2018 HONDA CLARITY PLUG IN HYBRID warning

uu Child Safety u Safety of Infants and Small Children
74
Safe Driving A LATCH-compatible child seat can be installe d in either of the two outer rear seats.
A child seat is attached to the lower anchors with either the rigid or flexible type of
connectors.
1. Locate the lower anchors under the marks.
2. Place the child seat on the vehicle seat, then
attach the child seat to the lower anchors
according to the instructions that came
with the child seat.
u When installing the child seat, make sure
that the lower anchors are not
obstructed by the seat belt or any other
object.■ Installing a LATCH-Compatible Child Seat 1 Installing a LATCH-Compatible Child Seat
For your child’s safety, when using a child seat
installed using the LATCH system, make sure that the
child seat is properly secured to the vehicle.
A child seat that is not properly secured will not
adequately protect a child in a crash and may cause
injury to the child or other vehicle occupants.
3
WARNING Never attach two child seats to the same
anchor. In a collision, one anchor may not
be strong enough to hold two child seat
attachments and may break, causing
serious injury or death.Marks
Rigid TypeLower Anchors18 CLARITY PHEV CSS-31TRW6000.book 74 ページ ２０１７年８月３１日　木曜日　午後２時 ４９分

Continued
75uu Child Safety u Safety of Infants and Small Children
Safe Driving
3. Open the tether anchor cover behind the
head restraint.
4.
Route the tether strap over the top of the
head restraint and secure the tether strap
hook to the anchor.
Route the tether strap around the head
restraint and secure the tether strap hook
to the anchor.
5. Tighten the tether strap as instructed by the
child seat manufacturer.
6. Make sure the child seat is firmly secured by
rocking it forward and back and side to
side; little movement should be felt.
7. Make sure any unused seat belt that a child
can reach is buckled, the lockable retractor
is activated, and the be lt is fully retracted
and locked.Flexible Type 1 Installing a LATCH-Compatible Child Seat
Installing a LATCH-compatible child seat in the
rear center seat
Each outer rear seat is equi pped with a pair of lower
anchors which are used to secure a LATCH-
compatible child seat. The rear center seat, however,
is not equipped with anchors of any kind.
The inner and outer anchors are spaced apart at a
standard distance of 11 inches (280 mm). The
distance between the two inner anchors is 15.7
inches (400 mm).
LATCH-compatible restraint systems that are fitted
with rigid-type attachments cannot be installed in the
rear center seat. However, a system fitted with
flexible-type attachments can be installed in the
center seat, provided that the manufacturer’s
instructions for that system permit the use of the
inner anchors with the stated spacing.
Before seating a child, make sure that the system is
properly attached to both the lower anchors and
tether anchors.3
WARNING Do not use the lower inner anchors of the
outer rear seats to secure a LATCH-
compatible child seat to the rear center
seat, unless the manufacturer’s instructions
for that system permit the use of inner
anchors with the stated spacing.Tether
Strap
Hook
Anchor Straight Top Tether Type
Tether
Strap
Hook
Anchor Other Top Tether Type Straight Top Tether Type
Other Top Tether Type18 CLARITY PHEV CSS-31TRW6000.book 75 ページ ２０１７年８月３１日　木曜日　午後２時 ４９分

80 uu Child Safety u Safety of Larger Children
Safe Driving Safety of Larger Children The following pages give instructions on how to check proper seat belt fit, what kind
of booster seat to use if one is needed , and important precautions for a child who
must sit in front.
When a child is too big for a child seat, secure the child in a rear seat using the lap/
shoulder seat belt. Have the child sit upright and all the way back, then answer the
following questions.
■ Checklist
• Do the child’s knees bend comfortably over
the edge of the seat?
• Does the shoulder belt cross between the
child’s neck and arm?
• Is the lap part of the seat belt as low as
possible, touching the child’s thighs?
• Will the child be able to stay seated like this
for the whole trip?
If you answer yes to all these questions, the child is ready to wear the lap/shoulder
seat belt correctly. If you answer no to any question, th e child needs to ride on a
booster seat until the seat belt fits properly without a booster seat.■ Protecting Larger Children
■ Checking Seat Belt Fit 1 Safety of Larger Children
3
WARNING Allowing a child age 12 or under to sit in
front can result in injury or death if the
passenger’s front airbag inflates.
If a larger child must ri de in front, move the
vehicle seat as far to the rear as possible,
have the child sit up properly and wear the
seat belt properly, us ing a booster seat if
needed.18 CLARITY PHEV CSS-31TRW6000.book 80 ページ ２０１７年８月３１日　木曜日　午後２時 ４９分

