2018 CITROEN DS3 CABRIO lock

58
Boot
Opening
F After unlocking the vehicle using the remote control or the key, press the opening
control, then raise the tailgate.
Closing
F Lower the tailgate by pressing the centre of its trim.
It is strongly recommended that you do
not lower the tailgate by pressing one of
its sides.
If the tailgate is not fully closed: -
when the engine is running ,
this warning lamp comes on,
accompanied by a
message in
the multifunction screen for a
few
seconds,
- when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on,
accompanied by an audible signal
and a
message in the multifunction
screen for a
few seconds.
If the tailgate is not closed fully, opening
the roof in zone B is not possible.
Check that the tailgate is properly closed.
Opening conditions for the
boot with the roof in zone B
To avoid inter ference of the boot and the
roof in zone B, the opening of the boot is
conditional on the position of the roof.
02
Access

59
If the roof per forms an opening
manoeuvre in zone B, an action on the
boot opening command causes the roof to
close. The boot will be opened when the
roof has reached position 2 . You can then
raise the tailgate.
If the roof per forms an closing manoeuvre
in zone B , an action on the boot opening
command has no effect on the roof
manoeuvre, but triggering the opening of
the tailgate will only be effective when the
roof has reached position 2 . You can then
raise the tailgate.
If the roof per forms an opening or closing
manoeuvre in zone B following an
"anti-panic" function, the boot opening
command is inhibited. It will operate again
when the roof has reached position 2
or
position 3 .
If the roof is in position 3 , an action on
the boot opening control causes the roof
to close to position 2 . When the roof has
reached this position, the tailgate opening
will be triggered. You can then raise the
tailgate.Back-up control
Measures for mechanically unlocking the boot
in the event of a battery or central locking fault.
Unlocking
F Fold the rear seats to gain access to the two locks from inside the boot. F

I
nsert a small screwdriver into hole A of
each side lock to unlock the boot.
Before opening the boot, check that the
roof is not in zone B .
02
Access

64
No person or object should block the
seat sliding back into its initial position;
returning to this position is necessary for
longitudinal locking.
Make sure that the seat belt has reeled in
correctly so as not to prevent passenger
access to the rear seats.
Grab handle
PERFORMANCE front
seats
Seat consisting of a cushion and an adjustable
b ackrest to adapt your position for optimal
driving and comfort conditions.
Manual adjustments
Longitudinal adjustment
F Raise the control and slide the seat forwards or backwards.
Height adjustment
F Pull the control upwards to raise or push it downwards to lower, as many times as
necessary to obtain the position required.
This ergonomic grip, located at the top of the
side trim, allows:
-

r

ear side passengers to have a

support
when the vehicle is moving,
-

p

rovision of a

support point improving
access to seats in the rear,
-

e

asier exit from the rear seats.
03
Ease of use and comfort

65
Adjusting the seat backrest angle
F Push the handle towards the rear and move the seat backrest for wards or backwards.
Before moving the seat backwards,
ensure that there is nothing that might
prevent the full travel of the seat.
There is a
risk of trapping or pinching
passengers if present in the rear seats
or jamming the seat if large objects are
placed on the floor behind the seat.
Additional adjustments
Access to the rear seats
F Pull the control for ward to fold the backrest and move the seat for ward.
When returning it, the seat resumes its
initial position.
No person or object should block the
seat sliding back into its initial position;
returning to this position is necessary for
longitudinal locking.
Make sure that the seat belt has reeled in
correctly so as not to prevent passenger
access to the rear seats.
Grab handle
This ergonomic grip, located at the top of the
side trim, allows:
-
r
ear side passengers to have a support
when the vehicle is moving,
-

p
rovision of a support point improving
access to seats in the rear,
-

e
asier exit from the rear seats.
03
Ease of use and comfort

67
Steering wheel adjustment
F When stationary, pull the control lever to
release the steering wheel.
F

A
djust the height and reach to suit your
driving position.
F

P
ush the control lever to lock the adjustment
mechanism.
As a
safety precaution, these operations
should only be carried out while the
vehicle is stationary.
Mirrors
Door mirrors
Each fitted with an adjustable mirror glass
permitting the lateral rearward vision necessary
for overtaking or parking.
They can also be folded in for parking in narrow
spaces.
Demisting/Defrosting
If your vehicle is fitted with heated
mirrors, the demisting-defrosting
operates by switching on the heated
rear screen.
For more information on Rear screen demist -
defrost , refer to the corresponding section.
Adjustment
F Move control B in any of the four directions
to adjust.
F

