . . . . . . . . . . 3-16
Important safety precautions . . . . . . . . . . . . . . . . . . . 3-2
Front seat adjustment (Manual) . . . . . . . . . . . . . . . . . 3-7
Front seat adjustment (Power) . . . . . . . . . . . . . . . . . . 3-8
Driver position memory system . . . . . . . . . . . . . . . . . 3-9
"Securing a child restraint seatwith " "Tether Anchor" "system" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-38\
"Securing a child restraint with alap/shoulder belt" . . . 3-39
"Securing a child restraint withthe LATCH anchors system" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-\
37
Shift-lock override - Dual clutch transmission. . . . . . . 6-20
Side air bag . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-60\
S