82
Safe Driving Exhaust Gas Hazard Carbon Monoxide Gas The engine exhaust from this vehicle contains carbon monoxide, a colorless,
odorless, and highly toxic gas. As long as you properly maintain your vehicle, carbon
monoxide gas will not get into the interior.
■ Have the exhaust system in spected for leaks whenever
• The exhaust system is m aking an unusual noise.
• The exhaust system may have been damaged.
• The vehicle is raised for an oil change.
When you operate a vehicle with the trunk open, airflow can pull exhaust gas into
the interior and create a hazardous condition. If you must drive with the trunk open,
open all the windows and set the climate control system as shown below.
1. Select the fresh air mode.
2. Select the mode.
3. Set the fan speed to high.
4. Set the temperature control to a comfortable setting.
Adjust the climate control system in the same manner if you sit in your parked
vehicle with the engine running. 1 Carbon Monoxide Gas
An enclosed area such as a garage can quickly fill up
with carbon monoxide gas.
Do not run the engine with the garage door closed.
Even when the garage door is open, drive out of the
garage immediately afte r starting the engine.
3
WARNING Carbon monoxide gas is toxic.
Breathing it can cause unconsciousness and
even kill you.
Avoid any enclosed areas or activities that
expose you to carbon monoxide.18 CLARITY PHEV CSS-31TRW6000.book 82 ページ ２０１７年８月３１日　木曜日　午後２時 ４９分

85Instrument Panel This chapter describes the buttons, indicators, and gauges that are used while driving.
Indicators ............................................ 86
Driver Information Interface Warning and
Information Messages ..................... 103
Gauges and Driver Information
Interface ....................................... 121
Gauges ............................................ 121
Driver Information Interface ............. 12418 CLARITY PHEV CSS-31TRW6000.book 85 ページ ２０１７年８月３１日　木曜日　午後２時 ４９分

92 uu Indicators u
Instrument Panel Indicator Name On/Blinking Explanation Message
Transmission
System Indicator ●
All the gear positions may light for
several seconds, and go off. ●
When all the gear positions illuminate,
immediately stop your vehicle in a safe
place. ●
Indicators go off if there is no problem.
However, even if they go off, take your
vehicle to an authorized Honda Clarity
Plug-In Hybrid dealer for inspection. ●
The indicated current gear
selection blinks if there is a
problem with the transmission
system. ●
Avoid sudden start and acceleration, and
stop in a safe place immediately. ●
Have your vehicle checked by an
authorized Honda Clarity Plug-In Hybrid
dealer. ●
The indicated current gear
selection or all the gear positions
blink if you cannot select ( P
due
to a transmission system failure. ●
The engine can be activated as a
temporary measure. 2 If the Transmission System Indicator
Blinks along with the Warning
Message P. 552 ●
Set the parking brake when parking. ●
Have your vehicle checked by an
authorized Honda Clarity Plug-In Hybrid
dealer immediately.18 CLARITY PHEV CSS-31TRW6000.book 92 ページ ２０１７年８月３１日　木曜日　午後２時 ４９分

97 uu Indicators u
Continued
Instrument Panel
*1:Canadian models only: Apply and hold th e brake pedal before selecting the ON mode.Indicator Name On/Blinking Explanation Message
Turn Signal and
Hazard Warning
Indicators ●
Blinks when you operate the turn
signal lever. ●
Blinks along with all turn signals
when you press the hazard
warning button. ●
Does not blink or blinks rapidly -
Have your vehicle checked by an
authorized Honda Clarity Plug-In Hybrid
dealer immediately. —
High Beam
Indicator ●
Comes on when the high beam
headlights are on. — —
Lights On
Indicator ●
Comes on when the light switch in
a position other than OFF or when
the switch is set to AUTO and the
exterior lights come on. ●
If you set the power mode to
ACCESSORY or VEHICLE OFF while the
exterior lights are on, a chime sounds
when the driver’s door is opened. —
Immobilizer
System Indicator ●
Blinks if the immobilizer system
cannot recognize the key
information. ●
Blinks - You cannot start the power
system. Set the power mode to VEHICLE
OFF *1
, then select the ON mode again. ●
Repeatedly blinks - The system may be
malfunctioning. Have your vehicle
checked by an author ized Honda Clarity
Plug-In Hybrid dealer. ●
Do not attempt to alter this system or add
other devices to it. Electrical problems can
occur.Indicator Canadian models18 CLARITY PHEV CSS-31TRW6000.book 97 ページ ２０１７年８月３１日　木曜日　午後２時 ４９分

98 uu Indicators u
Instrument Panel Indicator Name On/Blinking Explanation Message
System Message
Indicator ●
Comes on along with a beep when
a problem is detected. A system
message on the driver information
interface appears at the same time. ●
While the indicator is on, press the
(display/information) button to see the
message again. ●
Refer to the Indicators information in this
chapter when a system message appears
on the driver information interface. Take
the appropriate action for the message. ●
The driver information interface does not
return to the normal screen unless the
warning is canceled, or the button is
pressed. —
Security System
Alarm Indicator ●
Blinks when the security system
alarm has been set. 2 Security System Alarm P. 153
—
SPORT Mode
Indicator ●
Comes on when you press the
SPORT button. ●
The ambient meter remains lit up
in red as long as sport mode is on. 2 SPORT Mode P. 389
ECON Mode
Indicator ●
Comes on when ECON mode is on. 2 ECON Mode P. 388Indicator18 CLARITY PHEV CSS-31TRW6000.book 98 ページ ２０１７年８月３１日　木曜日　午後２時 ４９分