2018 HYUNDAI I20 engine

)' 
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
We recommend the air conditioning
system be serviced by an authorized
HYUNDAI dealer.
WWindshield defrosting and defog-
ging
• For maximum defrosting, set the
temperature control to the extreme
right/hot position and the fan speed
control to the highest speed.
• If warm air to the floor is desired while defrosting or defogging, set
the mode to the floor-defrost posi-
tion.
• Before driving, clear all snow and ice from the windshield, rear win-
dow, outside rear view mirrors, and
all side windows.
• Clear all snow and ice from the hood and air inlet at the buttom of
the windshield.
• If the engine temperature is still cold after starting, then a brief
engine warm up period may be
required for the vented air flow to
become warm or hot.
Because the refrigerant
is at very high pressure,
the air conditioning sys-
tem should only be serv-
iced by trained and certi-
fied technicians. It is important that
the correct type and amount of oil
and refrigerant is used, otherwise
damage to the vehicle and personal
injury may occur.WARNING
Do not use the or position
during cooling operation in
extremely humid weather. The dif-
ference between the temperature
of the outside air and that of the
windshield could cause the outer
surface of the windshield to fog
up, causing loss of visibility. Set
the mode selection to the
position and fan speed control to a
lower speed.
WARNING

UUSB charger (if equipped)The USB charger is designed to
recharge batteries of small size elec-
trical devices using a USB cable.
The electrical devices can be
recharged when the Engine Start/
Stop button is in the ACC, ON or
START position.
The battery charging state may be
monitored on the electrical device.
Disconnect the USB cable from the
USB port after use. • A smart phone or a tablet PC may
get warmer during the re-charging
process. It does not indicate any
malfunction with the charging sys-
tem.
• A smart phone or a tablet PC, which adopts a different re-charg-
ing method, may not be properly
re-charged. In this case, use an
exclusive charger of your device.
• The charging terminal is only to recharge a device. Do not use the
charging terminal either to turn ON
an audio or to play media on the
AV N .
Clothes hanger (if equipped)These hangers are not designed to
hold large or heavy items.
OIB044031
OIB047195R
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
)' 

##!'%$&%" '&$HHow vehicle audio worksAM and FM radio signals are broad-
cast from transmitter towers located
around your city. They are intercepted
by the radio antenna on your vehicle.
This signal is then processed by the
radio and sent to your vehicle speak-
ers.
When a strong radio signal has reached your vehicle, the precise
engineering of your audio system
ensures the best possible qualityreproduction. However, in some cases
the signal coming to your vehicle may
not be strong and clear. This can be due to factors, such as
the distance from the radio station,
closeness of other strong radio sta-
tions or the presence of buildings,
bridges or other large obstructions in
the area.
AM broadcasts can be received at
greater distances than FM broad-
casts. This is because AM radio
waves are transmitted at low fre-
quencies. These long distance, low
frequency radio waves can follow the
curvature of the earth rather than
travelling straight. In addition, they
curve around obstructions resulting
in better signal coverage.
JBM001
FM reception
JBM002
AM reception

#!'%$&%" '&$
IInformation- Using the USB Device
• Connect the USB device after turn-
ing on the engine. The USB device
may become damaged if it is already
connected when the ignition is
turned on. The USB device may not
operate properly if the car ignition
is turned on or off with the USB
device connected.
• Be careful for static electricity when connecting/disconnecting USB
devices.
• Encoded MP3 Players will not be recognized when connected as an
external device.
• When connecting an external USB device, the vehicle’s audio system
may not recognize the USB depend-
ing on what firmware is used by
USB device or what files are on the
USB.
• Only products formatted with byte/sectors under 64Kbyte will be
recognized.
(Continued)(Continued)
• This device recognizes USB devices
formatted in FAT 12/16/32 file for-
mats. This device does not recognize
files in NTFS file format.
• Some USB devices may not be sup- ported due to compatibility issues.
• Avoid contact between the USB con- nector and bodily parts or foreign
objects.
• Repeated connecting/disconnecting of USB devices within short periods
of time may result in product mal-
function.
• A strange noise may occur when dis- connecting the USB.
• Make sure to connect/disconnect external USB devices with the audio
power turned off.
• The amount of time required to rec- ognize the USB device may differ
depending on the type, size or file
formats stored on the USB. Such
differences in time are not indica-
tions of malfunctions.
• The vehicle audio system only sup- ports USB devices designed to play
music files.
(Continued)(Continued)
• USB images and videos are not sup-
ported.
• Do not use the USB interface to charge batteries or USB accessories
that generate heat. Doing so may
lead to worsened performance or
damage to the audio system.
• The audio system may not recognize the USB device if separately pur-
chased USB hubs and extension
cables are being used. Connect the
USB device directly with the USB
port of the vehicle.
• When using mass storage USB devices with separate logical drives,
only files saved to the root drive can
be played.
• Files may not properly operate if application programs are installed
on the USBs.
• The audio system may not operate normally if MP3 Players, cellular
phones, digital cameras, or other
electronic devices (USB devices not
recognized as portable disk drives)
are connected with the audio sys-
tem.
(Continued)i

