||
INSTRUMENTS AND CONTROLS
96
NOTE
•The rear fog lights are considerably brighter than the normal taillights andshould be used only when conditionssuch as fog, rain, snow, smoke or dustreduce visibility for other vehicles to lessthan 500 ft. (150 meters).
• Condensation may form temporarily onthe inside of the lenses of exterior lightssuch as headlights, fog lights, or taillights.This is normal and the lights aredesigned to withstand moisture. Normally,condensation will dissipate after thelights have been on for a short time.
Related information
•Lighting panel (p. 90)
Hazard warning flashers
The hazard warning flasher should be used to indicate that the vehicle has become a traffichazard. When the function is activated, both turn signal indicators in the instrument panel will flash.
Location of the hazard warning flasher button
–To activate the flashers, press the button in the center dash. Press the button again toturn off the flashers.
NOTE
• Regulations regarding the use of the haz- ard warning flasher may vary, dependingon where you live.
• The hazard warning flashers will be acti-vated automatically if an airbag deploys.
Related information
• Turn signals (p. 97)
INDEX
389
Engine
overheating 76
specifications 374
Start/Stop 257, 258, 259, 260, 261
starting 248
switching off 249, 251
Engine compartment overview 328
Engine Drag Control (EDC) 175
Engine oil 375 checking 329
low pressure warning light 75
volumes 376
Engine remote start (ERS) 250
Environment 23
F
Federal Clean Air Act 322 Flat tires repairing with tire sealing system 312
Floor mats cleaning 363
placing correctly 248
Fluid specifications 377, 378
Fog lights 74 rear 95, 339
Four C (active chassis system) 174
Front airbags 34 disconnecting passenger
