2018 HYUNDAI I20 brake

)')
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
OOpening the hood 1. Make sure the shift lever is in P
(Park, for Continuously Variable
Transaxle vehicle) or first gear or
R (Reverse, for Manual Transaxle
vehicle) and set the parking brake.
2. Pull the release lever to unlatch the hood. The hood should pop
open slightly. 3. Go to the front of the vehicle, raise
the hood slightly, push the second-
ary latch up (1) inside of the hood
center and lift the hood (2). 4. Pull out the support rod.
5. Hold the hood opened with the
support rod.&& 
OIB047050
OIB044047
OIB044052
The support rod must be inserted
completely into the hole provided
whenever you inspect the engine
compartment. This will prevent the
hood from falling and possibly
injuring you.
WARNING

)'
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
IInformation
Make sure to refuel your vehicle
according to the "Fuel Requirements"
suggested in the foreword chapter.
Do not spill fuel on the exterior sur- faces of the vehicle. Any type of fuel
spilled on painted surfaces may
damage the paint.If the fuel filler cap requires replace-
ment, use only a genuine HYUNDAI
cap or the equivalent specified for
your vehicle. An incorrect fuel filler cap
can result in a serious malfunction of
the fuel system or emission control
system.NOTICEi
(Continued)•
When refueling, always move
the shift lever to the P (Park)
position (for Continuously
Variable Transaxle vehicle) or
first gear or R (Reverse) position
(for Manual Transaxle vehicle),
set the parking brake, and place
the ignition switch to the
LOCK/OFF position. Sparks
produced by electrical compo-
nents related to the engine can
ignite fuel vapors causing a fire.
•
Do not use matches or a lighter
and do not smoke or leave a lit
cigarette in your vehicle while at
a gas station, especially during
refueling.
•
Do not over-fill or top-off your
vehicle tank, which can cause
petrol spillage.
(Continued)
(Continued)•
If a fire breaks out during refuel-
ing, leave the vicinity of the vehi-
cle, and immediately contact the
manager of the gas station and
then contact the local fire
department. Follow any safety
instructions they provide.
•
If pressurized fuel sprays out, it
can cover your clothes or skin
and thus subject you to the risk
of fire and burns. Always
remove the fuel cap carefully
and slowly. If the cap is venting
fuel or if you hear a hissing
sound, wait until the condition
stops before completely remov-
ing the cap.
•
Always check that the fuel cap is
installed securely to prevent fuel
spillage in the event of an acci-
dent.

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3Types of warning indicator and
sound
••If an object is in between sensors
or close to a sensor, the displayed
indicator may differ from the above
illustration.
• Do not wash the vehicle's sensor with high pressure water.
• When you shift into the R (Reverse) position and one or
more of the below situation occurs,
this may indicate a malfunction
with the parking assist system.
• You don't hear an audible warning sound or the buzzer sounds inter-
mittently.
If this occurs, we recommend that
the system be checked by an
authorized HYUNDAI dealer.
Non-operational conditions of Parking Distance Warning(Reverse) SystemThe Parking Distance Warning
(Reverse) System may not operate
normally when:• Moisture is frozen to the sensor.
• The sensor is covered or stained
with foreign material, such as snow
or water, or the sensor cover is
blocked.There is a possibility of a parking
assist system malfunction when:• Driving on uneven road surfacessuch as unpaved roads, gravel,
bumps, or gradient.
• Objects generating excessive noise such as vehicle horns, loud motor-
cycle engines, or truck air brakes
can interfere with the sensor.
• Heavy rain or water spray is present.
• Wireless transmitters or mobile phones are present near the sensor.
• The sensor is covered with snow.
• Any non-factory equipment or accessories have been installed, or
if the vehicle bumper height or sen-
sor installation has been modified.
NOTICE
Distance from
object
Warning
indicator
Warning sound
120cm ~ 61cm
(47 in. ~ 24 in.)
Buzzer beeps
intermittently.
60cm ~ 31cm
(24 in. ~ 12 in.)
Buzzer beeps
more frequently.
Less than
30 cm (12 in.)
Buzzer beeps continuously.
• is displayed. (if equipped)

Key ignition switch
(if equipped)
(&($( &
"W($

+)
!-0,0*&."'$-.,/#0%(/
OIB\f54\f1\f
To reduce the risk of SERIOUS
INJURY or DEATH\b take the fol
lowing precautions:
•NEVER allow children or any
person who is unfamiliar with
the vehicle to touch the ignition
switch or related parts.
Unexpected and sudden vehicle
movement can occur.
•NEVER reach through the steer
ing wheel for the ignition switch\b
or any other control\b while the
vehicle is in motion. The pres
ence of your hand or arm in this
area may
cause a loss of vehicle
control resulting in an accident.
WARNING
•NEVER turn the ignition switch
to the LOCK or ACC position
while the vehicle is in motion
except in an emergency. This
will result in the engine turning
off and loss of power assist for
the steering and brake systems.
(Continued)
(Continued)
This may lead to loss of direc
tional control and braking func
tion\b which could cause an acci
dent.
•Before leaving the driver’s seat\b
always make sure the shift lever
is in 1st gear (for Manual
Transaxle vehicle) or P (Park)
position (for Automatic
Transaxle/ Continuously
Variable Transaxle vehicle)\b
apply the parking brake\b and
turn ignition switch to the LOCK
position.
Unexpected vehicle movement
may

