2018 BUICK LACROSSE seat

2
Power Mirror/ Window Controls
Memory Seat ButtonsF
Exterior Lamps/Instrument Panel Illumination Controls
Engine Start/Stop Button
Driver Information Center Controls/ Audio Steering Wheel Controls
Windshield Wipers Lever
Driver Information Center
Tap Shift Controls
Turn Signal Lever
Electric Parking Brake
Head-Up Display ControlsF
Trunk Release Button
Steering Wheel Adjustment Lever or Power ControlF
Cruise Control/Forward Collision AlertF/Heated Steering WheelF/Voice Recognition Buttons
INSTRUMENT PANEL
Symbols
Low Tire Pressure
Antilock Brake System Warning
Brake System Warning
Airbag Readiness
P ARK Electric Parking Brake
Door Ajar
Fog Lamps
Lane Keep Assist Warning
Cruise Control Set
Vehicle Ahead
Adaptive Forward Lighting
Service Electric Parking Brake
Traction Control Off
Charging System

3
Hazard Warning Flashers ButtonInfotainment System Touch Screen
Electronic Precision Shift Lever
Driver’s Heated/Vented Seat ButtonsF
Sport Mode/Traction Control Off/Automatic Parking AssistF/Parking Assist/Lane Keep AssistF Buttons
Infotainment System Controls
Refer to your Owner’s Manual to learn about the information being relayed by the lights, gauges and indicators on the instrument cluster.
See In Brief in your Owner’s Manual.
Passenger’s Heated/Vented Seat ButtonsF
Climate Controls
Engine Oil Pressure
Engine Coolant Temperature
High Beam Headlamps
Security
StabiliTrak Off
Traction Control/StabiliTrak Active
Safety Belt Reminder
Check Engine
Low Fuel
Lights On Reminder
F Optional equipment

4
REMOTE KEYLESS ENTRY TRANSMITTER (KEY FOB)
Lock
Press to lock all doors.
Unlock
Press to unlock the driver’s door. Press again to unlock all doors.
Trunk
Press twice to open the trunk.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle. The exterior lamps will flash and the horn will sound.
Press and hold to activate the alarm. Press it again to cancel the alarm.
Door Key
Press the button on the back of the
transmitter to pull out the door key.
Note: To change the remote lock, unlock, and remote start settings, go to Settings > Vehicle > Remote Lock, Unlock, Start.
Remote Vehicle Start
Press and release the Lock button and then immediately press and hold the button until the turn signal lamps flash to start the engine from outside the vehicle. After entering the vehicle, turn on the ignition.
• During a remote start, the engine will run for 10 minutes. Repeat these steps to run the engine for an additional 10 minutes. A remote start can be extended once.
• Press and hold the button until the parking lamps turn off to cancel a remote start.
Remote Start and Heated/Vented SeatsF
Select the remote start heated or vented seat option in the Vehicle Settings to have the heated/vented seats turn on during a remote start. The seat button indicators do not illuminate and the temperature per-formance of the unoccupied seat may be reduced during a remote start.
KEYLESS ACCESS SYSTEM
The Keyless Access System enables operation of the doors, ignition and trunk without
removing the Remote Keyless Entry transmitter from your pocket or purse. The trans mitter must be within 3 feet of the door being unlocked or the trunk.
Keyless Unlocking
With the transmitter within range:
Press the lock button on the driver’s door handle to unlock the driver’s door; press it again within 5 seconds to unlock all doors.
Press the lock button on a passenger door handle to unlock all doors.
Press the bottom of the Buick emblem above the license plate to open the trunk.
Keyless Locking
With the ignition off, the transmitter removed from the vehicle, and all doors closed:
Press the lock button on any door handle to lock all doors immediately.
If Passive Locking is turned on, all doors will lock automatically after a short delay.
Note: To change the Keyless Locking and Unlocking settings, go to Settings > Vehicle > Remote Lock, Unlock, Start.
See Keys, Doors and Windows in your Owner’s Manual.F Optional equipment
See Keys, Doors and Windows in your Owner’s Manual.

