2018 Hyundai Sonata Plug-in Hybrid light

[x] Cancel search: light

Page 446 of 552

Hyundai Sonata Plug-in Hybrid 2018  Owners Manual 7-51
7
Maintenance
Instrument panel fuse replace-
ment
1. Turn the hybrid system off.
2. Turn all other switches OFF.
3. Open the fuse panel cover.
4. Refer to the label on the inside ofthe fuse panel

Page 451 of 552

Hyundai Sonata Plug-in Hybrid 2018  Owners Manual Maintenance
Fuse NameFuse ratingCircuit Protected
MODULE 7 10ADriver/Passenger Door Module, Electric Parking Brake Module, AMP, Digital Clock, Blind Spot
Detection Rader LH/RH, Rear Parking Assist Sen

Page 453 of 552

Hyundai Sonata Plug-in Hybrid 2018  Owners Manual 7-58
Maintenance
Fuse NameFuse ratingCircuit Protected
MODULE 510AFront Console Switch, Active Air Flap Unit, BMS Control Module, Fuel Filler Door & Trunk Lid Switch,
Smart Cruise Control Unit, Tire P

Page 462 of 552

Hyundai Sonata Plug-in Hybrid 2018  Owners Manual 7-67
7
Maintenance
L
LI
IG
G H
H T
T 
 B
B U
U L
LB
B S
S
Consult an authorized HYUNDAI
dealer to replace most vehicle light
bulbs. It is difficult to replace vehicle
light bulbs because other parts o

Page 463 of 552

Hyundai Sonata Plug-in Hybrid 2018  Owners Manual 7-68
Maintenance
Headlamp, parking lamp,
turn signal lamp and side
marker light bulb replacement(1) Headlamp (Low)
(2) Headlamp (High)
(3) Turn signal lamp
(4) Side marker lamp
(5) Daytime running lam

Page 467 of 552

Hyundai Sonata Plug-in Hybrid 2018  Owners Manual 7-72
Maintenance
Rear combination light bulb
replacement
(1) Stop/Tail lamp
(2) Turn signal lamp
(3) Tail lamp
(4) Back-up lamp
(5) Rear side marker (LED) (if equipped)
Stop/Tail lamp and Turn signal

Page 469 of 552

Hyundai Sonata Plug-in Hybrid 2018  Owners Manual 7-74
Maintenance
High mounted stop lamp
1. Remove the rear seat cushionassembly.
2. Remove the rear seat back assem- bly.
3. Slightly remove the rear door weather-strip.
4. Remove the rear door scuff

Page 470 of 552

Hyundai Sonata Plug-in Hybrid 2018  Owners Manual 7-75
7
Maintenance
1. Using a flat-head screwdriver,gently pry the lens from the interi-
or light housing.
2. Remove the bulb by pulling it straight out.
3. Install a new bulb in the socket.
4. Align