occur if these precautions
are not followed.WARNING

+)+
!-0,0*&."'$-.,/#0%(/

Starting the engine Starting the petrol engine
Vehicle with Manual Transaxle :
1. Make sure the parking brake isapplied.
2. Make sure the shift lever is in neu tral.
3. Depress the clutch and brake ped als.
4. Turn the ignition switch to the START position. Hold the key
(maximum of 1\f seconds) until the
engine starts and release it.
Vehicle with Automatic Transaxle/ Continuously Variable Transaxle :
1. Make sure the parking brake is applied.
2. Make sure the shift lever is in P (Park) or N (Neutral).
3. Depress the brake pedal.
4. Turn the ignition switch to the START position. Hold the key
(maximum of 1\f seconds) until the
engine starts and release it. Information
• Do not wait for the engine to warmup while the vehicle remains station
ary\b
Start driving at moderate engine
speeds\b (Steep accelerating and
decelerating should be avoided\b)
• Always start the vehicle with your foot on the brake pedal\b Do not
depress the accelerator while start
ing the vehicle\b Do not race the
engine while warming it up\b
i
•Always wear appropriate shoes
when operating your vehicle.
Unsuitable shoes\b such as high
heels\b ski boots\b sandals\b flip
flops\b etc.\b may interfere with
your ability to use the brake\b
accelerator and clutch pedals.
•Do not start the vehicle with the
accelerator pedal depressed. The
vehicle can move and lead to an
accident.
•Wait until the engine rpm is nor
mal. The vehicle may suddenly
move if the brake padel is
releas

ed when the rpm is high.
WARNING

+)
!-0,0*&."'$-.,/#0%(/
Starting the diesel engine
To start the diesel engine when the
engine is cold\b it has to be preheat
ed before starting the engine and
then have to be warmed up before
starting to drive.
Vehicle with manual transaxle:
1.Make sure the parking brake isapplied.
2.Make sure the shift lever is in neu tral.
3.Depress the clutch and brake ped als.
4.Turn the ignition switch to the ON position to preheat the engine.
The glow indicator light ( ) will
illuminate.
5.When the glow indicator light ( ) goes out\b turn the key ignition
switch to the START position. Hold
the key (maximum of 1\f seconds)
until the engine starts and release
it. Information
If the engine does not start within 10
seconds after preheating is completed,
turn the ignition switch once more to
the LOCK position and wait for 10
seconds\b Then turn the ignition switch
to the ON position in order to preheat
the engine again\b
Starting and stopping the engine
for turbocharger intercooler
1.Do not race or accelerate the engine immediately after starting
the engine.
If the engine is cold\b idle for sever
al seconds before sufficient lubri
cation is ensured in the turbo
charger unit.
2.After high speed or extended driv ing that requires heavy engine
load\b idle the engine about one
minute before turning the engine
off.
This idle time will allow the tur
bocharger to cool prior to shutting
the engine off.
Do not turn off the engine immedi
ately after it has been subjected to a
heavy load. Doing so may cause
severe damage to the engine or
turbo charger unit.
NOTICE
i

+)
!-0,0*&."'$-.,/#0%(/
•NEVER press the Engine
Start/Stop button while the vehi
cle is in motion except in an
emergency. This will result in the
engine turning off and loss of
power assist for the steering and
brake systems.
This may lead to loss of direc
tional control and braking func
tion\b which could cause an acci
dent.
•Before leaving the driver’s seat\b
always make sure the shift lever
is in neutral\b set the parking
brake\b press
the Engine
Start/Stop button to the OFF
position\b and take the Smart Key
with you.
Unexpected vehicle movement
may occur if these precautions
are not followed.
(Continued)
WARNING
To turn the engine off in an emer
gency:
Press and hold the Engine
Start/Stop button for more than
two seconds OR Rapidly press
and release the Engine Start/Stop
button three times (within three
seconds).
If the vehicle is still moving\b you
can restart the engine without
depressing the brake pedal by
pressing the Engine Start/Stop
button with the shift lever in the N
(Neutral) position.
(Continued)
•NEVER reach through the steer
ing wheel for the Engine
Start/Stop button or any other
control while the vehicle is in
motion. The presence of your
hand or arm in this area may
cause a loss of vehicle control
resulting in an accident.
WARNING

+)
!-0,0*&."'$-.,/#0%(/Button Position Action Notice
ON
• Press the Engine Start/Stop button while it
is in the ACC position without depressing
the clutch pedal.
• The warning lights can be checked before the engine is started. Do not leave the Engine Start/Stop button in
the ON position when the engine is not run
ning to prevent the battery from discharging.
Blue indicator
START
To start the engine\b depress the clutch and
brake pedals and press the Engine Start/
Stop button with the shift lever in neutral. If you press the Engine Start/Stop button
without depressing the clutch pedal\b the
engine does not start and the Engine
Start/Stop button changes as follows:
OFF ®ACC ®ON ®OFF
Not illuminated
Vehicle with Manual Transaxle