8F Optional equipment
FRONT SEATS
Power Seat Adjustment
A. Seat Adjustment
Move the horizontal control to move the seat forward or rearward and to tilt, raise or lower the seat.
B. Seatback Recline Adjustment
Move the vertical control to recline or raise the seatback.
C. Lumbar Adjustment
Press the round control to adjust the lumbar support.
D. MassageF
Press the control button to turn the
massage feature on/off. It will turn off after10 minutes.
Memory Seat
With the driver’s seat, power steering columnF and power outside mirrors in the desired position, press and release the SET button. A beep will sound. Immediately press and hold button 1 until two beeps sound. Repeat the steps using button 2 for a second driver and the Exit button to set the exit position.
To recall the setting, press and hold button 1 or 2 or the Exit button until the stored position is reached.
To set the Auto Memory Recall or Easy Exit options, go to Settings > Vehicle > Comfort and Convenience.
Auto Heated/Vented SeatF
The auto heated or vented seats will turn on automatically when the ignition is on based on the vehicle’s interior temperature.
To turn the Auto Heated/Vented Seats feature on or off, go to Settings > Vehicle > Comfort and Convenience.
See Seats and Restraints in your Owner’s Manual.
FOLDING REAR SEATBACKS
1. Press the button at the base of the head restraint post to lower the head restraint.
2. Use the door key from the Remote Keyless Entry transmitter in the mini-buckle slot to
disconnect the mini-latch of the center safety belt.
3. Pull the release handle in the trunk to release the seatback.
4. Fold the seatback forward.
See Seats and Restraints in your Owner’s Manual.
ABCD

9
SUNROOFF
The sunroof and sunshade controls are located on the overhead console.
Press the Front Sunshade switch to open or close the front sunshade.
Press the Rear Sunshade switch to open or close the rear sunshade.
Press the rear of the Sunroof switch to express-open the sunroof. Press the front of the switch to express-close the sunroof.
See Keys, Doors and Windows in your Owner’s Manual.
AUTOMATIC CLIMATE CONTROLS
Driver’s Heated/Vented Seat ControlsF
Automatic Operation
1. Press AUTO.
2. Set the temperature.
The system automatically controls the fan speed, air delivery, air conditioning and
recirculation to reach the set temperature. Allow time for the system to reach the desired
temperature. If the functions are manually adjusted, automatic operation is canceled.
SYNC Temperature Settings
Press CLIMATE to display the touch screen controls. Touch SYNC to link all passenger
settings to the driver settings.
See Climate Controls in your Owner’s Manual.
Passenger’s Heated/Vented Seat ControlsF
ON/OFF
AUTO Driver’s Temperature Control/Automatic Operation
CLIMATE Touch Screen Display
Max Defrost
Passenger’s Temperature Control/Recirculation Mode
Fan Speed Controls
Rear Window Defog/Heated Outside MirrorsF Control
F Optional equipment

