Page 164 of 643

162
Controls
Opening and Closing the Moonroof*
You can only operate the moonroof when the power mode is in ON. Use the switch 
in the front of the ceiling to open and close the moonroof.
■Automatic operation
To open:  Pull the switch back firmly.
To close:  Push the switch forward firmly.
The moonroof will automa tically open or close 
all the way. To stop the moonroof midway, 
touch the switch briefly.
■Manual operation
To open:  Pull the switch back lightly, and 
hold it until the desired position is reached.
To close:  Push the switch fo rward lightly, and 
hold it until the desired position is reached.
■Tilting the moonroof up
To tilt:  Push on the center of the moonroof 
switch.
To close:  Push the switch forward firmly, 
then release.
■Opening/Closing the Moonroof1 Opening/Closing the Moonroof
NOTICE
Opening the moonroof in below freezing 
temperature or when it is  covered with snow or ice 
can damage the moonroof panel or motor.
The power moonroof can be operated for up to 10 
minutes after you set the power mode to VEHICLE 
OFF (LOCK).
Opening either front door cancels this function.
When resistance is detected, the auto reverse 
function causes the moonroof to change directions, 
then stop. Auto reverse stops sensing when the 
moonroof is almost closed to ensure that it fully 
closes.
You can use the remote transmitter or the key to 
operate the moonroof. 2 Opening Windows and Moonroof
* with 
the Remote  P. 160
2 Opening/Closing the Windows and 
Moonroof
* with the Key  P. 161
3WARNING
Opening or closing the moonroof on 
someone’s hands or fingers can cause 
serious injury.
Make sure all hands and fingers are clear of 
the moonroof before opening or closing it.
Open
CloseTilt
* Not available on all models
18 CIVIC 4D HCM (KA KC KL)-31TBA6201.book  162 ページ  2018年10月30日  火曜日 午前7時28分 
         
        
        
     
        
        Page 165 of 643

163
Controls
Operating the Switches Around the Steering Wheel
Ignition Switch*
1Ignition Switch*
You cannot take the key out  unless the shift lever is 
in 
( P.
If you open the driver’s door when the key is in LOCK 
( 0 or ACCESSORY (q, a warning buzzer will sound 
to remind you to take the key out.
When this happens, the fo llowing messages appear 
on the driver information interface
*:•In LOCK ( 0:  Remove Key From Ignition .
•In ACCESSORY (q: Return Ignition Switch To 
Lock (0) Position . The buzzer will stop when you 
take the key out.
If the key won’t turn from LOCK 
( 0 to ACCESSORY 
(q, turn the key while moving the steering wheel left 
and right. The steering wh eel will unlock, allowing 
the key to turn.
3WARNING
Removing the key from  the ignition switch 
while driving locks the steering. This can 
cause you to lose control of the vehicle.
Remove the key from  the ignition switch 
only when parked.
Manual transmission models
Continuously variable transmission models
All models
( 0 LOCK: Insert and remove the key in this 
position.
( q ACCESSORY: Operate the audio system and 
other accessories in this position.
( w ON: This is the position when driving.
(e START: This position is for starting the engine. 
The switch returns to ON ( w when you let go of 
the key.
* Not available on all models
18 CIVIC 4D HCM (KA KC KL)-31TBA6201.book  163 ページ  2018年10月30日  火曜日 午前7時28分 
         
        
        
     
        
        Page 168 of 643

uuOperating the Switches Around the Steering Wheel uENGINE START/STOP Button*
166
Controls
If you open the driver’s door when th e power mode is in ACCESSORY, a warning 
beep sounds.
Warning buzzers may sound from inside and/
or outside the vehicle to remind you that the 
smart entry remote is out of the vehicle. If the 
buzzer continues even after the remote is put 
back inside, place it to be within its 
operational range.
■When the power mode is in ON
If the smart entry remote is taken out of the 
vehicle, and the driver’s door is closed, 
warning buzzers sound from both inside and 
outside the vehicle. A warning message on 
the driver information  interface notifies the 
driver inside that the remote is out.
■When the power mode is in 
ACCESSORY
If the smart entry remote is taken out of the 
vehicle, and all the doors are closed, a 
warning buzzer sounds from outside the 
vehicle.
■Power Mode Reminder
■Smart Entry Remote Reminder
1 Smart Entry Remote Reminder
When the smart entry remote is within the system’s 
operational range, and the driv er’s door is closed, the 
warning function cancels.
If the smart entry remote is taken out of the vehicle 
after the engine has been started, you can no longer 
change the  ENGINE START/STOP  button mode or 
restart the engine. Always make sure if the remote is 
in your vehicle when you operate the  ENGINE 
START/STOP  button.
Removing the smart entry remote from the vehicle 
through a window does not  activate the warning 
buzzer.
Do not put the smart entr y remote on the dashboard 
or in the glove box. It may cause the warning buzzer 
to activate. Under some  other conditions that can 
prevent the vehicle from locating the remote, the 
warning buzzer may also activate even if the remote 
is within the system’s operational range.
18 CIVIC 4D HCM (KA KC KL)-31TBA6201.book  166 ページ  2018年10月30日  火曜日 午前7時28分 
         
        
        
     
        
