2017 YAMAHA GRIZZLY 350 height

Operating the drive select lever and driving in reverse ....................................... 6-3
Engine break-in ........................................... 6-4
Parking ........................................................ 6-5
Parking on a slope ...................................... 6-6
Accessories and loading ............................. 6-6
RIDING YOUR ATV ........................................ 7-1 GETTING TO KNOW YOUR ATV ................ 7-2
RIDE WITH CARE AND GOOD JUDGMENT .............................................. 7-2
BE CAREFUL WHERE YOU RIDE ............... 7-9
TURNING YOUR ATV................................ 7-12
CLIMBING UPHILL ................................... 7-13
RIDING DOWNHILL .................................. 7-16
CROSSING A SLOPE................................ 7-17
CROSSING THROUGH SHALLOW WATER .................................................... 7-18
RIDING OVER ROUGH TERRAIN ............. 7-20
SLIDING AND SKIDDING.......................... 7-20
WHAT TO DO IF... ..................................... 7-22
WHAT TO DO... ......................................... 7-22
PERIODIC MAINTENANCE AND
ADJUSTMENT................................................ 8-1 Owner’s manual and tool kit ....................... 8-2 Periodic maintenance chart for the
emission control system ........................... 8-3
General maintenance and lubrication chart.......................................................... 8-5
Checking the spark plug............................. 8-9
Engine oil and oil filter cartridge ............... 8-11
Final gear oil ............................................. 8-15
Cleaning the air filter element ................... 8-18
Cleaning the spark arrester ...................... 8-21
V-belt cooling duct check hose ................ 8-22
V-belt case drain plug............................... 8-23
Adjusting the carburetor ........................... 8-23
Adjusting the engine idling speed ............ 8-23
Adjusting the throttle lever free play ......... 8-24
Valve clearance......................................... 8-25
Adjusting the drive select lever safety system cable .......................................... 8-26
Brakes....................................................... 8-26
Checking the front brake pads and rear brake shoes ............................................ 8-26
Checking the brake fluid level .................. 8-27
Changing the brake fluid .......................... 8-29
Checking the front brake lever free play... 8-29
Adjusting the brake pedal height, and the brake pedal and rear brake lever
free play .................................................. 8-29
Brake light switches ................................. 8-34
UB1463E0.book Page 2 Thursday, August 4, 2016 2:12 PM

6-8
6

Never exceed the weight limits shown. An over-
loaded ATV can be unstable.
 Do not exceed the maximum tongue weight.
You can measure tongue weight with a bath-
room scale. Put the tongue of the loaded trailer
on the scale with the tongue at hitch height. Ad-
just the load in the trailer, if necessary, to reduce the weight on the hitch. If you are carrying cargo
and towing a trailer, include the tongue weight
in the maximum ATV load limit.
 Load cargo on the carriers as close to the center
of the ATV as possible. Put cargo at the rear of
the front carrier, at the front of the rear carrier,
and center it.
 Tie down cargo securely to the carriers. Make
sure cargo in the trailer cannot move around. A
shifting load can cause an accident.
 Make sure the load does not interfere with con-
trols or your ability to see where you are going.
 Ride more slowly than you would without a
load. The more weight you carry, the slower you
should go.
 Allow more braking distance. A heavier ATV
takes longer to stop.
 Avoid making sharp turns unless at very slow
speeds.
 Avoid hills and rough terrain. Choose terrain
carefully. Added weight affects the stability and
handling of the ATV.
MAXIMUM LOADING LIMIT
ATV loading limit (total weight of rider, car-
go, accessories, and tongue):210.0 kg (463 lb)
Front carrier: 40.0 kg (88 lb)
Rear carrier: 80.0 kg (176 lb)
Storage compartment: 2.0 kg (4 lb)
Tr a i l e r h i t c h : Pulling load (total weight of trailer and
cargo): 4900 N (500 kgf, 1102 lbf)
Tongue weight (vertical weight on trailer
hitch point): 147 N (15 kgf, 33 lbf)
UB1463E0.book Page 8 Thursday, August 4, 2016 2:12 PM

8-29
8
EBU24283Changing the brake fluidHave a Yamaha dealer change the brake fluid at
the intervals specified in the periodic maintenance
and lubrication chart. In addition, have the oil seals
of the brake master cylinder and calipers as well
as the brake hoses replaced at the intervals listed
below or whenever they are damaged or leaking.
Oil seals: Replace every two years.
 Brake hoses: Replace every four years.EBU24395Checking the front brake lever free
playThe brake lever free play must be checked at the
intervals specified in the periodic maintenance
and lubrication chart. The brake lever should have
no free play as shown. If there is free play, have a
Yamaha dealer check the brake system.
EBU30691Adjusting the brake pedal height, and
the brake pedal and rear brake lever
free playThe brake pedal height, brake pedal free play, and
rear brake lever free play must be checked and, if
necessary, adjusted at the intervals specified in
the periodic maintenance and lubrication chart.TIP Always perform this maintenance completely in
the following order whenever adjusting the rear
brake.1. No brake lever free play
UB1463E0.book Page 29 Thursday, August 4, 2016 2:12 PM

