Page 231 of 279

Consult an authorized tire dealer for tire repairs and
additional information.
Damaged Run Flat tires, or Run Flat tires that have
experienced a loss of pressure should be replaced
immediately with another Run Flat tire of identical size
and service description (Load Index and Speed Sym-
bol).
Run Flat Tires — If Equipped
Run Flat tires allow you the capability to drive 50 miles
(80 km) at 50 mph (80 km/h) after a rapid loss of
inflation pressure. This rapid loss of inflation is referred
to as the Run Flat mode. A Run Flat mode occurs when
the tire inflation pressure is of/or below 14 psi (96 kPa).
Once a Run Flat tire reaches the run flat mode it has
limited driving capabilities and needs to be replaced
immediately. A Run Flat tire is not repairable.
It is not recommended driving a vehicle loaded at full
capacity or to tow a trailer while a tire is in the run flat
mode.
See the tire pressure monitoring section for more infor-
mation.
Tire Spinning
When stuck in mud, sand, snow, or ice conditions, do
not spin your vehicle’s wheels above 30 mph (48 km/h)
or for longer than 30 seconds continuously without
stopping.
Refer to “Freeing A Stuck Vehicle” in “In Case Of
Emergency” for further information.
WARNING!
Fast spinning tires can be dangerous. Forces gener-
ated by excessive wheel speeds may cause tire
damage or failure. A tire could explode and injure
someone. Do not spin your vehicle’s wheels faster
than 30 mph (48 km/h) for more than 30 seconds
continuously when you are stuck, and do not let
anyone near a spinning wheel, no matter what the
speed.
8
SERVICING AND MAINTENANCE 229
Page 242 of 279

VEHICLE STORAGE
If you are leaving your vehicle dormant for more than
21 days, you may want to take these steps to protect
your battery.
•Disconnect the negative cable from the battery.
• Anytime you store your vehicle, or keep it out of
service (e.g., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
BODYWORK
Protection From Atmospheric Agents
Vehicle body care requirements vary according to geo-
graphic locations and usage. Chemicals that make roads
passable in snow and ice and those that are sprayed on
trees and road surfaces during other seasons are highly
corrosive to the metal in your vehicle. Outside parking,
which exposes your vehicle to airborne contaminants,
road surfaces on which the vehicle is operated, extreme hot or cold weather and other extreme conditions will
have an adverse effect on paint, metal trim, and under-
body protection.
The following maintenance recommendations will en-
able you to obtain maximum benefit from the corrosion
resistance built into your vehicle.
What Causes Corrosion?
Corrosion is the result of deterioration or removal of
paint and protective coatings from your vehicle.
The most common causes are:
•
Road salt, dirt and moisture accumulation.
• Stone and gravel impact.
• Insects, tree sap and tar.
• Salt in the air near seacoast localities.
• Atmospheric fallout/industrial pollutants.
Body And Underbody Maintenance
Cleaning Headlights
Your vehicle is equipped with plastic headlights and
fog lights that are lighter and less susceptible to stone
breakage than glass headlights.
240 SERVICING AND MAINTENANCE
Page 253 of 279

CAUTION!(Continued)
service. Contact your authorized dealer for service
assistance.
• The use of fuel additives, which are now being
sold as octane enhancers, is not recommended.
Most of these products contain high concentra-
tions of methanol. Fuel system damage or vehicle
performance problems resulting from the use of
such fuels or additives is not the responsibility of
the manufacturer and may void or not be covered
under the New Vehicle Limited Warranty.
NOTE: Intentional tampering with the emissions con-
trol system can result in civil penalties being assessed
against you.
Carbon Monoxide Warnings
WARNING!
Carbon monoxide (CO) in exhaust gases is deadly.
Follow the precautions below to prevent carbon
monoxide poisoning:
• Do not inhale exhaust gases. They contain carbon
monoxide, a colorless and odorless gas, which can
kill. Never run the engine in a closed area, such as
a garage, and never sit in a parked vehicle with
the engine running for an extended period. If the
vehicle is stopped in an open area with the engine
running for more than a short period, adjust the
ventilation system to force fresh, outside air into
the vehicle.
• Guard against carbon monoxide with proper
maintenance. Have the exhaust system inspected
every time the vehicle is raised. Have any abnor-
mal conditions repaired promptly. Until repaired,
drive with all side windows fully open.
9
TECHNICAL SPECIFICATIONS 251
Page 268 of 279

Adding Engine Coolant (Antifreeze)...........209
Adding Fuel ........................... .149
Adding Washer Fluid .....................196
Additives, Fuel ......................... .248
AirBag .............................. .104
Air Bag Operation .....................106
Air Bag Warning Light ..................103
Driver Knee Air Bag ....................107
Enhanced Accident Response ..............184
Event Data Recorder (EDR) ...............184
If A Deployment Occurs .................110
Knee Impact Bolsters ....................106
Maintaining Your Air Bag System ...........113
Transporting Pets ..................... .122
Air Bag Light .....................71, 103, 124
Air Bag Maintenance ......................113
Air Cleaner, Engine (Engine Air Cleaner Filter) . . .201
Air Conditioner Maintenance ................202
Air Conditioning Refrigerant .............202, 203
Air Conditioning System ...................202
Air Filter ............................. .201
Air Pressure, Tires ....................... .227
Alarm System (Security Alarm) ...............20
Alfa DNA System (Dynamic Car Control System) .138
Alfa Twin Clutch Transmission............77, 133 Fluid Type
....................... .216, 254
Alterations/Modifications, Vehicle ..............6
Antifreeze (Engine Coolant) ..............208, 252
Capacities .......................... .252
Disposal .............................211
Anti-Lock Brake System (ABS) ................82
Anti-Lock Warning Light ....................74
Automatic Transaxle .......................17
Automatic Transmission ...................133
Fluid Type .......................... .254
Auxiliary Electrical Outlet (Power Outlet) ........50
Battery ............................ .71, 199
Charging System Light ...................71
Keyless Key Fob Replacement ..............16
Belts, Seat ............................. .124
Body Mechanism Lubrication ................203
B-Pillar
Location ........................ .222
Brake Fluid ........................... .254
Brake, Parking ......................... .131
Brake System ....................... .212, 248
Anti-Lock (ABS) ........................82
Master Cylinder ...................... .212
Parking ............................ .131
Warning Light .........................69
266 INDEX