        Page 178 of 643

176
uuOperating the Switches Around the Steering Wheel uAdjusting the Steering Wheel
Controls
Adjusting the Steering Wheel
The steering wheel height and distance from your body can be adjusted so that you 
can comfortably grip the steering wheel in an appropriate driving posture.
1.Pull the steering wheel adjustment lever up.
u The steering wheel adjustment lever is 
under the steering column.
2. Move the steering wheel up or down, and 
in or out.
u Make sure you can see the instrument 
panel gauges and indicators.
3. Push the steering wheel adjustment lever 
down to lock the steering wheel in position.
u After adjusting the position, make sure 
you have securely locked the steering 
wheel in place by trying to move it up, 
down, in, and out.1Adjusting the Steering Wheel
3WARNING
Adjusting the steering wheel position while 
driving may cause you to lose control of the 
vehicle and be seriously injured in a crash.
Adjust the steering wheel only when the 
vehicle is stopped.
To adjust
To lock Lever
18 CIVIC 4D HCM (KA KC KL)-31TBA6201.book  176 ページ  2018年10月30日
 火曜日 午前7時28分 
         
        
        
     
        
        Page 181 of 643

179Continued
Controls
Adjusting the Seats
Front Seats
Adjust the driver’s seat as far back as possible 
while allowing you to ma intain full control of 
the vehicle. You should be able to sit upright, 
well back in the seat and be able to 
adequately press the pedals without leaning 
forward, and grip the steering wheel 
comfortably. The passenger’s seat should be 
adjusted in a similar manner, so that it is as far 
back from the front airbag in the dashboard 
as possible.
■Adjusting th e front power seat(s)*
1Adjusting the Seats
The National Highway Traffic Safety Administration 
and Transport Cana da recommend that drivers allow 
at least 10 inches (25 cm)  between the center of the 
steering wheel and the chest.
Always make seat adjustments before driving.
3WARNING
Sitting too close to a front airbag can result 
in serious injury or death if the front 
airbags inflate.
Always sit as far back from the front 
airbags as possible  while maintaining 
control of the vehicle.
Move back.
Allow sufficient 
space.
■Adjusting the Seat Positions
Horizontal Position 
Adjustment
Height Adjustment
(Driver’s seat only)
Seat-back Angle 
Adjustment
* Not available on all models
18 CIVIC 4D HCM (KA KC KL)-31TBA6201.book  179 ページ  2018年10月30日  火曜日 午前7時28分 
         
        
        
     
        
        Page 183 of 643

181
uuAdjusting the Seats uFront Seats
Controls
Adjust the driver's seat -back to a comfortable, 
upright position, leaving ample space 
between your chest and  the airbag cover in 
the center of the steering wheel.
The front seat passenger should also adjust 
their seat-back to a comfortable, upright 
position.
Reclining a seat-back so that  the shoulder part of the belt no longer rests against the 
occupant's chest reduces the protective capa bility of the belt. It also increases the 
chance of sliding under the belt in a crash and being seriously injured. The farther a 
seat-back is reclined, the gr eater the risk of injury.
■Adjusting the Seat-Backs1Adjusting the Seat-Backs
Do not put a cushion, or  other object, between the 
seat-back and your back.
Doing so may interfere with  proper seat belt or airbag 
operation.
If you cannot get far e nough away from the steering 
wheel and still reach th e controls, we recommend 
that you investigate whether some type of adaptive 
equipment may help.
3WARNING
Reclining the seat-back  too far can result in 
serious injury or death in a crash.
Adjust the seat-back to  an upright position, 
and sit well back in the seat.
18 CIVIC 4D HCM (KA KC KL)-31TBA6201.book  181 ページ  2018年10月30日  火曜日 午前7時28分 
         
        
        
     
        
        Page 184 of 643

182
uuAdjusting the Seats uHead Restraints
Controls
Head Restraints
Your vehicle is equipped with head restraints in all seating positions.
Front head restraints are most effective for 
protection against whiplash and other rear-
impact crash injuries when the center of the 
back of the occupant’s head rests against the 
center of the restraint. The tops of the 
occupant’s ears should be level with the 
center height of the restraint.
To raise the head restraint:
Pull it upward.
To lower the head restraint:
Push it down while pressing the release 
button.
■Adjusting the Front Head Restraints
Models without SPORT mode
1Adjusting the Front Head Restraints
In order for the head restraint system to work 
properly:
•Do not hang any items on  the head restraints, or 
from the restraint legs.
•Do not place any object be tween an occupant and 
the seat-back.
•Install each restraint in its proper location.
3WARNING
Improperly positioning head restraints 
reduces their effectiveness and increases 
the likelihood of serious injury in a crash.
Make sure head restraints are in place and 
positioned properly before driving.
Position head in the center 
of the head restraint.
18 CIVIC 4D HCM (KA KC KL)-31TBA6201.book  182 ページ  2018年10月30日  火曜日 午前7時28分 
         
        
        
     
        
        Page 185 of 643
183
uuAdjusting the Seats uHead Restraints
Controls
Front head restraints can be  removed for cleaning or repair.
To remove a head restraint:
Pull the restraint up as far as  it will go. Then push the release button, and pull the 
restraint up and out.
To reinstall a head restraint:
Insert the legs back in place,  then adjust the head restraint to an appropriate height 
while pressing the release button. Pull up on  the restraint to make sure it is locked 
in position.
■Removing and Reinstalling the Front Head Restraints
Models without SPORT mode1 Removing and Reinstalling  the Front Head Restraints
3WARNING
Failure to reinstall, or  correctly reinstall, the 
head restraints can result in severe injury 
during a crash.
Always replace the he ad restraints before 
driving.
18 CIVIC 4D HCM (KA KC KL)-31TBA6201.book  183 ページ  2018年10月30日  火曜日 午前7時28分