14
DRIVER ASSISTANCE SYSTEMSF
Safety Alert Seat — The driver’s seat pulses — left side, right side or simultaneously — to alert the driver of the direction of potential hazards.
Seat pulsing alerts or audible alerts may be selected. To change the alert settings, go to Settings > Vehicle > Collision/Detection Systems > Alert Type.
Lane Change Alert with Side Blind Zone Alert — While driving, the system displays a warning symbol on the left or right side mirror when a vehicle is detected in that side blind zone area or rapidly approaching that area. The warning symbol flashes if a turn
signal is activated when a vehicle has been detected on the same side.
To turn the systems on or off, go to Settings > Vehicle > Collision/Detection Systems > Lane Change Alert.
Forward Collision Alert — The Vehicle Ahead indicator is green on the instrument
cluster when a vehicle is detected and is amber when following a vehicle ahead too closely. When approaching a vehicle directly ahead too rapidly, a red alert flashes on the windshield and the Safety Alert Seat pulses or beeps sound (if selected).
Press the Collision Alert button on the steering wheel to set the alert timing to Far, Medium, or Near.
Forward Automatic Braking — The brakes may be applied automatically in potential colli-sion situations to help reduce damage or help avoid collisions with vehicles directly ahead.
To set the Forward Collision Alert and Forward Automatic Braking systems to Alert and Brake, Alert, or Off, go to Settings > Vehicle > Collision/Detection Systems > Forward Collision System.
Traction Control and StabiliTrak Systems — The traction control system limits wheelspin and the StabiliTrak® stability control system assists with directional control of the vehicle in difficult driving conditions. Both systems turn on automatically every time the vehicle is
started. Turn off traction control if the vehicle is stuck and rocking the vehicle is required.
Press the Traction Control/StabiliTrak Off button (A) to turn traction control on or off.
Lane Keep Assist with Lane Departure Warning — The system may help avoid
collisions due to unintentional lane departures. The Lane Keep Assist indicator is green on the instrument clus-ter if the system is available to assist. If the vehicle approaches a detected lane marking without using a turn signal in that direction, the system may assist by gently turning the steering wheel and displaying an amber  .
If active driver steering is not detected, the amber may flash and the Safety Alert Seat may pulse, or beeps may sound (if selected), on the side of the departure direction as the lane marking is crossed. In order to use this system safely, the driver needs to steer and be in complete control of the vehicle.
Press the Lane Keep Assist button (B) to turn the system on or off.
F Optional equipment
AB
CD

15
DRIVER ASSISTANCE SYSTEMSF
BATTERY LOCATION
CAPLESS FUEL FILL
F Optional equipment
Front Pedestrian Detection — During daytime driving at speeds of 5–50 mph, the system detects pedestrians directly ahead up to a distance of approximately 131 feet and displays an amber indicator. When approaching a detected pedestrian too quickly, a red alert flashes on the windshield and the Safety Alert Seat pulses or beeps sound (if selected). The system may prepare the brakes or automatically brake the vehicle.
To set the system to Alert and Brake, Alert, or Off, go to Settings > Vehicle > Collision/Detection Systems > Front Pedestrian Detection.
Rear Vision Camera — When the vehicle is in Reverse, a view of the area behind the vehicle displays on the touch screen. Vehicle speed must be below 5 mph.
To turn the guidance lines or symbols on or off, go to Settings > Rear Camera.
Front and Rear Parking Assist — During low-speed parking maneuvers, the system provides “distance to closest object” information on the Driver Information Center, sounds a beep (if selected), and pulses the Safety Alert Seat. When an object is very close, 5 beeps sound (if selected) from the front or rear of the vehicle and the Safety Alert Seat pulses.
Rear Cross Traffic Alert — When the vehicle is in Reverse, the system warns of traffic
coming in either direction by displaying a red alert on the infotainment screen and pulsing the left or right side of the Safety Alert Seat or sounding beeps (if selected).
Press the Parking Assist button (C) to turn the Parking Assist and Rear Cross Traffic Alert systems on or off.
Automatic Parking Assist — Automatic Parking Assist steers the vehicle to help park in
parallel and perpendicular spaces.
1. Press the Automatic Parking Assist button (D). A beep sounds and a parking assist display is shown on the Driver Information Center (DIC). The system will begin searching for a large enough parking space.
2. Once a space is found, shift the vehicle into Reverse or Drive as directed on the DIC and apply the accelerator or brake as needed. Parking Complete will be displayed and a beep will sound when the parking maneuver is complete.
See Driving and Operating in your Owner’s Manual.
The standard 12-volt battery is located under the trim panel on the driver’s side of the trunk. Remote jump-start terminals are located under the hood on the driver’s side of the vehicle.
See Vehicle Care in your Owner’s Manual.
To open the fuel door, press and release the center of the rear edge of the door. It will pop out slightly. Pull the door to open.
The capless fuel system does not have a fuel fill cap. Fully insert the fuel pump nozzle before starting to fill the tank. If the tank must be filled using a portable container, first insert the capless funnel adapter, located under the trunk floor, into the fuel system.
See Driving and Operating in your Owner’s Manual.