2018 CITROEN C-ELYSÉE bulb

3
.
.
Driving recommendations 80
Starting-switching off the engine 8 1
Parking brake

8
3
Manual gearbox
8

4
Automatic gearbox (EAT6)

8
4
Gear shift indicator

8
8
Stop & Start

8
8
Under-inflation detection
9

1
Speed limiter
9

3
Cruise control

9
5
Rear parking sensors
9

7
Reversing camera
9

9Fuel 1
0 0
Misfuel prevention (Diesel) 1 01
Compatibility of fuels
1

02
AdBlue
® (BlueHDi engines) 1 03
Snow chains 1 06
Energy economy mode
1

07
Changing a wiper blade
1

08
Towing a trailer

1
08
Very cold climate screen(s)

1
09
Advice on care and maintenance
1

09
Roof bars

1
10
B o n n e t


112
Engines
1

13
Checking levels

1
13
C h e c k s
11

6
Running out of fuel (Diesel)

1
18
Temporary puncture repair kit
1

18
Spare wheel

1
22
Changing a bulb
1

26
Changing a fuse
1

31
12

V battery
1
35
Towing the vehicle

1
39Engine technical data and
towed loads

1
41
Petrol engines
1
42
Diesel engines 1 43
Dimensions 144
DrivingPractical information
In the event of a breakdown Technical data
Alphabetical index
Audio equipment and telematics
CITROËN Connect Nav
CITROËN Connect Radio
Bluetooth audio system
Audio system
.
Contents

50
Mats
Removable carpet protection.
Fitting
When fitting the mat for the first time, on the
driver's side use only the fixings provided in the
wallet attached.
The other mats are simply placed on the
carpet.
Removing
To remove the mat on the driver's side:
F M ove the seat as far back as possible.
F

U
nclip the fixings.
F

R
emove the mat.
Refitting
To refit the mat on the driver's side:
F P osition the mat correctly. To avoid any risk of jamming of the pedals:
-

O
nly use mats which are suited to the
fixings already present in the vehicle;
these fixings must be used.
-
D
o not fit one mat on top of another.
The use of mats not approved by
CITROËN may inter fere with access to
the pedals and hinder the operation of the
cruise control / speed limiter.
F
R
efit the fixings by pressing.
F
C
heck that the mat is secured correctly.
Storage box
F Raise the boot floor to access the storage
box.
This has areas for the storage of a box of spare
bulbs, a first aid kit, two warning triangles, etc.
It also houses the vehicle tools, the temporary
puncture repair kit, etc.
Ease of use and comfort

57
General safety
recommendations
Labels are affixed in different locations on
your vehicle. They include safety warnings
and vehicle identification. Do not remove
them: they are an integral part of your
vehicle.
For any work on your vehicle, use a
qualified workshop that has the technical
information, skills and equipment required,
all of which a CITROËN dealer is able to
provide.We draw your attention to the following
points:
-

T
he fitting of electrical equipment
or accessories not approved by
CITROËN may cause excessive
current consumption and faults and
failures with the electrical system of
your vehicle. Contact a CITROËN
dealer for information on the range of
recommended accessories.
-

A
s a safety measure, access to
the diagnostic socket, used for the
vehicle's electronic systems, is
reser ved strictly for CITROËN dealers
or qualified workshops, equipped
with the special tools required (risk
of malfunctions of the vehicle's
electronic systems that could cause
breakdowns or serious accidents).
The manufacturer cannot be held
responsible if this advice is not
followed.
-

A
ny modification or adaptation not
intended or authorised by CITROËN
or carried out without meeting the
technical requirements defined by
the manufacturer will result in the
suspension of the legal and contractual
warranties. Installation of accessory radio
communication transmitters
Before installing a radio communication
transmitter, you must contact a CITROËN
dealer for the specification of transmitters
which can be fitted (frequency, maximum
power, aerial position, specific installation
requirements), in line with the Vehicle
Electromagnetic Compatibility Directive
(2004/104/EC).
Depending on country regulations, some
safety equipment may be compulsory:
high visibility safety vests, warning
triangles, breathalysers, spare bulbs,
spare fuses, fire extinguisher, first aid kit,
mud flaps at the rear of the vehicle, etc.
5
Safety

126
List of operations
Changing a bulb
The headlamps have polycarbonate
lenses with a protective coating:
F
d
o not clean them using a dr y or
abrasive cloth, nor with a detergent
or solvent product,
F

u
se a sponge and soapy water or a pH
neutral product,
F

w
hen using a high pressure washer
on persistent marks, do not keep the
lance directed towards the lamps or
their edges for too long, so as not to
damage their protective coating and
seals.
A bulb must only be changed with the
ignition off and after the headlamp has
been switched off for several minutes –
Risk of serious burns!
F