##!'%$&%" '&$Delete DevicesPress the [
[
SETUP/CLOCK]
button 
Select [Phone]  Select [Delete
Devices].
• Displays the paired Bluetooth
®
device list.
• When selecting from the list, the device is deleted.
Information
• When you delete a paired device, theCall History and Contacts stored in
the head unit are also deleted.
• To re-use a deleted device, you must pair the device again.Connection PriorityPress the
[SETUP/CLOCK]
button 
Select [Phone]  Select [Connection
Priority].
• Select the device to want to set the connection priority of paired
devices.
• If “None” is chosen, the Bluetooth
®
system will try to connect to the
last connected device, then to all
paired devices.
Information
• When the engine is running, the selected Bluetooth
®
device is auto-
matically connected. If you fail to
connect the selected device, the pre-
viously-connected device is auto-
matically connected, and if it also
fails, then it tries to connect all
paired devices sequentially.
• Depending on auto connection pri- ority, connection to a device may
take time.
• If a Bluetooth
®
device becomes dis-
connected due to being out of com-
munication range, turning the
device OFF, or a Bluetooth
®
com-
munication error, corresponding
Bluetooth
®
devices are automatical-
ly searched and reconnected.
• Even if you are outside, the Bluetooth
®
device will be automatically connected
once you are in the vicinity of the vehi- cle. If you do not want to automatical-
ly connect your Bluetooth
®
device,
turn off the Bluetooth
®feature in your
Bluetooth
®device.
(Continued) (Continued)
• In some Bluetooth
®devices, starting
the ignition while talking through
Bluetooth
®
enabled handsfree call
will result in the call becoming dis-
connected due to car handsfree call
transfer. If you use your phone out-
side the vehicle, turn off the
Bluetooth
®
feature in your phone.
LanguagePress the
[SETUP/CLOCK]
button 
Select [Language].
• Changes the display language.
Display OffPress the
[SETUP/CLOCK]
button 
Select [Display Off].
• Audio operation is maintained and only the screen will be turned Off.
In the Screen Off state, press any
button to turn the Screen On again.
i
i

#!'%$&%" '&$
(5) M
M
ODE
• If any media is connected, each
time this is pressed, it toggles
between the connected media
modes & radio modes (FM, AM,
DRM).
• If no media is connected, each time this is pressed, it toggles
between the radio modes (FM ➟
AM ➟DRM ➟FM).
• Press and hold the button to turn off.
(6)
UP/DOWN
• Press the button in radio mode to cycle between the FM/AM and
DRM frequencies in the order as
stored in the presets.
• Press and hold the button in radio mode to search for the next avail-
able frequency.
• Press the button in media mode to change the current song. (except
AUX)
• Press and hold the button in media mode to quick search through
songs. (except Bluetooth
®(BT)
Audio and AUX)
• Do not stare at the screen while driving. Staring at the screen for
prolonged periods of time could
lea d to traffic accidents.
• Do not disassemble, assemble, or modify the audio system.
Such acts could resul t in acci-
dents, fire, or electric shock.
• Using the phone while driving may lead to a lack of attention of
traffic conditions and increase
the likelihood of accidents. Use
the phone feature after parking
the vehicle.
• Exercise caution not to spill water or introduce foreign
objects into the device. Such
acts co uld lead to smoke, fire, or
product malfunction.
(Continued)
WARNING
(Continued)
• Please refrain from use if the screen is blank or no sound can
be heard as these signs may
i ndicate product malfunction.
Continued use in such conditions
could lead to accidents (fires,
electric s hock) or product mal-
functions.
• Do not touch the antenna during thunder or lightening as such
acts may lead to lightning
induced electric shock.
• Do not stop or park in parking- restricted areas to operate the
product. Such acts could lead to
traffic accidents.
• Use the system with the vehicle engine turned o n. Prolonged
use with the ignition turned on
only could result in battery dis-
charge.

