2017 VOLVO V90 keyless entry

||
LOCKS AND ALARM
* Option/accessory.
254
Button for closing and locking on the underside of the tailgate.
–Press the button 12
on the underside of
the tailgate to close.
> The tailgate closes automatically - the tail- gate remains unlocked.
NOTE
The button is active 24 hours after the hatch has been left open. Thereafter, it must beclosed manually.
–Press the button 12
on the underside of
the tailgate to close it and simultaneously lock the tailgate and doors (all doors must beclosed for locking).
> The tailgate closes automatically - the tail- gate and doors are locked, and the alarm *
is armed.
NOTE
If the remote key is not detected sufficiently close to the tailgate, locking/unlocking willnot work. See the section "Remote keyrange" for more information.
NOTE
When using key-free * blocking/closing, three
signals will sound if the key is not detected sufficiently close to the tailgate. See the sec-tions "Remote key range" and "Locks andremote keys" for more information.
IMPORTANT
During manual tailgate operation, open or close it slowly. Do not use force to open/close it if there is resistance. It may be dam-aged and stop working correctly.
Cancel opening/closing
–There are five ways to cancel opening/clos- ing:
• Press the button on the instrument panel.
• Press the remote control key's button.
• Press the close button 12
along the bottom
edge of the tailgate.
• Press the rubberised pressure platebeneath the outside handle.
• Using the foot movement
* (see section
"Opening/closing power operated tailgatewith foot movement" for more informa-tion).
> Tailgate movement will be interrupted and the tailgate will stop and can then bemanoeuvred manually.
Programmable max. openingThe maximum opening position of the tailgatecan be adjusted, e.g. to suit a low ceiling height ina garage. To adjust max. opening:
1. Open the tailgate - stop it in the open posi- tion.
12A car with keyless locking/entry (Passive Entry *) has one button for closing and one button for closing and locking.

LOCKS AND ALARM
* Option/accessory.
256
Opening/closing the tailgate with foot movement *
To facilitate the operation of the tailgate when your hands are occupied, it can be opened/closed by means of a forward kicking motionunder the rear bumper.
The sensor is positioned to the left of centre in the bumper 13
.
One of the car's remote control keys must be within range 14
behind the car in order for open-
ing/closing to be possible. This also applies to an already unlocked car in order to avoid accidentalopening e.g. in a car wash.
Operation
Kicking motion within the detector's valid activation area.
Opening/closing
NOTE
The foot-operated tailgate function is availa- ble in two versions:
• Opening and closing with foot movement
• Only unlocking with foot movement (liftup the tailgate manually to open it)
Note that the function for opening and clos-ing with foot movement requires the "Power operated tailgate" * option.
–Make one slow, forward kicking motion
under the left part of the rear bumper. Then take a step back. The bumper must not betouched.
> A short acoustic signal sounds when opening/closing is activated - the tailgate is opened/closed. If the tailgate is on open position then it is always closed on activation via foot move-ment.
The tailgate can also be closed via the instrumentpanel's button, the remote control key or the but- ton(s) 15
under the tailgate. For more information,
see the section "Power operated tailgate". If several kicking motions take place without an approved remote control key being locatedbehind the car, opening will not be possible untilafter a certain delay. Do not leave your foot positioned under the car during the kicking motion. This could cause acti-vation to fail.
Cancel opening/closing
–Make one slow forward kicking motion when
opening/closing is in progress in order to stop the movement of the tailgate.
The remote control key does not have to be inthe vicinity of the car to cancel opening/closing.
13 If the car is equipped with skid plate/diffuser * then the detector is positioned out towards the left-hand corner of the bumper.
14 See the section "Remote control key range" for more information.
15 Only applies to a car equipped with keyless locking/entry (Passive Entry) *.

LOCKS AND ALARM
}}
* Option/accessory.257
NOTE
There is a risk of reduced function, or no function, if the rear bumper is loaded withlarge amounts of ice, snow, dirt or similar. Forthis reason, make sure you keep it clean.
NOTE
Pay attention to the possibility that the sys- tem may be activated in a car wash or similarif the remote key is within range.
Related information
•Locking/unlocking the tailgate (p. 247)
• Power operated tailgate
* (p. 253)
• Remote control key range (p. 238)
Replacing the battery in the remote control key
The battery in the remote control key needs to be replaced when it has become discharged.
NOTE
All batteries have a limited service life and must eventually be replaced (does not applyto Key Tag). The service life of the battery var-ies depending on how often the vehicle/keyis used.
The battery for the remote control key should be replaced if:
the information symbol illuminates and the message
Car key battery low
See Owner's manual is shown in the
driver display
and/or
• the locks repeatedly do not react to signals from the remote control key within 20 metresfrom the car.
NOTE
Always try moving closer to the car and mak- ing another unlock attempt.
The battery in the button-less key 16
(Key Tag)
cannot be replaced - a new key can be ordered from an authorised Volvo workshop.
IMPORTANT
A discharged Key Tag must be handed over to an authorised Volvo workshop. The keymust be deleted from the car since it is stillpossible to use it to start the car via back-upstart.
16 This key is supplied with a car equipped with the keyless locking/entry option (Passive Entry *).

