Page 187 of 683
185
uuOpening and Closing the Windows uOpening/Closing the Power Windows
Continued
Controls
To open:  Push the switch down.
To close:  Pull the switch up.
Release the switch when the window reaches 
the desired position.
To open:  Press the unlock button, and then 
within 10 seconds, press it again and hold it.
If the windows and moonroof stop midway, 
repeat the procedure.
■Opening/Closing Windows without Auto-Open/Close 
Function
Close
Open
■Opening the Windows and Moonroof* with the Remote
Unlock 
Button
* Not available on all models
18 ACCORD HYBRID-31TWA6000.book  185 ページ  2018年1月30日 火曜日 午後7時38分 
         
        
        
     
        
        Page 188 of 683
186
uuOpening and Closing the Windows uOpening/Closing th e Power Windows
Controls
To open: Unlock the driver’s door with the 
key. Within 10 seconds of returning the key to 
the central position, turn  the key in the unlock 
direction and hold it there.
To close:  Lock the driver’s door with the key. 
Within 10 seconds of re turning the key to the 
central position, turn  the key in the lock 
direction and hold it there.
Release the key to stop the windows and 
moonroof at the desired position. If you want 
further adjustment, repeat the same 
operation.
■Opening/Closing the Windows and Moonroof* with the Key
Close
Open
* Not available on all models
18 ACCORD HYBRID-31TWA6000.book  186 ページ  2018年1月30日 火曜日 午後7時38分 
         
        
        
     
        
        Page 189 of 683

187
Controls
Opening and Closing the Moonroof*
You can only operate the moonroof when the power mode is in ON. Use the switch 
in the front of the ceiling to  open and close the moonroof.
■Automatic operation
To open:  Pull the switch back firmly.
To close:  Push the switch forward firmly.
The moonroof will automatically open or close 
all the way. To stop the moonroof midway, 
pull or push the switch briefly.
■Manual operation
To open:  Pull the switch back lightly, and 
hold it until the desired position is reached.
To close:  Push the switch fo rward lightly, and 
hold it until the desired position is reached.
■Tilting the moonroof up
To tilt:  Push on the center of the moonroof 
switch.
To close:  Push the switch forward firmly, 
then release.
■Opening/Closing the Moonroof1 Opening/Closing the Moonroof
NOTICE
Opening the moonroof in below freezing 
temperature or when it is  covered with snow or ice 
can damage the moonroof panel or motor.
The power moonroof can be operated for up to 10 
minutes after you set the power mode to VEHICLE 
OFF.
Opening either front door cancels this function.
When resistance is detected, the auto reverse 
function causes the moonroof  to change directions, 
then stop. Auto reverse stops sensing when the 
moonroof is almost closed to ensure that it fully 
closes.
You can use the remote transmitter or the key to 
operate the moonroof. 2 Opening the Windows and Moonroof
* 
with the Remote  P. 185
2 Opening/Closing the Windows and 
Moonroof
* with the Key  P. 186
3WARNING
Opening or closing the moonroof on 
someone’s hands or fingers can cause 
serious injury.
Make sure all hands and fingers are clear of 
the moonroof before opening or closing it.
Open
CloseTilt
* Not available on all models
18 ACCORD HYBRID-31TWA6000.book  187 ページ  2018年1月30日 火曜日 午後7時38分 
         
        
        
     
        
        Page 190 of 683

188
Controls
Operating the Switches Around the Steering Wheel
POWER Button
■Changing the Power Mode1POWER Button
POWER Button Operating Range
You can start the power system when the smart entry 
remote is inside the vehicle.
The power system may also start if the smart entry 
remote is close to the door  or window, even if it is 
outside the vehicle.
ON mode:
The button is on (in red), if  the power system is on.
If the battery of the smar t entry remote is getting 
low, the power system may not start when you press 
the  POWER  button. If the power system does not 
start, refer to the following link. 2 If the Smart Entry Remote Battery is Weak  
P. 637
Do not leave the power mode in ACCESSORY or ON 
when you get out.
Operating Range
VEHICLE OFF (LOCK)
The button is off.
The power to all electrical components is turned 
off.
Press the button.
Without pressing 
the brake pedal ACCESSORY
The button blinks (in red).
Operate the audio system and other accessories in 
this position.
ON
The button blinks (in red).
All electrical components can be used.
18 ACCORD HYBRID-31TWA6000.book  188 ページ  2018年1月30日 火曜日 午後7時38分 
         
        
        
     
        
        Page 192 of 683

uuOperating the Switches Around the Steering Wheel uPOWER Button
190
Controls
Warning buzzers may sound from inside and/
or outside the vehicle to remind you that the 
smart entry remote is out of the vehicle. If the 
buzzer continues even after the remote is put 
back inside, place it to be within its 
operational range.
■When the power mode is in ON
If the smart entry remote is taken out of the 
vehicle, and the driver’s door is closed, a 
warning buzzer sounds from both inside and 
outside the vehicle. A warning message on 
the driver information interface notifies the 
driver inside that the remote outside of the 
vehicle.
■When the power mode is in 
ACCESSORY
If the smart entry remote is taken out of the 
vehicle, and all the doors are closed, a 
warning buzzer sounds from outside the 
vehicle.
■Smart Entry Remote Reminder1 Smart Entry Remote Reminder
When the smart entry remote is within the system’s 
operational range, and the driv er’s door is closed, the 
warning function cancels.
If the smart entry remote is taken out of the vehicle 
after the power system has  been turned on, you can 
no longer change the  POWER button mode or 
restart the power system. Always make sure if the 
remote is in your vehi cle when you operate the 
POWER  button.
Removing the smart entry remote from the vehicle 
through a window does not  activate the warning 
buzzer.
Do not put the smart entr y remote on the dashboard 
or in the glove box. It may cause the warning buzzer 
to activate. Under some  other conditions that can 
prevent the vehicle from locating the remote, the 
warning buzzer may also activate even if the remote 
is within the system’s operational range.
18 ACCORD HYBRID-31TWA6000.book  190 ページ  2018年1月30日 火曜日 午後7時38分 
         