#
!'%$&%" '&$
••Operating the device while driving
could lead to accidents due to a
lack of attention to external sur-
roundings. First park the vehicle
before operating the device.
• Adjust the volume to levels that allow t he driver to hear sounds
from outside of the vehicle. Driving
in a state where external sounds
cannot be heard may lead to acci-
dents.
• Pay attention to the volume setting when turning the device on. A sud-
d en output of extreme volume
upon turning the device on could
lead to hearing impairment. (Adjust
the vol ume to a suitable levels
before turning off the device.)
(Continued)(Continued)
• Turn on the car engine
before
using this device. Do not operate
the audio system for long periods
of time only with the ignitio n turned
on as such operations may lead to
battery discharge.
• Do not subject the device to severe shock or impact. Direct pressure
onto the front side of the monitor
may cause damage to the LCD.
• When cleaning the device, make sure to turn off the device and usea dry and smooth cloth. Never use
tough materials , chemical cloths,
or solvents (alcohol, benzene, thin-
ners, etc.). As such materials may
damage the de vice panel or cause
color/quality deterioration.
(Continued)NOTICE
Driving while distracted can result
in a loss of vehicle control that
may lead to an accident, severe
pe rsonal injury, and death. The
driver’s primary responsibility is in
the safe and legal operation of a
ve hicle, and use of any handheld
devices, other equipment, or vehi-
cle systems which take the dri-
ver’s eyes, attention and focus
away from the safe operation of a
vehicle or which are not permissi-
ble by la w should never be used
during operation of the vehicle.
WARNING

#
!'%$&%" '&$
TT he scroll feature can be used to dis-
play file and folder names that are
too long to display on the s creen.Languages supported (Unicode sup-
port)• Korean: 2,604 characters
• English: 94 characters
• Common Chinese characters:
4,888 characters
• Special symbols: 986 charactersJapanese/Simplified Chinese charac-
ters are not supported.
Information- Using the USB Devices
• Starting the vehicle while a USB device is connected can damage the
device. Please disconnect USB
devices before starting the vehicle.
• Starting the vehicle or stopping the engine while an external USB device
is connected can result in failure of
the external USB device to operate.
• Be cautious of static electricity when connecting/disconnecting external
USB devices.
• An encrypted MP3 player is not rec- ognized when connected as an exter-
nal device.
• External USB devices may not be recognized, depending on the state
of the external USB device.
• Only products with byte/sectors for- matted at 4 KB or lower are recog-nized.
• Only USB devices in FAT12/16/32 format are recognized; NTFS and
ExFAT file systems are not recog-
nized.
• Some USB devices are not recog- nized due to compatibility issues.
(Continued)(Continued)
• Do not touch the USB connections.
• Connecting and disconnecting USB
devices rapidly over a short period
of time can cause equipment failure.
• Abnormal sounds may be audible when the USB device is disconnect-
ed.
• Turn the audio off before connecting or disconnecting external USB
devices.
• Recognition may take longer depending on the type, capacity or
file format of the external USB
device. This is not a product mal-
function.
• Use of USB devices for purposes other than playing music files is pro-
hibited.
• Image display and video playback are not supported.
• Use of USB accessories, including charge and heat through the USB
interface, can lead to reduced prod-
uct performance or malfunctions.
Do not use USB devices or acces-
sories for these purposes.
(Continued)
NOTICENOTICE
i