2018 CHRYSLER PACIFICA hood release

INSTRUMENT PANEL
Instrument Panel
1 — Multifunction Lever9 — Switch Panel
2 — Instrument Cluster Display Controls 10 — Electronic Park Brake Switch
3 — Instrument Cluster 11 — Gear Selector
4 — Windshield Wiper Lever 12 — Ignition
5 — Uconnect System 13 — Speed Controls
6 — Glove Compartment 14 — Steering Wheel
7 — Front Center Stack AUX Jack and USB Port 15 — Hood Release
8 — Climate Controls 16 — Headlight Switch
10 GRAPHICAL TABLE OF CONTENTS

Sunroof Maintenance
Use only a non-abrasive cleaner and a soft cloth to clean the
glass panel.
Ignition Off Operation
The power sunroof switch will remain active for up to
approximately 10 minutes after the ignition switch is
turned to the OFF/LOCK position. Opening either front
door will cancel this feature.
NOTE:Ignition Off time is programmable through the
Uconnect System. Refer to “Uconnect Settings” in “Multi-
media” for further information.
HOOD
Opening
The hood release lever (to open the primary latch) and
safety latch (to open the secondary latch) must be released
to open the hood.
1. Pull the hood release lever located under the driver ’s side of the instrument panel. 2. Move to the outside of the front of the vehicle.
3. Push the safety latch release lever toward the passenger
side of the vehicle. The safety latch is located behind the
center front edge of the hood.
Hood Release Lever
3
GETTING TO KNOW YOUR VEHICLE 139

4. Remove the support rod from the locking tab and insertit into the seat located on the underside of the hood.
NOTE:
• Before lifting the hood, check that the wiper arms are not
in motion and not in the lifted position.
• While lifting the hood, use both hands.
• Vehicle must be at a stop and the transmission must be
in PARK.
Closing
1. Hold up the hood with one hand and with the other
hand remove the support rod from its seat and reinsert
it into the locking tab.
2. Lower the hood to approximately 12 inches (30 cm) from the engine compartment and drop it. Make sure that the
hood is completely closed.
WARNING!
Be sure the hood is fully latched before driving your
vehicle. If the hood is not fully latched, it could open
when the vehicle is in motion and block your vision.
Failure to follow this warning could result in serious
injury or death.
CAUTION!
To prevent possible damage, do not slam the hood to
close it. Lower hood to approximately 12 inches (30 cm)
and drop the hood to close. Make sure hood is fully
closed for both latches. Never drive vehicle unless
hood is fully closed, with both latches engaged.
Safety Latch Release Lever Location
140 GETTING TO KNOW YOUR VEHICLE

To Turn Off The Engine Using ENGINE
START/STOP Button
1. Place the gear selector in PARK, then push and releasethe ENGINE START/STOP button.
2. The ignition switch will return to the OFF position.
3. If the gear selector is not in PARK, the ENGINE START/ STOP button must be held for two seconds or three short
pushes in a row with the vehicle speed above 5 mph
(8 km/h) before the engine will shut off. The ignition
switch position will remain in the ACC position until the
gear selector is in PARK and the button is pushed twice
to the OFF position. If the gear selector is not in PARK
and the ENGINE START/STOP button is pushed once,
the instrument cluster will display a “Vehicle Not In
Park” message and the engine will remain running.
Never leave a vehicle out of the PARK position, or it
could roll.
NOTE: If the ignition switch is left in the ACC or RUN
(engine not running) position and the transmission is in
PARK, the system will automatically time out after 30
minutes of inactivity and the ignition will switch to the
OFF position.
ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms the engine and permits
quicker starts in cold weather.
Connect the cord to a 110-115 Volt AC electrical outlet with
a grounded, three-wire extension cord.
For ambient temperatures below 0°F (-18°C), the engine
block heater is recommended. For ambient temperatures
below -20°F (-29°C), the engine block heater is required.
The engine block heater cord is routed under the hood,
behind to the passenger ’s side headlamp. Follow the steps
below to properly use the engine block heater:
1. Locate the engine block heater cord (behind the passen- ger ’s side headlamp).
2. Undo the hook-and-loop strap that secures the heater cord in place.
3. Pull the cord to the front of the vehicle and plug it into a grounded, three-wire extension cord.
4. After the vehicle is running, reattach the cord to the hook-and-loop strap and properly stow away behind
the passenger ’s side headlamp.
6
STARTING AND OPERATING 311

IN CASE OF EMERGENCY
CONTENTS
HAZARD WARNING FLASHERS ............425
 ASSIST AND SOS MIRROR — IF EQUIPPED . . . .425
 BULB REPLACEMENT ....................431
▫ Replacement Bulbs ..................... .431
▫ Replacing Exterior Bulbs ..................433
 FUSES ............................... .438
▫ General Information .....................438
▫ Fuse Location ........................ .439
▫ Underhood Fuses .......................439
 JACKING AND TIRE CHANGING —
IF EQUIPPED ..........................446
▫ Jack And Spare Tire Location ..............446
▫ Equipment Removal ....................447
▫ Preparations For Jacking .................448 ▫
Jacking Instructions .....................448
▫ Road Tire Installation ....................455
▫ Portable Air Compressor — If Equipped .......457
▫ Tire Service Kit For Inflating Tire —
If Equipped .......................... .459
▫ Return Inflatable Spare Tire ................463
 TIRE SERVICE KIT — IF EQUIPPED ..........464
 JUMP STARTING ........................475
▫ Preparations For Jump Start ...............476
▫ Jump Starting Procedure ..................477
 REFUELING IN EMERGENCY ..............478
 IF YOUR ENGINE OVERHEATS .............479
 MANUAL PARK RELEASE .................480
 FREEING A
STUCK VEHICLE ..............481
7