        
        
     
        
        Page 202 of 683

200
uuOperating the Switches Around the Steering Wheel uRear Defogger/Heated Door Mirror Button
Controls
Rear Defogger/Heated  Door Mirror Button
Press the rear defogger and heated door 
mirror button to defog the rear window and 
mirrors when the power mode is in ON.
The rear defogger and heated door mirror 
automatically switches off after 10-30 
minutes depending on the outside 
temperature.
However, if the outside temperature is 32°F 
(0°C) or below, it does not automatically 
switch off.
Heated Windshield Button
Press the heated windshield button to deice 
the windshield when the power mode is in 
ON.
1Rear Defogger/Heated Door Mirror Button
NOTICE
When cleaning the inside  of the rear window, be 
careful not to damage  the heating wires.
It is critical to wipe the window from side to side 
along the defogger  heating wires.
This system consumes a lot of power, so turn it off 
when the window has been defogged. Also, do not 
use the system for a long time while the power 
system is stopped. This may weaken the 12-volt 
battery, making it difficult to turn the power system 
on.
When the outside temperature is below 41°F (5°C), 
the heated door mirror may  activate automatically for 
10 minutes when you set the power mode to ON.
Canadian models
1 Heated Windshield Button
This system consumes a lot of power, so turn it off 
when the window has been defogged or deiced. 
Also, do not use the syst em for a long period when 
the power system is stopped. This may weaken the 
12-volt battery, making it difficult to turn the power 
system on.
18 ACCORD HYBRID-31TWA6000.book  200 ページ  2018年1月30日 火曜日 午後7時38分 
         
        
        
     
        
        Page 234 of 683

232
Controls
Climate Control System
Using Automatic Climate Control
The automatic climate control system maintains the interior temperature you select. 
The system also selects the proper mix of heated or cooled air that raises or lowers 
the interior temperature to your  preference as quickly as possible.
Use the system when the power system is on.
1. Press the  AUTO button.
2. Adjust the interior temperature using the dr iver’s side or passenger’s side control 
dial.
3. Press the   (on/off) button to cancel.
■Switching between the recirculation and fresh air modes
Press the   (recirculation) button and switch the mode depending on 
environmental conditions.
Recirculation mode (indicator on): Recirculat es air from the vehicle’s interior through 
the system.
Fresh air mode (indicator off): Maintains out side ventilation. Keep the system in 
fresh air mode in normal situations.
1 Using Automatic Climate Control
If any buttons are presse d while using the climate 
control system in auto, the function of the button 
that was pressed wi ll take priority.
The  AUTO  indicator will go  off, but functions 
unrelated to the button th at was pressed will be 
controlled automatically.
To prevent cold air from bl owing in from outside, the 
fan may not start i mmediately when the  AUTO 
button is pressed.
If the interior is very warm, you can cool it down 
more rapidly by partial ly opening the windows, 
turning the system on auto, and setting the 
temperature to low. Change the fresh mode to 
recirculation mode  until the temperature cools down.
When you set the temperat ure to the lower or upper 
limit,  Lo or  Hi is displayed.
Pressing the   button switches the climate control 
system between on and off. When turned on, the 
system returns to your last selection.
While ECON mode is active, the climate control 
system may have reduced  cooling performance.
Floor and 
defroster 
vents
Floor ventsDashboard and floor 
vents, and back of 
the center console
*
Dashboard vents 
and back of the 
center console
*
AUTO
 Button
Driver’s Side 
Temperature 
Control Dial
 (Recirculation) 
Button
Fan Control Dial
A/C (Air Conditioning) 
Button Passenger’s 
Side 
Temperature 
Control Dial
 (on/off) Button
* Not available on all models
18 ACCORD HYBRID-31TWA6000.book  232 ページ  2018年1月30日 火曜日 午後7時38分 
         
        
        
     
        
        Page 235 of 683

Continued233
uuClimate Control System uUsing Automatic Climate Control
Controls
Pressing the   button turns the air 
conditioning system on and automatically 
switches the system to fresh air mode.
Press the   button again to turn off, the 
system returns to the previous settings.
■To rapidly defrost the windows
1.Press the   button.
2. Press the   button.
■Defrosting the Windshield and Windows1Defrosting the Windshield and Windows
For your safety, make sure you have a clear view 
through all the windows before driving.
Do not set the temperatur e near the upper or lower 
limit.
When cold air hits the windshield, the outside of the 
windshield may fog up.
If the side windows fog up,  adjust the vents so that 
the air hits th e side windows.
1To rapidly defrost the windows
After defrosting the windows, switch over to fresh air 
mode. If you keep the syst em in recirculation mode, 
the windows may fog up from humidity. This 
impedes visibility.
18 ACCORD HYBRID-31TWA6000.book  233 ページ  2018年1月30日 火曜日 午後7時38分