2018 FIAT 500E fog light

▫Central Lock/Unlock (Switch Safe Lock
Device) — If Equipped ....................43
 DOORS ...............................44
▫ Manual Lock ...........................44
▫ Power Door Locks ......................45
 SEATS ................................46
▫ Manual Adjustment Front Seats ..............46
▫ Heated Seats — If Equipped ...............49
▫ Manual Folding Rear Seat ..................50
 HEAD RESTRAINTS ......................50
▫ Reactive Head Restraints — Front Seats ........51
▫ Rear Head Restraints .....................52
 STEERING WHEEL .......................53
▫ Tilt Steering Column — If Equipped ..........53
 MIRRORS ..............................54
▫ Inside Day/Night Mirror ..................54
▫ Automatic Dimming Mirror — If Equipped .....54▫
Power Mirrors .........................55
▫ Folding Mirrors .........................55
▫ Spotter Mirror — If Equipped ...............56
▫ Heated Mirrors — If Equipped .............56
 EXTERIOR LIGHTS .......................56
▫ Multifunction Lever ......................56
▫ Headlights ............................56
▫ Daytime Running Lights ..................57
▫ High Beams ...........................57
▫ Flash-To-Pass ..........................57
▫ Parking Lights .........................57
▫ Follow Me Home/Headlight Delay ...........57
▫ Fog Lights — If Equipped .................57
▫ Turn Signals ...........................58
▫ Lane Change Assist ......................58
 INTERIOR LIGHTS .......................59
▫ Interior Light Timing (Center Position) ........59
14 GETTING TO KNOW YOUR VEHICLE

NOTE:When the headlights are turned on, the Daytime
Running Lights will be deactivated.
Daytime Running Lights
To activate the Daytime Running Lights (DRL), rotate the
end of the multifunction lever to the Osymbol.
NOTE: The low beams and side/taillights will not be on
with DRL.
If allowed by law in the country in which the vehicle was
purchased the DRL function can be turned on or off using
the display menus. Refer to “Uconnect Settings” in “Mul-
timedia” for further information.
High Beams
With the low beams activated, push the multifunc-
tion lever towards the instrument panel to turn on
the high beams. Pull the multifunction lever toward the
steering wheel to turn off the high beams.
Flash-To-Pass
You can signal another vehicle with your headlights by
partially pulling the multifunction lever toward the steer-
ing wheel. This will cause the high beam headlights to turn
on until the lever is released.
Parking Lights
To turn on the parking lights, remove the key or
turn the ignition to OFF/LOCK position and
turn on the headlights.
Follow Me Home/Headlight Delay
When this feature is selected, the driver can choose to have
the headlights remain on for a preset period of time.
Activation
Remove the key or turn the ignition to the STOP (OFF/
LOCK) position, and pull the multifunction lever toward
the steering wheel within two minutes. Each time the lever
is pulled, the activation of the lights will be extended by 30
seconds. The activation of the lights can be extended to a
maximum of 210 seconds.
Deactivation
Pull the multifunction lever toward the steering wheel and
hold it for more than two seconds.
Fog Lights — If Equipped
The fog light switch is located on the center stack of the
instrument panel, just below the radio.
3
GETTING TO KNOW YOUR VEHICLE 57

Push the switch once to turn the front fog lights on. Push
the switch a second time to turn the front fog lights off.
Turn Signals
Push the multifunction lever upward to signal a right turn
or downward to signal a left turn. The corresponding
indicator in the instrument cluster display will blink to
indicate the operation of the turn signal.NOTE:
The indicators will automatically turn off when the
turn has been completed and the steering wheel is returned
to a straight position.Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash three
times. Then, the turn signal (right or left) will automatically
turn off.
Fog Light SwitchTurn Signal Operation
58 GETTING TO KNOW YOUR VEHICLE

CAUTION!
Failure to follow these cautions can cause damage to
the heating elements:
•Use care when washing the inside of the rear win-
dow. Do not use abrasive window cleaners on the
interior surface of the window. Use a soft cloth and a
mild washing solution, wiping parallel to the heat-
ing elements. Labels can be peeled off after soaking
with warm water.
• Do not use scrapers, sharp instruments, or abrasive
window cleaners on the interior surface of the win-
dow.
• Keep all objects a safe distance from the window.
— Exterior Bulb Failure Indicator Light — If
Equipped
This light will illuminate when there is a malfunction in
one of the exterior bulbs.
Green Indicator Lights
—Cruise Control Set Indicator Light — If Equipped
This indicator light will illuminate when the cruise control
is set to the desired speed. Refer to “Speed Control” in
“Starting And Operating” for further information.
— Front Fog Indicator Light — If Equipped
This indicator light will illuminate when the front fog
lights are on.
— Park/Headlight On Indicator Light
This indicator light will illuminate when the park lights or
headlights are turned on.
— Plugged In Indicator Light
This indicator will illuminate when the vehicle is plugged
in.
— Turn Signal Indicator Lights
When the left or right turn signal is activated, the turn
signal indicator will flash independently and the corre-
sponding exterior turn signal lamps will flash. Turn signals
can be activated when the multifunction lever is moved
down (left) or up (right).
NOTE:
• A continuous chime will sound if the vehicle is driven
more than 1 mile (1.6 km) with either turn signal on.
• Check for an inoperative outside light bulb if either
indicator flashes at a rapid rate.
4
GETTING TO KNOW YOUR INSTRUMENT PANEL 97

