2018 CITROEN DS3 CABRIO tailgate

57
If the vehicle is to be parked outside for
a long period, it is advisable to protect the
roof using a


tarpaulin.
It is advisable to close the roof when you
park the vehicle.
Even if the roof is closed, it is safer not to
leave any valuables inside the vehicle.
Remove the ignition key when you leave
the vehicle to prevent any involuntary roof
movement.
If your vehicle has a
voice command
system, it may be affected if you drive with
the roof open.
Protection of electric motors that control
roof opening and closure: during repeated
opening and closing movements of the
roof, it is possible that heating up of the
electric motors no longer allows the roof to
be opened or closed. Allow the motors to
cool by not trying to move the roof for ten
minutes.Boot
Opening
Closing
- when the engine is running ,
this warning lamp comes on,
accompanied by a
message in
the multifunction screen for a
few
seconds,
-

w
hen the vehicle is moving
(speed higher than 6
mph
(10
km/h)), this warning lamp
comes on, accompanied by an
audible signal and a
message in
the multifunction screen for a
few
seconds.
Back-up control
Unlocking
F Fold back the rear seats to gain access to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the boot.
F

A

fter unlocking the vehicle, press the
opening control and then open the boot.
F

L

ower the tailgate using the interior grab
handle.
If the tailgate is not fully closed: Measures for mechanically unlocking the boot
in the event of a battery or central locking fault.
02
Access

58
Boot
Opening
F After unlocking the vehicle using the remote control or the key, press the opening
control, then raise the tailgate.
Closing
F Lower the tailgate by pressing the centre of its trim.
It is strongly recommended that you do
not lower the tailgate by pressing one of
its sides.
If the tailgate is not fully closed: -
when the engine is running ,
this warning lamp comes on,
accompanied by a
message in
the multifunction screen for a
few
seconds,
- when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on,
accompanied by an audible signal
and a
message in the multifunction
screen for a
few seconds.
If the tailgate is not closed fully, opening
the roof in zone B is not possible.
Check that the tailgate is properly closed.
Opening conditions for the
boot with the roof in zone B
To avoid inter ference of the boot and the
roof in zone B, the opening of the boot is
conditional on the position of the roof.
02
Access

59
If the roof per forms an opening
manoeuvre in zone B, an action on the
boot opening command causes the roof to
close. The boot will be opened when the
roof has reached position 2 . You can then
raise the tailgate.
If the roof per forms an closing manoeuvre
in zone B , an action on the boot opening
command has no effect on the roof
manoeuvre, but triggering the opening of
the tailgate will only be effective when the
roof has reached position 2 . You can then
raise the tailgate.
If the roof per forms an opening or closing
manoeuvre in zone B following an
"anti-panic" function, the boot opening
command is inhibited. It will operate again
when the roof has reached position 2
or
position 3 .
If the roof is in position 3 , an action on
the boot opening control causes the roof
to close to position 2 . When the roof has
reached this position, the tailgate opening
will be triggered. You can then raise the
tailgate.Back-up control
Measures for mechanically unlocking the boot
in the event of a battery or central locking fault.
Unlocking
F Fold the rear seats to gain access to the two locks from inside the boot. F

I
nsert a small screwdriver into hole A of
each side lock to unlock the boot.
Before opening the boot, check that the
roof is not in zone B .
02
Access

88
Wiper control stalk
The vehicle's front and rear wipers are
designed to improve the driver's visibility
progressively according to the climatic
conditions.
Programming
You can configure automatic wiping for the
front wipers.
Without AUTO wipingWith AUTO wiping
Front wipers
Raise or lower the control to the desired
position to select the wiping speed.
Fast (heavy rain).
Normal (moderate rain).
Intermittent (proportional to the
speed of the vehicle).
Of f.
Single wipe (press down and
release).
or Automatic, then single wipe.
Refer to the corresponding section.
Rear screen wiper
In the event of snow or hard frost, or
when having a bicycle carrier mounted
on the tailgate, deactivate the automatic
rear wiper via the vehicle settings or
configuration menu in the display screen.
Rear screen wiper selection ring. Of f.
Intermittent wipe.
Wash-wipe (set duration).
You can configure rear wiping on engaging
reverse gear.
04
Lighting and visibility

162
F After emptying the bottle or container, wipe away any spillage around the tank filler
using a
damp cloth.
If any AdBlue
® additive is spilt or splashed,
wash immediately with cold water or wipe
with a

damp cloth.
If the AdBlue
® has crystallised, clean it off
using a

sponge and hot water.
F

R

efit the blue cap to the tank filler and turn it
a

6
th of a turn clockwise, to its stop.
F
D
epending on equipment, return the spare
wheel and/or the storage box to the bottom
of the boot.
F

R

efit the boot carpet and close the tailgate.
Important: when topping up after
running out of AdBlue
®, you must wait
for around 5 minutes before switching
on the ignition, without opening the
driver's door , or unlocking the vehicle ,
or placing the key in the ignition
switch .
Switch on the ignition, then after
10


seconds, start the engine.
Advice on care and
maintenance
Recommendations on the care and
maintenance of your vehicle are given in the
Maintenance and Warranty Guide.
Textured paint
Textured paint reacts to light with variations of
appearance and finish that emphasise the car's
lines and form. This paint coating has particles
that remain visible and create a unique satin
relief effect. Its lightly granulated texture gives
it a
surprising feel. Observe the following recommendations
to avoid damaging the paint finish:
-

c
hoose a high pressure wash, or at
least a high water delivery; roller brush
washing is compatible.
-
g
ently wipe the body with a clean
microfibre cloth.
-
c
arefully wipe off any fuel spilt on the
body using a soft cloth, then allow to
d r y.
-

c
lean off minor marks (for example,
finger marks), using the product in the
"TECHNATURE" range intended for
removing insects.
H o w eve r,
-

d
o not select the programme with hot
wax finish.
-

d
o not use waterless cleaning.
-

n
ever polish the vehicle.
-

d
o not use paint restorers, abrasive
or polishing products, or bright paint
preser vers (wax polish, for example).
It is always preferable to have paint
repairs carried out in the dealer network or
by a


qualified workshop.
07
Practical information