8-30
8

Before adjusting the brake pedal and brake le-
ver free play, check the rear brake shoes for
wear.
Checking and adjusting the brake pedal height
The top of the brake pedal should be positioned
72.0–82.0 mm (2.83–3.23 in) above the footboard
bracket.
Check and adjust the brake pedal height as fol-
lows.
1. Remove the footboard by removing the bolts and nuts. 2. Check the brake pedal height.
If the brake pedal height is correct, skip steps
3–5.
3. Loosen the locknut.1. Distance between brake pe dal and footboard bracket
1
1. Footboard
2. Bolt and nut
3. Bolt22
31
UB1463E0.book Page 30 Thursday, August 4, 2016 2:12 PM

8-31
84. Turn the adjusting bolt in or out until the brake
pedal height is within the specified limits.
5. Tighten the locknut.
6. Install the footboard by installing the bolts and nuts, and then tighten the bolts to the
specified torques. Adjusting the brake pedal free play
The brake pedal free play should measure 20.0–
30.0 mm (0.79–1.18 in) as shown. If the free play is
incorrect, adjust it as follows.
1. Locknut
2. Adjusting boltTightening torque:
Locknut:7 N·m (0.7 kgf·m, 5.1 lb·ft)
1
2
1. Footboard bolt A
2. Footboard bolt BTightening torques:Footboard bolt A:3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
Footboard bolt B: 7 N·m (0.7 kgf·m, 5.1 lb·ft)11
2
UB1463E0.book Page 31 Thursday, August 4, 2016 2:12 PM

10-1
10
EBU25962
SPECIFICATIONS
Dimensions:Overall length:1984 mm (78.1 in)
Overall width: 1085 mm (42.7 in)
Overall height:
1120 mm (44.1 in)
Seat height: 827 mm (32.6 in)
Wheelbase: 1233 mm (48.5 in)
Ground clearance:
245 mm (9.6 in)
Minimum turning radius: 3000 mm (118 in)Weight:Curb weight:
238.0 kg (525 lb)Noise and vibration level:Noise level (77/311/EEC):77.6 dB(A) (EUR, FRA, GBR)
Uncertainty of measurement:
3.0 dB(A) (EUR, FRA, GBR)
Vibration on seat (EN1032, ISO5008): Will not exceed 0.5 m/s² (EUR, FRA, GBR)
Uncertainty of measurement: 0.2 m/s² (EUR, FRA, GBR) Vibration on handle (EN1032, ISO5008):
2.8 m/s² (EUR, FRA, GBR)
Uncertainty of measurement: 0.7 m/s² (EUR, FRA, GBR)
Engine:Engine type:
Air cooled 4-stroke, SOHC
Cylinder arrangement: Single cylinder
Displacement: 348 cm³
Bore × stroke:
83.0 × 64.5 mm (3.27 × 2.54 in)
Compression ratio: 9.2 : 1
Starting system: Electric starter
Lubrication system:
Wet sumpEngine oil:Recommended brand:YAMALUBE
UB1463E0.book Page 1 Thursday, August 4, 2016 2:12 PM

12-2
12
NNeutral indicator light .....................................................4-2OOil temperature warning light ......................................... 4-2
Owner’s manual and tool kit .......................................... 8-2PParking ........................................................................... 6-5
Parking brake ................................................................. 4-7
Parking on a slope ......................................................... 6-6
Part locations ................................................................. 3-1RRear brake, adjusting the pedal height, and the pedal and lever free play ........................................... 8-29
Reverse indicator light ................................................... 4-2
Riding your ATV ............................................................. 7-1SSafety information .......................................................... 2-1
Seat .............................................................................. 4-12
Shock absorber assemblies, adjusting the front .........4-14
Shock absorber assembly, adjusting the rear ............. 4-15
Spark arrester, cleaning ............................................... 8-21
Spark plug, checking .....................................................8-9
Specifications ............................................................... 10-1
Speed limiter .................................................................. 4-5
Speedometer ................................................................. 4-3
Starter (choke) .............................................................. 4-11
Start switch .................................................................... 4-4
Steering shaft, lubricating ............................................ 8-37
Storage ........................................................................... 9-2
Storage compartment .................................................. 4-13
TTail/brake light bulb, replacing ..................................... 8-44
Throttle lever .......................................................... 4-4, 5-4
Throttle lever free play, adjusting ................................. 8-24
Tires ............................................................................... 5-4
Troubleshooting ........................................................... 8-46
Troubleshooting chart .................................................. 8-47VValve clearance ............................................................ 8-25
V-belt case drain plug .................................................. 8-23
V-belt cooling duct check hose ................................... 8-22
Vehicle identification number ....................................... 11-1WWheel hub bearings, checking ..................................... 8-36
Wheel, installing ........................................................... 8-44
Wheel, removing .......................................................... 8-44
UB1463E0.book Page 2 Thursday, August 4, 2016 2:12 PM