||
LOCKS AND ALARM
* Option/accessory.
262
The door is blocked against opening from the inside.
The door can be opened from both the out- side and the inside.
NOTE
• A door's knob control only blocks that particular door - not both rear doorssimultaneously.
• Cars with an electric child safety lock donot have a manual child lock.
Related information
• Detachable key blade (p. 250)
• Ignition positions (p. 385)
Alarm
*
The alarm alerts e.g. in the event of a break-in in the car.
When armed, the alarm is triggered if:
• a door, the bonnet or the tailgate is opened 18
• a movement is detected in the passenger compartment (if fitted with a movement detector
*)
• the car is raised or towed away (if fitted witha tilt detector
*)
• the starter battery's cable is disconnected or
• the siren is disconnected.
If there is a fault in the alarm system, the driver display shows the symbol and the message
Alarm system
failure Service required. In which
case, contact a workshop - an authorised Volvo workshop is recommended.
NOTE
Do not attempt to repair or alter components in the alarm system yourself. Any suchattempts may affect the terms of the insur-ance.
NOTE
The movement sensors trigger an alarm in the event of movement in the passengercompartment - air currents are also regis-tered. For this reason the alarm is triggered ifthe car is left with a window or the panoramic roof * open or if the passenger compartment
heater is used. To avoid this: Close the window/panoramic roof when leaving the car. If the car's inte-grated parking heater (or a portable electricheater) shall be used - direct the airflow fromthe air vents so that they are not pointingupwards into the passenger compartment.Alternatively, reduced alarm level can be used- see the section further down in this article.
Arming the alarmLock and arm the car alarm as follows:
• press the remote control key's lock button
• touch in the marked area on the outside of the door handle 19
or
• push on the tailgate's rubberised pressureplate 19
.
If the car is equipped with a power-operated tail- gate, the button on the underside of the tailgatecan also be used to lock the car and arm the caralarm.
18 Applies to certain markets.
19 Only applies to a car with keyless locking/entry (Passive Entry *)

LOCKS AND ALARM
* Option/accessory.263
Deactivate the alarmUnlock and disarm the car alarm as follows:
• press the remote control key's unlock button
• grip one of the door handles 19
or
• push on the tailgate's rubberised pressure plate 19
.
Switching off a triggered alarm
–Press the remote control key's unlock button or set the car in ignition position I by turning
the ignition dial to START and then releas-
ing.
NOTE
• Remember that the alarm is activated when the car is locked.
• If any of the doors are opened from theinside then the alarm is triggered.
Alarm signalsWhen the alarm has been triggered, the following happens:
• A siren sounds for 30 seconds or until thealarm is switched off.
• The direction indicators flash for 5 minutesor until the alarm is switched off. If the cause of alarm activation is not rectified, the alarm cycle is repeated up to 10 times
20
.
Lock and alarm indicator
A red LED on the instrument panel indicates the alarm system's status:
• LED not lit – alarm not armed.
• The LED flashes once every other second –alarm is armed.
• After the alarm has been disarmed, the LEDflashes rapidly for up to 30 seconds or until ignition position
I has been selected by turn-
ing the ignition dial to START and releasing
it - the alarm has been triggered.
Reduced alarm levelReduced guard means that the movement and tilt detectors can be temporarily deactivated. Switch off the movement and tilt detectors in order to avoid accidental triggering of the alarm -e.g. if a dog is left in a locked car or during trans-port on a car train or car ferry. The procedure isthe same as with the temporary disengaging ofthe deadlocks function.
Press the
Reduced guardbutton in the centre display's function view in order to switchoff the movement and tiltdetectors temporarily.
For more information, see the section "Dead- locks".
Related information
•Automatic arming/rearming of the alarm
*
(p. 264)
• Disarming the alarm
* without working remote
control key (p. 264)
• Deadlocks
* (p. 246)
19
Only applies to a car with keyless locking/entry (Passive Entry *)
20 Applies to certain markets.

LOCKS AND ALARM
}}
* Option/accessory.265
Type approval for the remote control key system
Type approval for the remote control key system can be read in the table.Lock system keyless start (Passive Start) and keyless locking/unlocking (Passive Entry *)
CEM marking for the remote control key system. For supplementary type approval number, see the tablebelow.
Country/Area Type approval
Jordan TRC/LPD/2014/250
Serbia P1614120100
Argentina CNC ID: C-14771

||
STARTING AND DRIVING
* Option/accessory.
386
NOTE
To reach level I or II without starting the
engine - do not depress the brake pedal, or
the clutch pedal for cars with manual gear changing, when these ignition positions are tobe selected.
• Ignition position I
- Turn the ignition dial to
START and release it. The control automati-
cally returns to its starting position.
• Ignition position II
- Turn the ignition dial to
START and hold it in the START position for
approx. 4 seconds. Then release the knob, which automatically returns to its startingposition.
• Back to ignition position 0
- To return to
ignition position 0 from position I and II -
Turn the ignition dial to STOP and release it.
The control automatically returns to its star-ting position.
Related information
• Starting the car (p. 386)
• Switching off the car (p. 387)
• Driver display (p. 90)
Starting the car
The car is started using the remote control key and the start knob in the tunnel console.
Start knob in the tunnel console.
The remote control key is not physically used when starting the car since the car is equippedwith support for keyless starting (Passive Start). To start the car:
1. The remote control key must be inside the car. For cars with Passive Start, the key needs to be located in the front part of thepassenger compartment. With the keyless locking/unlocking option (Passive Entry *),
the key can be anywhere in the car. 2. For cars with automatic gear changing, make
sure that gear position P or N is selected.
For cars with manual gear changing, make sure that the gear lever is in neutral positionand that either the clutch pedal or the brakepedal is depressed.
3. Depress the brake pedal fully 1
.
4. Turn the start knob to START and release it.
The control automatically returns to its star-ting position.
NOTE
For diesel-engined cars, there may be a slight delay before starting is initiated.
When the engine is started the starter motor works until the engine is started or until its over-heating protection triggers.
Backup reader's location in the tunnel console.
1 If the car is moving, then you simply need to turn the start knob towards START to start the engine.