Front Fog Lamps
To replace the front fog lights, see an authorized dealer.
Front/Rear Side Marker Lamps
1. Remove portion of the wheel liner to allow hand accessto side marker lamp.
2. Rotate the bulb socket counterclockwise, and remove the bulb and socket assembly from the housing.
3. Pull the bulb from the socket and insert the replacement bulb.
4. Install the bulb and socket assembly into the housing, and rotate the socket clockwise to lock it in place.
5. Reinstall the wheel liner.
Rear Tail, Stop, Backup And Turn Signal Lamps
1. Open the liftgate.
2. Remove the two screws and remove the tail lamp assembly. 3. Remove four screws and separate the backplate from the
lamp housing.
4. Remove the tail, stop, or turn signal bulbs by pushing them slightly and turning counter-clockwise.
5. Remove the backup lamp bulb by pulling straight out.
6. Replace lamps as required and reinstall lamp.
Tail Lamp Assembly Screws
7
IN CASE OF EMERGENCY 183

BODYWORK
Protection From Atmospheric Agents
Vehicle body care requirements vary according to geographic
locations and usage. Chemicals that make roads passable in
snow and ice and those that are sprayed on trees and road
surfaces during other seasons are highly corrosive to the
metal in your vehicle. Outside parking, which exposes your
vehicle to airborne contaminants, road surfaces on which the
vehicle is operated, extreme hot or cold weather and other
extreme conditions will have an adverse effect on paint,
metal trim, and underbody protection.
The following maintenance recommendations will enable
you to obtain maximum benefit from the corrosion resis-
tance built into your vehicle.
What Causes Corrosion?
Corrosion is the result of deterioration or removal of paint
and protective coatings from your vehicle.
The most common causes are:
•Road salt, dirt and moisture accumulation.
• Stone and gravel impact.
• Insects, tree sap and tar.
• Salt in the air near seacoast localities.
• Atmospheric fallout/industrial pollutants.
Body And Underbody Maintenance
Cleaning Headlights
Your vehicle is equipped with plastic headlights and fog
lights that are lighter and less susceptible to stone breakage
than glass headlights.
Plastic is not as scratch resistant as glass and therefore
different lens cleaning procedures must be followed.
To minimize the possibility of scratching the lenses and
reducing light output, avoid wiping with a dry cloth. To
remove road dirt, wash with a mild soap solution followed
by rinsing.
Do not use abrasive cleaning components, solvents, steel
wool or other aggressive material to clean the lenses.
Preserving The Bodywork
Washing
•Wash your vehicle regularly. Always wash your vehicle
in the shade using Mopar Car Wash, or a mild car wash
soap, and rinse the panels completely with clear water.
• If insects, tar, or other similar deposits have accumulated
on your vehicle, use Mopar Super Kleen Bug and Tar
Remover to remove.
8
SERVICING AND MAINTENANCE 251

Diagnostic System, Onboard....................98
Dimmer Switch Headlight ...............................56
Door Ajar .................................92
Door Ajar Light ............................92
Doors ....................................44
Driver ’s Seat Back Tilt ........................46
Driving Through Flowing, Rising, Or Shallow Standing
Water .................................174
Electrical Power Outlets .......................80
Electric Remote Mirrors .......................55
Electric Vehicle Features .......................18
Electric Vehicle Supply Equipment (EVSE) ..........24
Electronic Stability Control (ESC) ...............102
Emergency, In Case Of Hazard Warning Flasher ...................180
Jacking ............................... .228
Towing ................................211
Engine Compartment .......................... .217
Starting ...............................155
Enhanced Accident Response Feature .........130, 212
Exterior Lighting ............................56 Exterior Lights
..........................56, 151
Filters Air Conditioning ..........................71
Flashers Turn Signals .......................56, 97, 151
Flash-To-Pass ..............................56
Fluid Leaks ...............................151
Fluid Level Checks Brake .................................227
Fluids, Lubricants And Genuine Parts ............259
Fog Lights ............................. .56, 57
Fold-Flat Seats .............................46
Freeing A Stuck Vehicle ..................... .210
Fuses .................................. .184
Gear Ranges ............................. .159
General Information .....................110,275
General Maintenance ........................219
Glass Cleaning ............................254
GVWR ................................. .171
Hazard Driving Through Flowing, Rising, Or Shallow
Standing Water ..........................174
292 INDEX

UconnectUconnect Settings ........................263
Uniform Tire Quality Grades ..................249
Untwisting Procedure, Seat Belt ................117
USB....................................275
Vehicle Identification Number (VIN) .............256
Vehicle Loading ........................171, 233
Vehicle Modifications/Alterations .................5
Vehicle Security Alarm ........................41
Vehicle Storage .............................70
Voice Recognition System (VR) .................276
Warning Lights (Instrument Cluster Descriptions) ....94
Warnings And Cautions .......................5
Warranty Information .......................287 Washer
Adding Fluid .......................... .217
Washers, Windshield ..................... .60, 62
Washing Vehicle .......................... .251
Water Driving Through ........................ .174
Wheel And Wheel Tire Care ...................246
Wheel And Wheel Tire Trim ...................246
Wind Buffeting ..........................73, 74
Window Fogging ...........................71
Windows .................................72
Windshield Defroster ........................149
Windshield Washers .......................60, 62
Windshield Wiper Blades .....................225
Windshield Wipers ..........................60
Wipers Blade Replacement ....................225
298 INDEX