7. Remove the filter cover by prying back each of theretaining tabs from their hooking points, and then
pulling out the filter cover to expose the cabin air filter.
Remove the air filter by pulling it straight out of the
housing.
8. Install the new air filter with the arrow on the filter pointing toward the floor.
CAUTION!
The cabin air filter is identified with an arrow to
indicate airflow direction through the filter. Failure to
properly install the filter will result in the need to
replace it more often.
9. Once the filter is replaced, reinstall the filter cover, making sure the retaining tabs are fully secured into
their housings.
10. Close the cabin air filter compartment cover, and reinsert the snaps into their slots. Push the snap lids
until fully attached. 11. Push the glove compartment door to the near closed
position to reengage the glove compartment travel
stops. Finally, pull the glove compartment tension
tether clip down and slide it back into the slot on the
side of the glove compartment door.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, decklid, sliding doors and hood hinges, should be
lubricated periodically with a lithium based grease, such as
Mopar Spray White Lube to assure quiet, easy operation
and to protect against rust and wear. Prior to the applica-
tion of any lubricant, the parts concerned should be wiped
clean to remove dust and grit; after lubricating excess oil
and grease should be removed. Particular attention should
also be given to hood latching components to ensure
proper function. When performing other underhood ser-
vices, the hood latch, release mechanism and safety catch
should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as Mopar Lock
Cylinder Lubricant directly into the lock cylinder.
8
SERVICING AND MAINTENANCE 503

Clean Air............................. .551
Ethanol ...............................551
Filler Cap (Gas Cap) ..................... .404
Gasoline ...............................550
Materials Added ........................ .551
Methanol ............................. .551
Octane Rating ........................550, 555
Requirements .......................... .550
Specifications .......................... .555
Tank Capacity .......................... .555
Fuses .................................. .438
Garage Door Opener (HomeLink) ...............154
Gas Cap (Fuel Filler Cap) .....................404
Gasoline, Clean Air ........................ .551
Gasoline, (Fuel) ............................550
Gasoline, Reformulated ..................... .551
Gear Ranges ............................. .320
Glass Cleaning ............................546
Gross Axle Weight Rating .....................408
Gross Vehicle Weight Rating ...................407
GVWR ................................. .406Hazard
Driving Through Flowing, Rising, Or Shallow
Standing Water ..........................420
Hazard Warning Flashers .....................425
Headlights ................................94
Bulb Replacement ........................433
Cleaning ...............................543
High Beam/Low Beam Select Switch ...........94
Lights On Reminder .....................94, 97
Passing ............................. .94, 96
Replacing ............................. .433
Switch .................................94
Time Delay ..............................94
Washers ................................96
Head Restraints ............................82
Heated Mirrors ..........................89, 92
Heater, Engine Block ........................311
Hill Start

Assist ............................221
Hitches Trailer Towing .......................... .409
HomeLink (Garage Door Opener) ...............154
Hood Prop ...............................139
Hood Release ............................ .139
Hook, Coat ...............................167
12
INDEX 683

PowerBrakes ............................... .548
Inverter ...............................171
Mirrors ................................91
Outlet (Auxiliary Electrical Outlet) ............168
Seats ............................... .51, 53
Steering ...............................325
Power Seats Down .................................52
Forward ................................52
Rearward ...............................52
Up....................................52
Power Sliding Door On / Off Switch .......................42, 142
Pregnant Women And Seat Belts ................252
Preparation For Jacking ..................... .448
Pretensioners Seat Belts ............................. .252
Radial Ply Tires ............................529
Radiator Cap (Coolant Pressure Cap) .............513
Radio Frequency General Information ................26, 31, 32, 41
Radio Operation .......................... .650
Rear Air Conditioning ....................114,126 Rear Camera
............................. .401
Rear Cross Path ............................228
Rear ParkSense System ...................351, 360
Rear Seat Removal ..........................77
Rear View ................................89
Reclining Front Seats .........................49
Recreational Towing ........................ .418
Reformulated Gasoline .......................551
Refrigerant ...............................500
Release, Hood ............................ .139
Reminder, Lights On .........................94
Reminder, Seat Belt ........................ .241
Remote Control Starting System ...........................28
Remote Keyless Entry Arm The Alarm ..........................33
Disarm The Alarm ........................34
Programming Additional Key Fobs ..........24, 32
Remote Starting Exit Remote Start Mode .....................30
Uconnect Customer Programmable Features ......3
1
Uconnect Settings .........................31
Remote Starting System .......................28
Replacement Bulbs ........................ .431
Replacement Keys ...........................32
12
INDEX 687