D
o not touch the bulb directly with your
fingers, use a lint-free cloth.
It is essential only to use anti-ultraviolet
(UV) type bulbs, so as not to damage the
headlamp.
Always replace a faulty bulb with a new
bulb of the same type and specification.
Fastening the spare wheel
If your vehicle is fitted with alloy wheels,
when tightening the bolts on fitting, it is
normal to notice that the washers do not
come into contact with the spare wheel.
The wheel is secured by the conical
contact of each bolt.
After changing a wheel
Do not exceed 50 mph (80 km/h) when
using a "space-saver" type spare wheel.
Have the tightening of the bolts and the
pressure of the spare wheel checked by a
CITROËN dealer or a qualified workshop
without delay.
Have the punctured wheel repaired and
refit it on the vehicle as soon as possible.
Fitting a wheelF Put the wheel in place on the hub.
F S
crew in the bolts by hand as far as possible.
F
P

re-tighten the bolts using wheelbrace
1

o
n l y.
F

L
ower the vehicle again fully.
F

F
old jack 2 and detach it.
F

T
ighten the bolts using wheelbrace 1 o n l y.
F

R
efit the wheel bolt cover (alloy wheels).
F

S
tow the tools in their box.
In the event of a breakdown

127
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a few minutes.
Front lamps
Halogen headlampsHalogen lamps with daytime
running lamps and foglamps
1
Direction indicators (PY21W).
2 Main beam headlamps (H1).
3 Dipped beam headlamps (H7LL).
4 Sidelamps (W5W). 1
Direction indicators (PY21W).
2 Main beam headlamps (H1).
3 Dipped beam headlamps (H7LL).
4 Daytime running lamps / Sidelamps (LEDs).
5 Fo g l a m p s ( H11) .
Light-emitting diodes (LEDs)
For the replacement of this type of lamp,
go to a CITROËN dealer or a qualified
workshop.
Direction indicators
Quicker flashing of the direction indicator
lamp (left or right) indicates that one of
the bulbs on the corresponding side has
failed.
F

T
urn the connector a quarter turn anti-
clockwise.
F

P
ull the bulb connector.
F

R
emove the bulb and change it.
To refit, carry out these operations in reverse
o r d e r.
Amber colour bulbs, such as the direction
indicators, must be replaced by bulbs with
identical colour and specifications.
To refit, close the protective cover very
carefully to guarantee the sealing of the
lamp.
8
In the event of a breakdown

128
Main beam headlampsDipped beam headlampsSidelamps
F Remove the protective cover by pulling on
the tab.
F

U
nclip the module support unit.
F

R
emove the bulb connector.
F

R
emove the bulb and change it.
To reassemble it, reposition the unit in the
housing and clip it back.
Make sure to change the protective cover with
the tab facing upward. F
R emove the protective cover by pulling the
tab.
F

P
ush the entire module relative to the
support to unclip one of the two tabs.
F

O
nce the first tab is unclipped, release the
second tab.
F

R
emove the bulb connector.
F

R
emove the bulb and change it.
To reassemble it, position the unit in the
housing and push until the two tabs "clip".
Make sure to change the protective cover with
the tab facing upward. F
R emove the protective cover by pulling on
the tab.
F

R
emove the bulb connector.
F

R
emove the bulb and change it.
For reassembly, carry out these operations in
reverse order.
Make sure to change the protective cover with
the tab facing upward.
In the event of a breakdown

129
Foglamps
To refit, proceed in reverse order.If you experience any difficulty in changing
bulbs, contact your CITROËN dealer or a
qualified workshop.
Direction indicator side repeaters
Contact a CITROËN dealer or a qualified
workshop to obtain the module.
F

I

nsert a flat screwdriver between the lamp
and the housing.
F

P

ull and lever to unclip the housing.
F

R

emove the two fastening screws from the
module.
F

R

emove the module from its housing. F

P

ress the locking clip and disconnect the
connector.
F

T

urn the bulb holder a quarter turn anti-
clockwise.
F

R

emove the bulb holder.
F

R

emove the bulb and change it.
F

I

nsert a screwdriver towards the centre of
the repeater between the repeater and the
base on the body.
F

L
ever with the screwdriver to extract the
repeater and pull it out.
F

D
isconnect the wiring from the repeater.
F

R
eplace the module.
For reassembly, carry out these operations in
reverse order.
8
In the event of a breakdown

130
Rear lampsThird brake lamp
(W5W)
You must access the housing located on the
rear shelf from the rear seats:
F
U
nclip the bulb holder by lifting the two lugs
and remove it.
F

C
hange the faulty bulb.
F

P
ull the housing cover towards you and up
to disengage it.
F

D
isconnect the lamp connector.
F

L

oosen and remove the nut.
F

F

rom the outside, carefully remove the lamp
unit straight from its housing.
These bulbs are changed from inside the boot:
F

O

pen the boot.
F

R

emove the access grille from the
corresponding side trim panel.
F

D

isconnect the lamp connector. F

R

emove the four screws and lift off the bulb
h o l d e r.
F

T

urn the faulty bulb a quarter of a turn and
change it.
For reassembly, carry out these operations in
reverse order.
Take care to engage the lamp unit in its guides,
while keeping it in line with the vehicle.
Tighten sufficiently to ensure sealing, but
without damaging the lamp.
1 Brake lamp / sidelamps (P21/5W).
2
Direction indicators (PY21W).
3 Reversing lamp (W16W).
4 Foglamp (P21/5W).
In the event of a breakdown