R
eturn control A to the central position.
Objects seen in the mirror are in reality
closer than they appear.
Take this into account when assessing
the distance of vehicles approaching from
behind.
As a
safety measure, the mirrors should
be adjusted to reduce the blind spots.
Folding
F From outside: lock the vehicle using the remote control or the key.
F

F
rom inside: with the ignition on, pull the
control A in the central position rearwards.
If the mirrors are folded using control A ,
they will not unfold when the vehicle is
unlocked. Pull again on control A .
F

M

ove control A to the right or to the left to
select the corresponding mirror.
03
Ease of use and comfort

68
Unfolding
F From outside: unlock the vehicle using the remote control or the key.
F

F
rom inside: with the ignition on, pull the
control A in the central position rearwards.
The folding and unfolding of the door
mirrors using the remote control can be
deactivated in the dealer network or by
a


qualified workshop.
If necessary the mirrors can be folded
manually.
Rear view mirror
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the
nuisance to the driver caused by the sun,
headlamps from other vehicles, etc.
Manual model
Adjustment
Day/night position
F
P
ull the lever to change to the "night" anti-
dazzle position.
F

P
ush the lever to change to the normal
"day" position.
Automatic "electrochrome" model
This system automatically and progressively
changes between the day and night uses by
means of a
sensor, which measures the light
from the rear of the vehicle.
In order to ensure optimum visibility during
your manoeuvres, the mirror lightens
automatically when reverse gear is
engaged.
F

A

djust the mirror so that the glass is
directed correctly in the "day" position.
Ventilation
Air intake
The air circulating in the passenger
compartment is filtered and originates either
from the outside via the grille located at the
base of the windscreen or from the inside in air
recirculation mode.
Air treatment
The incoming air follows various routes
depending on the controls selected by the
driver:
-

d
irect arrival in the passenger compartment
(air intake),
-
p

assage through a

heating circuit (heating),
-

p
assage through a cooling circuit (air
conditioning).
03
Ease of use and comfort

76
Fragrance diffuser
Diffuses a fragrance in the passenger
c ompartment from the central air vents.
Operating wheel
The wheel on the dashboard adjusts the
intensity of diffusion of the fragrance.
F

T
urn the wheel to the right to diffuse
fragrance.
F

T
urn the wheel to the left to stop diffusing
fragrance.
The central vents must be open.
The intensity of the fragrance diffusion
may depend on the ventilation or air
conditioning settings.
Fragrance cartridge
This cartridge can be removed easily. On first
use, replace the plug with a real cartridge.
You can change it at any time, thanks to the
sealed cover that allows you to keep it enclosed
when it has already been opened.
You can obtain different fragrance cartridges
from your dealer or a
qualified workshop.
Do not discard the original cartridge,
which ser ves as a
blanking plug if no
fragrance diffuser is used.
To extend the ser vice life of the cartridge,
turn the knob to the left when you no
longer want fragrance to be diffused in the
passenger compartment.
For safety reasons, do not per form any
operations on the cartridge while driving.
Never remove the cartridges.
Do not try to refill the diffuser or
cartridges.
Avoid contact with the skin or eyes.
Keep cartridges out of the reach of
children or pets.
Removing the cartridge
Installing the cartridge
F Remove the sealed cover from the cartridge.
F

I
nstall the cartridge (flower to the top left).
F

P
ress the knob and turn it a quarter turn in
the clockwise direction.
F

P
ress the knob and turn it a quarter turn in
the anti-clockwise direction.
F
R
emove the cartridge.
F
R
efit the sealed cover.
03
Ease of use and comfort

77
Courtesy lamp
A.Courtesy lamp
B. Map reading lamps
Courtesy lamp
In this position, the courtesy lamp
comes on gradually:
-

w

hen the vehicle is unlocked,
-

w

hen the key is removed from the ignition,
-

o

n opening a door,
-

w

hen activating the locking button on
the remote control in order to locate your
vehicle.
It switches off gradually:
-

w

hen the vehicle is locked,
-

w

hen the ignition is switched on,
-

3

0

seconds after the last door is closed. Permanently off.
Permanent lighting.
In permanent lighting mode, the lighting
time varies according to the circumstances:
-
w
hen the ignition is off, approximately
ten minutes,
-
i
n energy economy mode,
approximately thirty seconds,
-
w
ith the engine running, unlimited.
Map reading lamps
F With the ignition on, press the
corresponding switch.
Interior mood lighting
The dimmed passenger compartment lighting
improves visibility in the vehicle when the light
i s p o o r.
Switching on
At night, the footwell and storage lamps at the
centre of the dashboard come on automatically
once the sidelamps are lit.
03
Ease of use and comfort